THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 5.0V STRATUM 3 HCMOS OCXO CW 0107 CGOF5S3 10.00M ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage TABLE 1.0 UNITS MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.5 - 7.0 Vdc MINIMUM NOMINAL MAXIMUM UNITS OPERATING SPECIFICATIONS (Fo) 10.00 Frequency Calibration Frequency Stability Frequency Aging Daily Frequency Aging Lifetime (20 Years) Total Frequency Tolerance Operating Temperature Range 0.5 -0.5 -0.1 -4.6 -20 - 0.1 20 3.0 4.6 70 ppm ppm ppb/day ppm ppm °C (Vcc) 4.75 5.00 5.25 Vdc Supply Current (Icc) - - 300 mA Supply Current Steady State @25°C (Icc) - 65 - mA Jitter (BW=10Hz to 20MHz) - - 3 ps rms Allan Variance (1 second) SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - 5.00E-10 -90 -145 - 10 5 1 2 dBc/Hz dBc/Hz mS Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 4.5 - - 15 0.4 pf Vdc Vdc 50 - 4 55 6 mA mA % nS (Voh) (Vol) (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% 1 2 3 The Connor-Winfield CGOF5S3 is a hermetically sealed 14 Pin DIP, 5.0V Oven Controlled Crystal Oscillator (OCXO) HCMOS / TTL Compatible. The CGOF5S3 is designed for higher stability Stratum 3 applications requiring low jitter and tight calibration. 4 FEATURES TABLE 3.0 PARAMETER Current DESCRIPTION 5.0V OPERATION HCMOS OUTPUT CHARACTERISTICS (High) (Low) NOTE MHz Supply Voltage LOAD Voltage CGOF5S3 TABLE 2.0 PARAMETER Center Frequency NOTE (Ioh) (Ioh) -4 45 - NOTE LOW JITTER <3pS RMS TEMPERATURE STABILITY ±0.1ppm OVERALL FREQUENCY TOLERANCE : ±4.6ppm over Twenty Years. OVERALL AGING: ±3.0ppm over Twenty Years TABLE 4.0 PACKAGE CHARACTERISTICS Package 14 pin DIP, hermetically sealed, grounded case, welded package ORDERING INFORMATION Notes: 1) Initial calibration @ 25°C at time of shipment. 2) Frequency vs. temperature stability 3) Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration and aging over 20 years. 4) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25 °C CGOF5S3 OCXO SERIES - 10.00MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx028 PAGE 1 OF 2 REV: 03 DATE: 7/12/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1minute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 38 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Tops ide board-mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15m inute cycles 12 times each perpendi cular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, halfsine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. Specifications subject to change without notice. DATA SHEET #: Cx028 PAGE 2 OF 2 REV: 03 DATE: 7/12/02 aCopyright 2001 Connor-Winfield all rights reserved.