Revised December 1999 FST16292 12-Bit to 24-Bit Multiplexer/Demultiplexer Bus Switch General Description Features The Fairchild Switch FST16292 provides twelve 2:1 highspeed CMOS TTL-compatible multiplexer/demultiplexer bus switches. The low on resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. ■ 4Ω switch connection between two ports. The select pin connects the A Port to the selected B Port output. The A2 Ports are not externally connected, thus have a 500Ω pull-down resistor to ground. ■ Control inputs compatible with TTL level. ■ Minimal propagation delay through the switch. ■ Low lCC. ■ Zero bounce in flow-through mode. ■ Internal 500Ω pull-down resistor on A2 port. Ordering Code: Order Number Package Number Package Description FST16292MEA MS56A 56-Lead Shrink Small Outline Package (SSOP), JEDEC MO-118, 0.300 Wide FST16292MTD MTD56 56-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code. Logic Diagram Connection Diagram Pin Descriptions Truth Table Pin Name Description S0 A1 A2 Function SO Data-select input L B1 B2 A1 = B1 , A2 = B2 A1 Bus A H B2 B1 A1 = B2 , A2 = B1 B1 , B2 Bus B © 1999 Fairchild Semiconductor Corporation DS500104 www.fairchildsemi.com FST16292 12-Bit to 24-Bit Multiplexer/Demultiplexer Bus Switch July 1997 FST16292 Absolute Maximum Ratings(Note 1) −0.5V to +7.0V Supply Voltage (VCC ) DC Switch Voltage (VS) −0.5V to +7.0V DC Input Voltage (VIN) (Note 2) −0.5V to +7.0V DC Input Diode Current (lIK) VIN<0V −50mA DC Output (IOUT ) Sink Current 128mA 4.0V to 5.5V Power Supply Operating (VCC) Input Voltage (VIN) 0V to 5.5V Output Voltage (VOUT) 0V to 5.5V Input Rise and Fall Time (tr, tf) +/− 100mA DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) Recommended Operating Conditions Switch Control Input −65°C to +150 °C 0ns/V to 5ns/V Switch I/O 0ns/V to DC −40 °C to +85 °C Free Air Operating Temperature (TA) Note 1: The “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum rating. The “Recommended Operating Conditions” table will define the conditions for actual device operation. Note 2: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. DC Electrical Characteristics Symbol VCC (V) Parameter TA = −40 °C to +85 °C Typ (Note 3) Min Max −1.2 4.5 Units IIN = −18mA VIK Clamp Diode Voltage VIH HIGH Level Input Voltage 4.0–5.5 VIL LOW Level Input Voltage 4.0–5.5 0.8 V II Input Leakage Current 5.5 ±1.0 µA 0≤ VIN ≤5.5V 0 10 µA VIN = 5.5V 0 ≤A, B ≤VCC 2.0 V Conditions V IOZ OFF-STATE Leakage Current 5.5 ±1.0 µA RON Switch On Resistance 4.5 4 7 Ω VIN = 0V, IIN = 64mA (Note 4) 4.5 4 7 Ω VIN = 0V, IIN = 30mA 4.5 8 12 Ω VIN = 2.4V, IIN = 15mA 4.0 14 20 Ω VIN = 2.4V, IIN = 15mA ICC Quiescent Supply Current 5.5 3 µA VIN = VCC or GND, IOUT = 0 ∆ ICC Increase in ICC per Input 5.5 2.5 mA One input at 3.4V Other inputs at VCC or GND Note 3: Typical values are at VCC = 5.0V and T A =+25°C Note 4: Measured by the voltage drop between A and B pins at the indicated current through the switch. On resistance is determined by the lower of the voltages on the two (A or B) pins. www.fairchildsemi.com 2 TA = −40 °C to +85 °C, Symbol Parameter CL = 50pF, RU = RD = 500Ω VCC = 4.5 – 5.5V Min tPHL,tPLH Prop Delay Bus to Bus (Note 5) tPHL,tPLH Prop Delay S0 to A1 tPZL, tPZH Output Enable Time S0 to B1 or B2 tPLZ, tPHZ Output Disable Time VCC = 4.0V Max Min Units Conditions Figure No. Max 0.25 0.25 ns VI = OPEN Figure 1 Figure 2 1.5 7.0 7.4 ns VI = OPEN Figure 1 Figure 2 1.0 6.7 7.0 ns VI = 7V for tPZL Figure 1 Figure 2 1.0 7.5 7.8 ns VI = OPEN for tPZH VI = 7V for tPLZ VI = OPEN for tPHZ S0 to B1 or B2 Figure 1 Figure 2 Note 5: This parameter is guaranteed by design but is not tested. The bus switch contributes no propagation delay other than the RC delay of the typical On resistance of the switch and the 50pF load capacitance, when driven by an ideal voltage source (zero output impedance). Capacitance Symbol (Note 6) Parameter Typ Max Units Conditions CIN Control pin Input Capacitance 3 pF VCC = 5.0V CI/O Input/Output Capacitance 10 pF VCC = 5.0V, S0 =GND Note 6: TA = +25°C, f = 1 MHz, Capacitance is characterized but not tested. AC Loading and Waveforms Note: Input driven by 50 Ω source terminated in 50 Ω Note: CL includes load and stray capacitance Note: Input PRR = 1.0 MHz, tW = 500 ns FIGURE 1. AC Test Circuit FIGURE 2. AC Waveforms 3 www.fairchildsemi.com FST16292 AC Electrical Characteristics FST16292 Physical Dimensions inches (millimeters) unless otherwise noted 56-Lead Shrink Small Outline Package (SSOP), JEDEC MO-118, 0.300 Wide Package Number MS56A www.fairchildsemi.com 4 56-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide Package Number MTD56 Technology Description The Fairchild Switch family derives from and embodies Fairchild’s proven switch technology used for several years in its 74LVX3L384 (FST3384) bus switch product. Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. www.fairchildsemi.com 5 www.fairchildsemi.com FST16292 12-Bit to 24-Bit Multiplexer/Demultiplexer Bus Switch Physical Dimensions inches (millimeters) unless otherwise noted (Continued)