PC PSU FSP250-60GHT,(85)F DESCRIPTION This is the specification of Model FSP250-60GHT,(85)F; AC line powered switching power supply with active PFC (Power Factor C orrection) circuit, meet EN61000-3-2 and with Full Range Input features. Also, +5Vsb power is less than 0.5Winput at power off mode (PS_ON input at high state) which is comply with ErP Lot 6 year 2013 requirement. APPLICATION Desktop , Mini-itx SAFETY STANDARD APPAOVAL W ATTAGE Wattage: 250W DIMENSION Dimension: 175mm(L) x 85mm(W) x 70mm(H) PRODUCT HIGHLIGHT Efficiency Level: Erp Lot: Input Voltage: 80PLUS Bonze <0.5W 100~240Vac Efficiency: 80PLUS Bonze PWOK Delay Time: 500ms > PWOK > 100ms EMC Performance: EN55022 class B EN55024 EN 61000-3-2 EN 61000-3-3 ENVIRONMENTAL SPECIFICATION INPUT SPECIFICATION Input Range: Input Frequency: Input Current: GENERAL SPECIFICATION 100-240 Vac 47-63 Hz 115V< 3.0 Amps – rms 230V<1.5 Amps – rms TEMP.Range: MTBF: OUTPUT SPECIFICATION *Output Voltage and C urrent Rating +3.3V Ripple-Noise(R-P) mV 70mV Regulation Load % ±5% Output Max.(A) 14A Output Min.(A) 0.5A +5V 70mV ±5% 16A 0.3A +12V1 140mV ±5% 14A 1A +12V2 140mV ±5% 16A 1A NOTES (1 ) +3.3V & +5V total output not exceed 110W. ( 2 ) Total output continuous shall not exceed 250W. This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice Operating Temperature:10°C to +50°C Storage Temperature: -20°C to + 80℃ The power supply reliability when calculated by MIL-HDBK-217; latest revision, are exceed 100,000 hours with all output at 80% full load and an ambient temperature of 25℃. -12V 140mV ±10% 0.5A 0A +5Vsb 70mV ±5% 2.5A 0A