• 1N4099UR-1 THRU 1N4135UR-1 AVAILABLE IN JAN, JANTX, JANTXV AND 1N4099UR-1 thru 1N4135UR-1 and JANS PER MIL-PRF-19500/435 • LEADLESS PACKAGE FOR SURFACE MOUNT • LOW CURRENT OPERATION AT 250 µA CDLL4099 thru CDLL4135 • METALLURGICALLY BONDED • DOU- MAXIMUM RATINGS Junction and Storage Temperature: -65°C to +175°C DC Power Dissipation: 500mW @ TEC = +125°C Power Derating: 10mW/ °C above TEC = +125°C Forward Derating @ 200 mA: 1.1 Volts maximum ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise specified. CDI TYPE NUMBER NOMINAL ZENER VOLTAGE VZ @ lZT (Note 1) ZENER TEST CURRENT lZT MAXIMUM ZENER IMPEDANCE ZZT (Note 2) MAXIMUM REVERSE LEAKAGE CURRENT lR @ VR µA OHMS VOLTS mA CDLL4099 CDLL4100 CDLL4101 6.8 7.5 8.2 250 250 250 200 200 200 10 10 1.0 5.17 5.70 6.24 56 51 46 CDLL4102 CDLL4103 CDLL4104 8.7 9.1 10 250 250 250 200 200 200 1.0 1.0 1.0 6.61 6.92 7.60 44 42 38 CDLL4105 CDLL4106 CDLL4107 11 12 13 250 250 250 200 200 200 .05 .05 .05 8.44 9.12 9.87 35 32 29 CDLL4108 CDLL4109 CDLL4110 14 15 16 250 250 250 200 100 100 .05 .05 .05 10.65 11.40 12.15 27 25 24 CDLL4111 CDLL4112 CDLL4113 17 18 19 250 250 250 100 100 150 .05 .05 .05 12.92 13.67 14.44 22 21 20 CDLL4114 CDLL4115 CDLL4116 20 22 24 250 250 250 150 150 150 .01 .01 .01 15.20 16.72 18.25 19 17 16 CDLL4117 CDLL4118 CDLL4119 25 27 28 250 250 250 150 150 200 .01 .01 .01 19.00 20.46 21.28 15 14 14 CDLL4120 CDLL4121 CDLL4122 30 33 36 250 250 250 200 200 200 .01 .01 .01 22.80 25.08 27.38 13 12 11 CDLL4123 CDLL4124 CDLL4125 39 43 47 250 250 250 200 250 250 .01 .01 .01 29.65 32.65 35.75 9.8 8.9 8.1 LEAD FINISH: Tin / Lead CDLL4126 CDLL4127 CDLL4128 51 56 60 250 250 250 300 300 400 .01 .01 .01 38.76 42.60 45.60 7.5 6.7 6.4 THERMAL RESISTANCE: (ROJEC): 100 °C/W maximum at L = 0 inch CDLL4129 CDLL4130 CDLL4131 62 68 75 250 250 250 500 700 700 .01 .01 .01 47.10 51.68 57.00 6.1 5.6 5.1 CDLL4132 CDLL4133 CDLL4134 CDLL4135 82 87 91 100 250 250 250 250 800 1000 1200 1500 .01 .01 .01 .01 62.32 66.12 69.16 76.00 4.6 4.4 4.2 3.8 VOLTS NOTE 1 NOTE 2 µA MAXIMUM ZENER CURRENT lZM The CDI type numbers shown above have a Zener voltage tolerance of + 5% of the nominal Zener voltage. Nominal Zener voltage is measured with the device junction in thermal equilibrium at an ambient temperature of 25°C + 3°C. A "C" suffix denotes a + 2% tolerance and a "D" suffix denotes a + 1% tolerance. Zener impedance is derived by superimposing on lZT, A 60 Hz rms a.c. current equal to 10% of lZT (25 µ A a.c.). DIM D F G G1 S MILLIMETERS INCHES MIN MAX MIN MAX 1.60 1.70 0.063 0.067 0.41 0.55 0.016 0.022 3.30 3.70 .130 .146 2.54 REF. .100 REF. 0.03 MIN. .001 MIN. FIGURE 1 DESIGN DATA CASE: DO-213AA, Hermetically sealed glass case. (MELF, SOD-80, LL34) THERMAL IMPEDANCE: (ZOJX): 35 °C/W maximum POLARITY: Diode to be operated with the banded (cathode) end positive. MOUNTING SURFACE SELECTION: The Axial Coefficient of Expansion (COE) Of this Device is Approximately +6PPM/°C. The COE of the Mounting Surface System Should Be Selected To Provide A Suitable Match With This Device. 6 LAKE STREET, LAWRENCE, MASSACHUSETTS 01841 PHONE (978) 620-2600 FAX (978) 689-0803 WEBSITE: http://www.microsemi.com 111 1N4099UR-1 CDLL4099 thru thru 1N4135UR-1 CDLL4135 Pd, Rated Power Dissipation (mW) FIGURE 2 500 400 300 200 100 0 0 25 50 75 100 125 150 175 TEC , End cap temperature (°C) POWER DERATING CURVE 1000 500 400 300 ZENER IMPEDANCE ZZT (OHMS) 200 100 50 40 30 28 VOLT 20 10 11 VOLT 5 4 3 2 6.8 VOLT 1 .1 2 .5 1 2 5 10 OPERATING CURRENT IZT (mA) 20 FIGURE 3 ZENER IMPEDANCE VS. OPERATING CURRENT 112 50 100