Medical PSU FSP060-2K30M1 DESCRIPTION This series of compact, open PC B constructed, AC -DC switching power supplies are capable of delivering 37.5-64 watts of continuous output power at convection cooling.They operate at 90-264 VAC input voltage without the need of voltage ion, and are suited for medical, information technology and industrial applications. Approval to both EN60601-1 and EN60950-1 safety standards improves design-in time and reduces end equipment compliance costs. SAFETY STANDARD APPAOVAL FEATURES Medical and ITE approvals C ompact size 2” x 4” x 1.18” Single, dua l and triple outputs Wide-range input 90-264 VAC Low earth leakage current Level B emissions RoHS compliant OUTPUT SPECIFICATION Ripple & Noise: Maximum excursion of 4% or better on all models, recovering to 1% of final value within 500 us after a 25% step load change All outputs protected to short circuit conditions. W ATTAGE Wattage: 55W Over Current Protection: 101.6mm(L) x 50.8mm(W) x 30.0mm(H) GENERAL SPECIFICATION DIMENSION Dimension: INPUT SPECIFICATION Input Range: Input Frequency: Input Current: Leakage Current: Efficiency: Inrush Current: 90-264 Vdc 47-63 Hz 1.3A(rms) for100VAC , 0.7A(rms) for240VAC 150 µA max. @ 264 VAC ,63 Hz 80~88% typical except PM42-31-3A and PM42-31-5A at 75% typical 30A @ 115VAC , or 60A @ 230VAC , at 25"C cold start ENVIRONMENTAL SPECIFICATION TEMP.Range: MTBF: Operating Temperature:-10°C to +70°C Storage Temperature: -40°C to + 85℃ 400,000 hours at fulll load at 25"C ambient, calculated per MIL-HDBK217F *Output Voltage and C urrent Rating Ripple-Noise(R-P) mV Regulation Load % Output Max.(A) Output Min.(A) +5V 100mV ±3% 8A 0.5A +12V1 120mV ±5% 3A 0.1A NOTES 1. Safety approvals are for PC B form only. To order unit with cover fitted, change suffix “A” to “C ”. 2. Maximum current of output #1 of multi-output models can be 8 A at 5 C FM forced air provided by user. 3. It is rated at 37.5 W maximum at convection cooling or 47.5 W maximum at 5 C FM forced air cooling by user. 4. The output voltages of a multiple output model may go outside of the stated tolerance when an output load current is out of stated limits. All models may be operated at no-load without damage. 5. Ripple and noise is maximum peak to peak voltage value measured at output within 20 MHz bandwidth, at rated line voltage and output load ranges, and with a 10 μF tantalum capacitor in parallel with a 0.1 μF ceramic capacitor across the output. MECHANICAL SPECIFICATION This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice