Embedded Power for Business-Critical Continuity Rev.06.18.09_104 NLP65 Medical of 4 NLP65 Medical Series Single, dual and triple output Total Power: 65W Input Voltage: 85 - 264 VAC # of Outputs: Single, dual, triple Special Features • 85 VAC to 264 VAC universal input range • Harmonic current correction as standard • Maximum component height 1.26 inches • UL, CSA and VDE safety approvals • Overvoltage and short circuit protection • 5 x 3 x 1.26 inch (127.0 x 76.2 x 32mm) footprint • Available RoHS compliant • 2 year warranty Electrical Specifications Input Input voltage range: Universal input (see Note 2) Input frequency range: 85 - 264 Vac 47 - 63 Hz Input current: (cold start) 120 Vac 230 Vac 17 A max. 32 A max Safety ground leakage current: 264 Vac, 60 Hz 95 µA Input current: 120 Vac 230 Vac 1.05 A rms 0.51 A rms Input fuse: 250 Vac F 3.15 A Output Output power: Total regulation: (line and load) Rise time: Safety Transient response: • VDE0705/EN60601-1/IEC1010 File No. 10401-3336-0156/32480 Licence No. 121949 • UL1950 File No. E147937 • CSA C22.2 No. 950 File No. LR41062C Temperature coefficient: Natural convection 65 W max. See table At turn-on 1.0 s, max Main output 25% step at 0.1 A/µs 5.0% max. dev., 1ms recovery to 1.0% ± 0.02%/°C Overvoltage protection: Main outputs 125%, ± 10% Short circuit protection: Cyclic operation Yes Embedded Power for Business-Critical Continuity All specifications are typical at nominal input, full load at 25° C unless otherwise stated. Rev.06.18.09_104 NLP65 Medical of 4 EMC Charateristics Conducted emissions: EN55022, FCC part 15 Level A Radiated emissions: EN55022, FCC part 15 Level A ESD air: EN61000-4-2, level 3 Perf. criteria 1 ESD contact: EN61000-4-2, level 4 Perf. criteria 1 Surge: EN61000-4-2, level 3 Perf. criteria 1 Fast transients: EN61000-4-4, level 3 Perf. criteria 1 Radiated immunity: EN61000-4-3, level 3 Perf. criteria 2 Conducted immunity: EN61000-4-6, level 3 Perf. criteria 2 Hold-up time: 120 Vac, 60 Hz 16 ms @ 65 W Efficiency: 120 Vac, 65 W 72% typical Isolation voltage: Input/output Input/chassis 4000 Vac 1500 Vac Switching frequency: Fixed 100 kHz, ± 5 kHz Approvals and standards: EN60601, UL2601, CSA 22.2 No. 125 Weight: 283 g (10 oz) MTBF demonstrated: MIL-HDBK-217F General Specifications 150,000 hours Environmental Specifications Thermal performance: Operating ambient (See derating curve) 0° C to +70 °C Non-operating -40 °C to +85 °C 75W 0 °C to 50 °C, ambient, convection cooled 50 °C - 70 °C ambient, convection cooled 65 W 65W Peak (0 °C to 50 °C, 60 s) See table Relative humidity: Non-condensing 5 to 95% RH Altitude: Operating 10,000 feet max. DERATING CURVE Output Power (Watts) 20 CFM FORCED AIR COOLING Derate to 50% load Non-operating 30,000 feet max. Vibration (See Note 5): 5 - 500 Hz 2.4 G rms approx. Shock per MIL-STD-810E 516.4 Part IV NATURAL CONVECTION COOLING 0°C 38W 32W 10°C 20°C 30°C 40°C 50°C 60°C 70°C Embedded Power for Business-Critical Continuity Rev.06.18.09_104 NLP65 Medical of 4 Ordering Information Output Voltage Output Current Ripple (4) Total Regulation (6) Model Number (11, 12) 8A 50 mV ±2.0% NLP65-9908J Max (1) Peak Fan (10) +5 V 7A 9.1 A +12 V 2.5 A 3.3 A 3A 150 mV ±5.0% –12 V 0.5 A 0.81 A 1A 120 mV ±5.0% +5 V 7A 9.1 A 8A 50 mV ±2.0% +15 V 2.2 A 2.9 A 2.5 A 150 mV ±5.0% –15 V 0.65 A 0.85 A 0.8 A 150 mV ±5.0% +5 V 7A 9.1 A 8A 50 mV ±2.0% +24 V 2A 2.6 A 2A 240 mV ±5.0% +5 V 7A 9.1 A 8A 50 mV ±2.0% +12 V 2.5 A 3.3 A 3A 150 mV ±5.0% NLP65-9910J NLP65-9920J NLP65-9929J +5 V 10 A 13 A 12 A 50 mV ±2.0% NLP65-9905J +12 V 5.4 A 7A 6.5 A 120 mV ±2.0% NLP65-9912J +15 V 4.4 A 5.7 A 5.3 A 150 mV ±2.0% NLP65-9915J +24 V 2.7 A 3.5 A 3.5 A 240 mV ±2.0% NLP65-9924J Notes Natural convection cooling. Models NLP65-9929J, NLP65-9908J, NLP65-9910J must not exceed 62.5 Watts continuous output power with natural convection. Model NLP65-9920J not to exceed 65 Watts continuous output power with natural convection. 2 When the input voltage is less than 90 Vac the operating temperature range is 0 °C to +40 °C. The ripple and regulation specifications may not be met. 3 Peak output current lasting less than 60 seconds with duty cycle less than 5%. During peak loading, output voltage may exceed total regulation limits. 4 Figure is peak-to-peak for convection power rating. Output noise measurements are made across a 20 MHz bandwidth using a 6 inch twisted pair, terminated with a 10 µF electrolytic capacitor and a 0.1 µF ceramic capacitor. 5 Three orthogonal axes, random vibration 10 minutes for each axes, 2.4 G rms 5 Hz to 500 Hz. 6 To maintain stated regulation then: for single output units I ≥ 0.2 A I max. for multiple output units 0.25 ≤ I(A)/I(B) ≤ 5, for I(A) ≥ 0.2 A I(A) max. 7 For optimum reliability, no part of the heatsink should exceed 120 oC, and no semiconductor case temperature should exceed 130 oC. 8 CAUTION: Allow a minimum of 1 second after disconnecting line power when making thermal measurements. 9 This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. 10 Maximum continuous output power for all multiple output models must not exceed 75 Watts with 20 CFM forced air cooling at 50 oC. 11 The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. 12 NOTICE: Some models do not support all options. Please contact your local Emerson Network Power representative or use the on-line model number search tool at http://www.PowerConversion.com to find a suitable alternative. 1 Embedded Power for Business-Critical Continuity Americas 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone: +1 760 930 4600 Facsimile: +1 760 930 0698 5.00 (127.00) 4.550 (115.57) 0.225 (5.715) J1 1 1 L 3.00 (76.20) 6 T1 J2 Europe (UK) Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone: +44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 J3 3 N Rev.06.18.09_104 NLP65 Medical of 4 2.550 (64.770) C19 Asia (HK) 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong Telephone: +852 2176 3333 Facsimile: +852 2176 3888 For global contact, visit: Mounting Hole Diameter 0.156 (4.00) ALL DIMENSIONS IN INCHES (mm) Pin Connections Input and Output Connectors Mating Connectors AC (J1) Molex 26-60-4030 type Molex 09-50-3031 or equivalent with Molex 08-50-0105 or equivalent crimp terminals DC (J3) Molex 26-60-4060 Molex 09-50-3061 with Molex 2478 phosphor bronze crimp terminals or equivalent. J1 Pin 1 AC Line Pin 2 No Pin Pin 3 AC Neutral Pin 1 MAXIMUM COMPONENT HEIGHT 1.26 (32.00) TOLERANCE: .xxx 0.005" .xx 0.02" www.PowerConversion.com techsupport.embeddedpower@ emerson.com While every precaution has been taken to ensure accuracy and completeness in this literature, Emerson Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Emerson Network Power. The global leader in enabling business-critical continuity. AC Power J2 Connectivity Safety Ground DC Power Embedded Computing Embedded Power Output Pin Connections J3 SINGLE DUAL TRIPLE Pin 1 No Connection V (B) V (B) Pin 2 V (A) V (A) V (A) Pin 3 V (A) V (A) V (A) Pin 4 Return Return Return Pin 5 Return Return Return Pin 6 No Connection No Pin V (C) Monitoring Outside Plant Power Switching & Controls Precision Cooling Racks & Integrated Cabinets Services Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2009 Emerson Electric Co.