Kemet C0603C33519PAC Surface mount ceramic chip capacitors x5r dielectric Datasheet

New Product Release
Surface Mount Ceramic Chip Capacitors
X5R Dielectric
KEMET is pleased to continue the expansion of high capacitance ratings in our X5R ceramic
chip capacitors to include the following values in our base metal electrode devices.
X5R/0603 - 2.7 µF (275) – 4.7 (475) @ 6.3 Volts
Outline Drawing
Table 1
Dimensions - Millimeters (Inches)
Metric EIA Size
Size Code Code
L - Length
1608
0603
1.6 (.04) ± 0.15 (.006)
Max.
W - Width
T - Thickness
B - Bandwidth
Separation
0.8 (.032) ± 0.15 (.006)
See Table 2 0.35 (.014) ± 0.15 (.006) 0.7 (.028)
Table 2 - X5R - Capacitance Value Extensions
Capacitance
Values (µF)
KEMET Part
Number
Capacitance
Tolerance
Thickness
mm
Qty
7” Reel
Qty
13” Reel
2.7
3.3
4.7
C0603C275(1)9PAC
C0603C335(1)9PAC
C0603C475(1)9PAC
K,M
K,M
K,M
0.8 ± .15
0.8 ± .15
0.8 ± .15
4,000
4,000
4,000
10,000
10,000
10,000
(1) To complete KEMET part number, insert the alpha code for the tolerance desired. K = ±10%; M = ±20%
Note: 0402 and 0603 components are reeled on paper tape.
F-9015 11/04
Electrical Parameters
As detailed in the KEMET Surface Mount Catalog F3102 for X5R, with following specific
requirements based on room temperature (25°C) parameters:
• Operating Range: -55°C to +85°C, with no-bias capacitance shift limited to ± 15% over that range
• Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 500
megohm microfarads or 100 gigohms, whichever is less.
• Capacitance and Dissipation Factor (DF) measured at the following conditions. DF Limit is 10%.
1 kHz and 1 Vrms if capacitance ≤ 10 µF
120 Hz and 0.5 Vrms if capacitance > 10 µF
Soldering Process
The 0603 components are suitable for reflow or wave soldering. All parts incorporate the standard KEMET barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching.
Marking
These chips are normally supplied unmarked. If required, they can be laser marked as an extra
cost option. More detail on the marking format is included in our Surface Mount Catalog F3102.
In general, the information in the KEMET Surface Mount catalog F3102 applies to these
capacitors. The information in this bulletin supplements that in the catalog.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • (864) 963-6300 • www.kemet.com
Similar pages