NDS-DP-DA series DIP switches Distinctive features and specifications UG1212-A-R1 ❑ Standard, piano and right angle models ❑ 1 to 12 positions ❑ Top tape sealing option ELECTRICAL SPECIFICATIONS MATERIALS • Current/voltage rating : 25mA 24VDC • Initial contact resistance : 50mΩ max. • Insulation resistance (at 500VDC) : 100 MΩ min. between adjacent terminals • Dielectric strength : 500VDC for one minute • Circuit : single pole, single throw • Electrical life : 2.000 cycles min. per switch • Case, UL94-V0, glass fiber filled PBT, black • Cover : UL94-V0,glass fiber filled PBT, red • Actuator : UL94-V0, glass fiber filled PBT, white • Terminals/contacts : gold over nickel plated phosphor bronze • Terminal seal : epoxy • Tape seal : polyester film GENERAL SPECIFICATIONS • Operating force : - NDS/DA models : 10N - DP models : 4N • Travel : - NDS/DA : 2 mm (.078) - DP models : 30° • Operating temperature : - DP/DA models : -20°C to +70°C - NDS models : -40°C to +85°C RECOMMENDED SOLDERING AND CLEANING PROCESSES • Hand soldering : 320°C max. for 2 seconds max. (30 watt iron max.) • Wave soldering : 260°C max. for 5 seconds max. • Force rinse, high agitation or triple bath cleaning method (with tape seal, option T) : freon TF or TE. When vapor methods are used, do not subject switch to solvents above 51°C. F Note : keep switches in "OFF" position during soldering and cleaning for best results. Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. Packaging unit : standard IC tubes - Quantities depending on model. See table below. NDS(R) Quantity NDS(R)-T Quantity DA Quantity DA-T Quantity NDS(R)-01 NDS(R)-02 NDS(R)-03 NDS(R)-04 NDS(R)-05 NDS(R)-06 NDS(R)-07 NDS(R)-08 NDS(R)-09 NDS(R)-10 NDS(R)-12 120 72 51 40 32 27 24 21 19 17 14 NDS(R)-01T NDS(R)-02T NDS(R)-03T NDS(R)-04T NDS(R)-05T NDS(R)-06T NDS(R)-07T NDS(R)-08T NDS(R)-09T NDS(R)-10T NDS(R)-12T 113 70 50 39 32 27 24 21 19 17 14 DA-02 DA-03 DA-04 DA-05 DA-06 DA-07 DA-08 DA-09 DA-10 DA-12 73 52 40 33 28 24 21 19 17 14 DA-02T DA-03T DA-04T DA-05T DA-06T DA-07T DA-08T DA-09T DA-10T DA-12T 70 50 39 32 28 24 21 19 17 14 APEM www.apem.com DP/DPL Quantity DP-T/DPL-T Quantity DP(L)-02 DP(L)-03 DP(L)-04 DP(L)-05 DP(L)-06 DP(L)-08 DP(L)-10 DP(L)-12 70 50 39 32 27 21 17 14 DP(L)-02T DP(L)-03T DP(L)-04T DP(L)-05T DP(L)-06T DP(L)-08T DP(L)-10T DP(L)-12T 65 49 39 32 27 21 17 14 F-7 NDS/NDSR series Standard DIP switches 1 2 3 4 5 6 7 8 9 10 11 • Raised or recessed actuator • 1 to 12 positions 12 MODEL STRUCTURE Raised actuator : NDS F NDS-02 2 6,44 (.253) 2,54 (.100) NDS-03 3 8,98 (.353) 5,08 (.200) NDS-04 4 11,52 (.453) 7,62 (.300) NDS-05 5 14,06 (.553) 10,16 (.400) NDS-06 6 16,60 (.653) 12,70 (.500) NDS-07 7 19,14 (.753) 15,24 (.600) NDS-08 8 21,68 (.853) 17,78 (.700) NDS-09 9 24,22 (.953) 20,32 (.800) NDS-10 10 26,76 (1.053) 22,86 (.900) NDS-12 12 31,84 (1.253) 27,94 (1.100) 2.54 (.100) 0.60 (.023) 7.62 (.300) 3.20 (.125) - A ON DIP 9.90 (.389) 4,22 (.166) 1 2 3 4 5 6 7 8 2.54 (.100) Ø0.97 (.038 DIA) 3.50 (.137) 1 7.62 (.300) NDS-01 1.20 (.047) 7.05 (.277) 1.60 (.062) 5.85 (.230) 1.40 (.055) Dim. "B" 3.20 (.125) Dim. "A" 9.90 (.389) No. Model No pos. B Top tape sealed : add "T" after model number. Recessed actuator : NDSR 2.54 (.100) NDSR-04 4 A 9.90 (.389) NDSR-06 NDSR-07 NDSR-08 6,44 (.253) 0.60 5.85 (.230) 2,54 (.100) 7.62 (.023) 8,98 (.353) (.300) 5,08 (.200) 11,52 (.453) 7,62 (.300) 5 14,06 DIP (.553) 10,16 (.400) 6 16,60 (.653) 12,70 (.500) 7 19,14 (.753) 15,24 (.600) Ø0.97(.853) 21,68 (.038 DIA) 17,78 (.700) 20,32 (.800) ON 1 2 3 4 5 6 7 8 8 2.54 (.100) 9 24,22 (.953) NDSR-10 10 26,76 (1.053) 22,86 (.900) NDSR-12 12 31,84 (1.253) 27,94 (1.100) B 0.60 (.023) 7.62 (.300) A ON DIP 1 2 3 4 5 6 7 8 2.54 (.100) 7.62 (.300) NDSR-09 2.54 (.100) Ø0.97 (.038 DIA) 3.50 (.137) 3 7.62 (.300) 2 NDSR-03 - 3.20 (.125) NDSR-02 NDSR-05 4,22 (.166) Dim. "B" 9.90 (.389) 1 3.20 (.125) NDSR-01 3.50 (.137) 7.05 (.277) Dim. "A" CNDS 1.60 (.062) 1.20 (.047) 1.40 (.055) No Model No pos. B Top tape sealed : add "T" after model number. F-8 www.apem.com CNDS APEM CNDSR DP/DPL series Piano DIP switches 1 2 3 4 5 6 7 8 9 10 11 • Short or long actuator • 2 to 12 positions 12 Note : Push down for "ON" is our standard type. Push down for "OFF" is also available on special order, consult factory. MODEL STRUCTURE Short actuator : DP A 2 6,44 (.253) 2,54 (.100) DP-03 3 9,18 (.361) 5,08 (.200) DP-04 4 11,72 (.461) 7,62 (.300) DP-05 5 14,26 (.561) 10,16 (.400) DP-06 6 16,80 (.661) 12,70 (.500) DP-08 8 21,88 (.861) 17,78 (.700) DP-10 10 26,96 (1.061) 22,86 (.900) DP-12 12 32,04 (1.261) 27,94 (1.100) 3 4 5 1 2 6 7 8 ON 2.54 (.100) 7.62 (.300) 0.60 (.023) 1.40 (.055) 2.54 (.100) Ø0.97 (.038 DIA) 7.62 (.300) DP-02 10.20 (.401) Dim. "B" 2.80 (.110) Dim "A" 10.80 (.425) No. Model No pos. B F Top tape sealed : add "T" after model number. Long actuator : DPL 6,44 (.253) 2,54 (.100) DPL-03 3 9,18 (.361) 5,08 (.200) DPL-04 4 11,72 (.461) 7,62 (.300) DPL-05 5 14,26 (.561) 10,16 (.400) DPL-06 6 16,80 (.661) 12,70 (.500) DPL-08 8 21,88 (.861) 17,78 (.700) DPL-10 10 26,96 (1.061) 22,86 (.900) DPL-12 12 32,04 (1.261) 27,94 (1.100) 1 2 3 4 5 2.54 (.100) 1.05 (.041) 2 6 7 8 ON 0.60 (.023) 7.62 (.300) 2.54 (.100) 1.40 (.055) Ø0.97 (.038 DIA) B 7.62 (.300) DPL-02 10.20 (.401) Dim. "B" 2.80 (.110) Dim "A" 12.57 (.494) A 10.80 (.425) No. Model No pos. Top tape sealed : add "T" after model number. APEM www.apem.com F-9 DA series Right angle DIP switches • 2 to 12 positions 1 2 3 4 5 6 7 8 9 10 11 12 MODEL STRUCTURE Raised actuator : DA F A Dim. "B" DA-03 3 8,89 (.350) 5,08 (.200) DA-04 4 11,52 (.453) 7,62 (.300) DA-05 5 14,06 (.553) 10,16 (.400) DA-06 6 16,60 (.653) 12,70 (.500) DA-07 7 19,14 (.753) 15,24 (.600) DA-08 8 21,68 (.853) 17,78 (.700) DA-09 9 24,22 (.953) 20,32 (.800) DA-10 10 26,76 (1.053) 22,86 (.900) DA-12 12 31,84 (1.253) 27,94 (1.100) ON 1.60 (.063) 2,54 (.100) 1 2 3 4 5 6 7 8 9 10 2.54 (.100) 1.50 (.059) 2.90 (.114) 6,44 (.253) 3.50 (.137) 2 0.60 (.023) 2.54 (.100) 6.20 (.244) 6.90 (.272) DA-02 1.40 (.055) ø0.97 (.038 DIA) 2.54 (.100) B 2.54 (.100) Dim "A" 9.90 (.389) No. Model No pos. Top tape sealed : add "T" after model number. F-10 www.apem.com APEM