GSIB6A05 THRU GSIB6A100 SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V 6.0A Current: Features GSIB-5S Glass passivated chip junction Ideal for printed circuit board High surge current capability High case dielectric strength This series is UL listed under Recognized Component Index, file number E185029 Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, Method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol GSIB6 A05 GSIB6 A10 GSIB6 A20 GSIB6 A40 GSIB6 A60 GSIB6 A80 GSIB6 A100 units Maximum repetitive peak reverse voltage Vrrm 50 100 200 400 600 800 1000 V Maximum RMS voltage Vrms 35 70 140 280 420 560 700 V Maximum DC blocking voltage Vdc 50 100 200 400 600 800 1000 V If(av) 6.0 2.8 A Ifsm 150 A Vf 1.0 V I2t 93 A2Sec Ir 10.0 250 µA (Note2) (Note1) Rth(ja) Rth(jc) 22.0 3.4 ℃/W Operating junction and storage temperature range Tj, Tstg -55 to +150 ℃ Maximum average forward Tc = 100℃(Note 1) Rectified output current at Ta = 25℃(Note 2) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 3.0A Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Maximum thermal resistance per leg Ta = 25°C Ta = 125°C Note: 1. Unit case mounted onAl plate heatsink 2. Unit case mounted on P.C.B. with 0.5 x 0.5” (12 x 12mm) copper peads and 0.375”(9.5mm) lead length 3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw Rev.A8 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GSIB6A05 THRU GSIB6A100 Rev.A8 www.gulfsemi.com