M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION MIN TYP Lower Frequency: Upper Frequency: MAX UNITS 2175 MHz 4.5 VDC 2175 Tuning Voltage: MHz 0.5 Supply Voltage: 7.6 8.0 8.4 VDC Output Power: +5.0 +7.0 +9.0 dBm Supply Current: 28 nd mA Harmonic Suppression (2 Harmonic) -15 -10 dBc Pushing: 1.0 3.0 MHz/V Pulling, all Phases: 2.0 4.0 MHz pk-pk Tuning Sensitivity: 7 MHz/V Phase Noise @ 1kHz offset: -95 -90 dBc/Hz Phase Noise @ 10kHz offset: -120 -115 dBc/Hz Phase Noise @ 100kHz offset: -140 -135 dBc/Hz Phase Noise @ 1MHz offset: -160 -155 dBc/Hz Phase Noise @ 10MHz offset: -164 -155 dBc/Hz Load Impedance: 50 Input Capacitance: 22 pF Operating Temperature Range: -40 +85 °C Storage Temperature Range: -45 +90 °C Phase Noise (1 Hz BW, Typical) Tuning Curve (Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation SIDE VIEW BOTTOM VIEW Gold Finish 0.465 SQ (11.81 SQ) Solder Mask 0.220 (5.59) 0.030 (0.76) 0.100 (2.54) 0.415 13 0.315 14 0.215 15 0.115 16 0.380 12 11 10 9 0.000 1 0.000 TOP ORIENTATION MARK 8 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 2 10 14 Others Vt RF-OUTPUT Vcc GROUND PAD LOCATION 2 3 4 0.415 CRYSTEK CVCO55CC 2175-2175 YYWW 0.500 (12.70) 0.500 0.280 0.500 (12.70) 0.180 TOP VIEW 0.215 0.040 (1.02) 0.115 [Vt] 0.080 0.052 (1.32) 0.315 [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches 0.500 [RF] TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) DIRECTION OF FEED 0.945±0.012 (24.00±0.30) 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55CC-2175-2175 Release Date: 19-Nov-2013 Revision Level: C Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com