Bay Linear Inspire the Linear Power B2025/2076 Dual-Channel Power Distribution Switch Advance Information Description Features • • • • • • • • • The Bay Linear B2026 & B2076 are a dual high-side power switch recommended for general Propose self-powered and bus-powdered universal serial for bus (USB) application conforming to USB requirements. These devices include thermal shutdown which in fault modes reduces the current consumptions. Additional features such as thermal shutdown to prevent catastrophic switch failure from excessively high current loads, under voltage lockout (UVLO) to ensure that the device remains off unless there is a valid input voltage present. These device it includes internal current limits. The 2026/76 offer a soft-start circuit for limit the inrush current and Fault status output flag for time over current and thermal shutdown status. Applications • • • • • • • Bay Linear B2026/76 are available in 8-pin Dip and 8-pin SOIC packages. Package Information 2.7V to 5.5V Input Under voltage Lockout 1µ µA Typical off-State Supply Current 500mA Minimum Continuous Load Current B2076 with Circuit Breaker Mode Logic Compatible Input Thermal Shutdown & Short Circuit protection Pin Compatible with B2526 Replacement for MIC2026/76 USB Host and self-Powered Hubs USB Power Management Battery-Charger Circuits Hot Plug-In Power Supplies Bus-Powered Hubs Notebooks/PDA ACPI power distribution Ordering Information Package Enable Active High B2026-1M B2076-1M B2026-1P B2076-1P SO-8 SO-8 8 DIP 8 DIP Active Low B2026-2M B2076-2M B2026-2P B2076-2P SO-8/8-DIP EN (A) FLAG (A) FLAG (B) EN (B) 1 8 2 VOUT (A) BAY 7 B2026/76 3 6 VIN 4 VOUT (B) 5 GND Top View Bay Linear, Inc 2418Armstrong St., Livermore CA USA 9550 EN (A) FLG (A) FLB (B) EN (B) 1 2 Logic Charge Pump 3 4 Logic Charge Pump 6 8 Out (A) 7 IN 5 Out (B) GND Tel: (925) 606-5950, Fax: (925) 940-9556 www.baylinear.com B2026/76 ABSOLUTE MAXIMUM RATINGS OPERATING RATING Supply Voltage…………………………………..+.6V Fault Flag Voltage……………………………….+.6V Fault Flag Current……………………………..25mA Output Voltage……………………………………6V Output Current……………………Internally Limited Enable Input……………………………-0.3V to +3V Storage Temperature………………-65°C to +150°C Lead Temperature (Soldering 5 sec.)………….260°C Supply Voltage ...............................................+2.7V to +5.5V Ambient Operating Temperature.................... -40°C to +85°C Thermal Resistance SOIC .................................................................. 160°C/W DIP..................................................................... 105°C/W ELECTRICAL CHARACTERISTICS at VIN = 5V, Ta=25°C, unless otherwise specified. (Note 1) Parameters Typ Min Max Units 5 5 160 160 µA 2.4 V 1 µA pF Conditions Supply Current Enable Input Threshold Enable Input Current Enable Input Capacitance Switch Resistance Output Turn-On Delay Output Turn-On Rise Time Output Turn-Off Delay Output Turn-Off Fall Time Output Leakage Current Continuous Load Current Short Circuit Current Limit Current Limit Threshold Over current Flag Response Delay Short Circuit Response Time Error Flag Off Current UVLO Threshold Bay Linear, Inc Switch Off, OUT = Open VENA=VEMB≤0.8V Switch Off, OUT = Open VENA=VEMB≥2.4V Switch On, OUT = Open VENA=VEMB≤0.8V Switch On, OUT = Open VENA=VEMB ≥2.4V Low to High Transition High to Low Transition, (Note1) VEN = 0V to 5.5V VIN = 5V IOUT = 500mA, Each Switch VIN = 3.3V IOUT = 500mA, Each Switch RL = 10Ω, CL=1µf RL = 10Ω, CL=1µf RL = 10Ω, CL=1µf RL = 10Ω, CL=1µf Each output (output disabled) Each output Each output (enable into load), VOUT = 0V Ramped Load applied to enable output, VOUT ≤ 4.0V VIN=5V, apply VOUT=0V UNTIL FLAG LOW VIN=3.3V, apply VOUT=0V UNTIL FLAG LOW VOUT=0V to IOUT=ILIMIT VFLAG = 5V VIN = Increasing VIN = Decreasing 2418Armstrong St., Livermore CA USA 9550 0.75 0.75 100 100 1.7 1.45 ± 0.01 1 90 100 1.3 1.15 35 32 0.5 0.9 1.0 3.0 3.0 20 2.4 2.15 Tel: (925) 606-5950, Fax: (925) 940-9556 0.8 -1 140 170 5 4.9 100 100 10 0.5 1.5 1.25 1.25 7.0 0.01 2.2 2.15 1 2.7 2.5 mΩ ms ms µs µs µA A A A ms µs µA V www.baylinear.com Advance Information- These data sheets contain descriptions of products that are in development. The specifications are based on the engineering calculations, computer simulations and/ or initial prototype evaluation. Preliminary Information- These data sheets contain minimum and maximum specifications that are based on the initial device characterizations. These limits are subject to change upon the completion of the full characterization over the specified temperature and supply voltage ranges. The application circuit examples are only to explain the representative applications of the devices and are not intended to guarantee any circuit design or permit any industrial property right to other rights to execute. Bay Linear takes no responsibility for any problems related to any industrial property right resulting from the use of the contents shown in the data book. Typical parameters can and do vary in different applications. Customer’s technical experts must validate all operating parameters including “ Typical” for each customer application. LIFE SUPPORT AND NUCLEAR POLICY Bay Linear products are not authorized for and should not be used within life support systems which are intended for surgical implants into the body to support or sustain life, in aircraft, space equipment, submarine, or nuclear facility applications without the specific written consent of Bay Linear President. Bay Linear, Inc 2418Armstrong St., Livermore CA USA 9550 Tel: (925) 606-5950, Fax: (925) 940-9556 www.baylinear.com