Fairchild L14G1 Hermetic silicon phototransistor Datasheet

HERMETIC SILICON PHOTOTRANSISTOR
L14G1
L14G2
L14G3
PACKAGE DIMENSIONS
0.230 (5.84)
0.209 (5.31)
0.195 (4.95)
0.178 (4.52)
0.255 (6.47)
0.225 (5.71)
0.030 (0.76)
NOM
0.500 (12.7)
MIN
0.100 (2.54)
0.050 (1.27)
SCHEMATIC
2
1
(CONNECTED TO CASE)
COLLECTOR
3
3
0.038 (0.97)
0.046 (1.16)
0.036 (0.92)
Ø0.020 (0.51) 3X
45°
BASE 2
NOTES:
1
EMITTER
1. Dimensions for all drawings are in inches (mm).
2. Tolerance of ± .010 (.25) on all non-nominal dimensions
unless otherwise specified.
DESCRIPTION
The L14G1/L14G2/L14G3 are silicon phototransistors mounted in a narrow angle, TO-18 package.
FEATURES
• Hermetically sealed package
• Narrow reception angle
 2001 Fairchild Semiconductor Corporation
DS300307
6/01/01
1 OF 4
www.fairchildsemi.com
HERMETIC SILICON PHOTOTRANSISTOR
L14G1
ABSOLUTE MAXIMUM RATINGS
Parameter
Operating Temperature
Storage Temperature
Soldering Temperature (Iron)(3,4,5 and 6)
Soldering Temperature (Flow)(3,4 and 6)
Collector to Emitter Breakdown Voltage
Collector to Base Breakdown Voltage
Emitter to Base Breakdwon Voltage
Power Dissipation (TA = 25°C)(1)
Power Dissipation (TC = 25°C)(2)
L14G2
L14G3
(TA = 25°C unless otherwise specified)
Symbol
TOPR
TSTG
TSOL-I
TSOL-F
VCEO
VCBO
VEBO
PD
PD
Rating
-65 to +125
-65 to +150
240 for 5 sec
260 for 10 sec
45
45
5
300
600
Unit
°C
°C
°C
°C
V
V
V
mW
mW
NOTE:
1. Derate power dissipation linearly 3.00 mW/°C above 25°C ambient.
2. Derate power dissipation linearly 6.00 mW/°C above 25°C case.
3. RMA flux is recommended.
4. Methanol or isopropyl alcohols are recommended as cleaning agents.
5. Soldering iron tip 1/16” (1.6mm) minimum from housing.
6. As long as leads are not under any stress or spring tension.
7. Light source is a GaAs LED emitting light at a peak wavelength of 940 nm.
8. Figure 1 and figure 2 use light source of tungsten lamp at 2870°K color temperature. A GaAs source of 3.0 mW/cm2 is approximately
equivalent to a tungsten source, at 2870°K, of 10 mW/cm2.
ELECTRICAL / OPTICAL CHARACTERISTICS
PARAMETER
Collector-Emitter Breakdown
Emitter-Base Breakdown
Collector-Base Breakdown
Collector-Emitter Leakage
Reception Angle at 1/2 Sensitivity
On-State Collector Current L14G1
On-State Collector Current L14G2
On-State Collector Current L14G3
Turn-On Time
Turn-Off Time
Saturation Voltage
www.fairchildsemi.com
(TA =25°C) (All measurements made under pulse conditions)
TEST CONDITIONS
SYMBOL
MIN
IC = 10 mA, Ee = 0
IE = 100 µA, Ee = 0
IC = 100 µA, Ee = 0
VCE = 10 V, Ee = 0
BVCEO
BVEBO
BVCBO
ICEO
θ
IC(ON)
IC(ON)
IC(ON)
ton
toff
VCE(SAT)
45
5.0
45
—
Ee = 0.5 mW/cm2, VCE = 5 V(7,8)
Ee = 0.5 mW/cm2, VCE = 5 V(7,8)
Ee = 0.5 mW/cm2, VCE = 5 V(7,8)
IC = 2 mA, VCC = 10 V, RL =100 Ω
IC = 2 mA, VCC = 10 V, RL =100 Ω
IC = 1.0 mA, Ee = 3.0 mW/cm2(7,8)
2 OF 4
TYP
MAX
UNITS
—
—
—
100
0.40
V
V
V
nA
Degrees
mA
mA
mA
µs
µs
V
6/01/01
DS300307
±10
1.0
0.5
2.0
—
8
7
—
HERMETIC SILICON PHOTOTRANSISTOR
L14G1
L14G3
Figure 2. Light Current vs. Temperature
Figure 1. Light Current vs. Collector to Emitter Voltage
10
IL, NORMALIZED LIGHT CURRENT
10
IL, NORMALIZED LIGHT CURRENT
L14G2
Ee = 20 mW/cm2
Ee = 10 mW/cm2
1
Ee = 5 mW/cm2
Ee = 2 mW/cm2
.1
Ee = 1 mW/cm2
NORMALIZED TO:
Ee = 10 mW/cm2
VCE = 5 V
1
.1
NORMALIZED TO:
VCE = 5 V
Ee = 10 mW/cm2
.01
.1
1
10
100
Ee - TOTAL IRRADIANCE IN mW/cm2
.01
.01
.1
1
10
100
VCE , COLLECTOR TO EMITTER VOLTAGE (V)
Figure 4. Switching Times vs. Output Current
ton and toff , NORMALIZED TURN ON AND TURN OFF TIMES
10
Figure 3. Normalized Light Current vs. Temperature
IL, NORMALIZED LIGHT CURRENT
10
1
NORMALIZED TO:
VCE = 5 V
Ee = 10 mW/cm2
TA = 25°C
0.1
-50
0
50
100
RL = 1 KΩ
1
.01
150
RL = 100 Ω
NORMALIZED TO:
VCE = 10 V
IL = 2 mA
Ion = Ioff = 5 µsec
RL = 100 Ω
.1
RL = 10 Ω
1.0
TA, TEMPERATURE (°C)
Figure 6. Normalized Light Current vs. Temperature
Both Emitter (LED 55B) and Detector
(L14G) at Same Temperature
Figure 5. Dark Current and Temperature
1.4
105
1.2
104
IL, NORMALIZED LIGHT CURRENT
ID, NORMALIZED DARK CURRENT
100
IL, OUTPUT CURRENT (mA)
106
103
102
NORMALIZED TO:
ID@ 25°C
VCEO = 10 V
10
1
.1
10
0
25
50
75
100
125
L14G
LED 55B
1.0
.8
.6
NORMALIZED TO:
LED 55B INPUT = 10 mA
VCE = 10 V
IL = 100 µA
TA = 25°C
.4
150
.2
TA, TEMPERATURE (°C)
.0
55
35
15
5
25
45
65
85
105
TA, TEMPERATURE (°C)
DS300307
6/01/01
3 OF 4
www.fairchildsemi.com
HERMETIC SILICON PHOTOTRANSISTOR
L14G1
L14G2
L14G3
DISCLAIMER
FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO
ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME
ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED
HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF
OTHERS.
LIFE SUPPORT POLICY
FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD
SEMICONDUCTOR CORPORATION. As used herein:
1. Life support devices or systems are devices or
systems which, (a) are intended for surgical
implant into the body,or (b) support or sustain life,
and (c) whose failure to perform when properly
used in accordance with instructions for use provided
in labeling, can be reasonably expected to result in a
significant injury of the user.
DS300307
6/01/01
2. A critical component in any component of a life support
device or system whose failure to perform can be
reasonably expected to cause the failure of the life
support device or system, or to affect its safety or
effectiveness.
4 OF 4
www.fairchildsemi.com
Similar pages