Phone: +39-011-988 2251 Fax: +39-011-988 1358 Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] http://gpsemi.it/pdf/GPTN5061.pdf GPTN5061 PHASE CONTROLLED SCR High reliability operation DC power supply AC drives VOLTAGE UP TO BLOCKING CHARACTERISTICS Characteristic 4200 V AVERAGE CURRENT 610 A SURGE CURRENT 7.5 kA Conditions Value VRRM Repetitive peak reverse voltage 4200 V VRSM Non-repetitive peak reverse voltage 4300 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 4200 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 100 mA 100 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 610 A IT(RMS) R.M.S. on-state current 958 A ITSM Surge on-state current Sine wave,180° conduction, Th = 55 °C Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax I²t VT(TO) I² t for fusing coordination Threshold voltage Tj = Tjmax 1.297 V rT On-state slope resistance Tj = Tjmax 0.935 mW VTM Peak on-state voltage, max IH IL Holding current, max Latching current, typ On-state current IT = 1500 A , Tj = Tjmax Tj = 25 °C Tj = 25 °C 7.5 kA 281 kA²s 2.70 V 300 mA 700 mA TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 5 V 3.0 V IGT Gate trigger current Tj = 25 °C, VD = 5 V 250 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.3 V PGM Peak gate power dissipation Pulse width 1 ms 150 W PG(AV) Average gate power dissipation IFGM Peak gate current 10 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 12 V 10 V 3 W SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Non rep. - Tj = Tjmax dV/dt tq Critical rate of rise of off-state voltage Tj = Tjmax Turn-off time, typ Tj = Tjmax, IT = 2000 A, di/dt = -5 A/µs 150 A/µs 1000 V/µs µs VR = 200 V, VD = 67% VDRM, dV/dt = 20 V/µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.032 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.007 °C/W Tjmax Max operating junction temperature Tstg Storage temperature -40 / 125 °C F Clamping force ± 5% Mass 12 kN 300 g Document GPTN5061T002 125 °C GPTN5061 PHASE CONTROLLED SCR Current rating - sine wave Power loss - sine wave 120 110 100 PF [W] Heatsink temperature [°C] 130 90 80 70 60 30° 60° 50 0 200 90° 400 180° 120° 1800 1600 1400 1200 1000 800 600 400 200 0 600 180° 90° 60° 30° 0 200 400 IT [A] 600 IT[A] Maximum surge current d.s. cooled On-state voltage drop 8 7 6 5 [A] ITIT[A] ITSM [A] 120° 4 3 2 1400 1400 1200 1200 1000 1000 800 800 Tj=Tjmax Tj=Tjmax 600 600 400 400 200 200 1 0 1 10 100 00 0.5 0 1 1 1.5 2 2 2.5 VVTT[V] [V] Number of cycle current pulses [n] Thermal impedance (j-c) 0.035 ZTH(j-c) [°C / W] 0.03 0.025 0.02 0.015 0.01 0.005 0 0.001 0.01 0.1 1 10 100 Time [s] Ordering information GPTN5061-VVGL VV: blocking voltage / 100 (e.g. 42 for 4200 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTN5061T002 33