Switched Multi-Channel Amplifier 2000-8000 MHz Model BXMF1020 FEATURES • Phase Matched • Amplitude Matched • Built-in Input Drive Protection • High Channel to Channel Isolation • 4 Channel Design Spectrum Microwave offers state-of-the-art multi-channel amplifiers used in demanding military frequency calibration systems. These 2, 3, and 4 channel modules are all phase matched, amplitude matched and offer both single and multiple path logic. These units allow the engineer to either distribute an amplified signal to multiple ports, or measure the amplified output from up to 4 auxiliary ports. Parameter Typical Min./Max. Frequency Range Receive Gain CAL Path Gain Noise Figure 1 dB Compression Single-Tone Spurious Free Dynamic Range Phase Tracking Delta (Electrical Degrees) Amplitude Tracking (Channel to Channel) Out Of Band Rejection Reverse Isolation Channel to Channel Isolation 2000 to 8000 MHz 13 dB 21 dB 9 dB +9 dBm 45 dB o 12 at any frequency 2 dB Variation Between Channels 30 dB 40 dB 60 dB 200 nsec 2.0:1 50 dB 2000 to 8000 MHz - Switching Speed (50% TTL to 90% / 10% RF) VSWR Switching Isolation (ON to OFF) DC Power Housing Size RF Connectors Operating Case Temp. (Min./Max. Values) +6.5v / 525 mA, +3.3v / 250 mA, -15v / 50 5.0 “ x 3.0 “ x 0.65 “ Field Replaceable SMA Connectors -40°C to +85°C Maximum (No Damage) Ratings Storage Temperature Operating Temperature DC Voltage @ 25°C Input Drive @ 25°C -65°C to +125°C -55°C to +100°C +/- 20 VDC +20 dBm Spectrum Microwave, Inc. • PH: 888.553.7531 • Fax: 888.553.7532 • Email: [email protected] • www.SpectrumMicrowave.com