DA9281.002 10 July 2006 MAS9281 IC FOR 10.00 – 60.00 MHz XO This is advance information on a new product under development. Micro Analog Systems Oy reserves the right to make any changes without notice. Low Cost Divider Option up to fo/512 Wide Supply Voltage Range CMOS Output • Very High Level of Integration • Very Low Phase Noise • Output Three-State Function • • • • DESCRIPTION MAS9281 is an integrated circuit well suited to make fundamental crystal oscillator (XO): only one additional component, a crystal is needed. MAS9281 includes oscillator and output buffer circuits. FEATURES • • • • • • APPLICATIONS Very small size Minimum current draw Stand-by functions: Output high impedance, but oscillator running. Output high impedance and oscillator stop Wide operating temperature range Phase noise <-130 dBc/Hz at 1 kHz offset CMOS output XO for data terminals XO for telecommunication applications XO for computer application • • • BLOCK DIAGRAM PD 1/2 1/2 1/2 1/2 OUT VDD MAS9281 X2 X1 X'Tal VSS 1 (6) DA9281.002 10 July 2006 ABSOLUTE MAXIMUM RATINGS Parameter Symbol Min Max Unit Supply Voltage Input Voltage Power Dissipation Operating Temperature Storage Temperature VDD - VSS VIN PMAX TOP TST -0.3 VSS -0.3 6.0 VDD + 0.3 120 85 150 V V mW o C o C -40 -55 Note RECOMMENDED OPERATION CONDITIONS Parameter Supply Voltage Crystal Load Capacitance MAS9281AN, -AP, -AQ, -AR, -AS, -AT, MAS9281A0, -A1, -A2, -A3, -A4 MAS9281AG -AH, -AJ, -AK, -AL MAS9281AA, -AB, -AC, -AD, -AE Symbol Conditions VDD CL Min Typ Max Unit Note 2.4 2.8 5.5 V 1) 2) 14.5 14.5 11 9 Note 1: If VDD = 5V, it is recommended to connect 1nF capacitor to Vdd pin. Note 2: For other load capacitance options contact to Micro Analog Systems Oy. ELECTRICAL CHARACTERISTICS FOR 3V SUPPLY VOLTAGE TA = -40°C to +85°C, typical values at TA = +27°C, VDD = 2.7V… 3.3V, fO = 30 MHz, Output Load = 15 pF, unless otherwise specified. Parameter Symbol Min 50 pF fo 10.00 60.00 MHz fo 10.00 40.00 MHz Output Load Crystal Frequency Range when Output Load is Maximum 30pF Crystal Frequency Range when Output Load is Maximum 50pF Supply Current MAS9281 (fo) MAS9281 (fo/2) MAS9281 (fo/4) MAS9281 (fo/8) MAS9281 (fo/16) MAS9281 (fo/512) Output Voltage Range 15 Output Symmetry Max IDD Unit mA 5.7 4.5 4.1 3.9 3.7 3.5 Vdd ± 0.5 Rise and Fall Time Start-up Time Typ 3 TSTART 48-52 Note 1 See fig. 2 Vpp 4 2 45 Note ns ms 55 % Tri State Output Buffer PD V OFF State 0 0.55 ON State 1.6 VDD Power Down High Level Output 2.7 V VOH Voltage: Ioh=5.2 mA ,Vdd = 3V (Test measurement, see fig. 1, p. 5) PD Pull-up Resistance Rup1 900k ohm (Design value) Note1: MAS9281AN – MAS9281AT and MAS9281A0 – MAS9281A4 maximum frequency is 44MHz. 2 (6) DA9281.002 10 July 2006 ELECTRICAL CHARACTERISTICS FOR 5V SUPPLY VOLTAGE TA = -40°C to +85°C, typical values at TA = +27°C, VDD = 4.5V… 5V, fO = 30 MHz, Output Load = 15 pF, unless otherwise specified. Parameter Symbol Min Output Load Crystal Frequency Range when Output Load is Maximum 30pF Crystal Frequency Range when Output Load is Maximum 50pF Supply Current MAS9281 (fo) MAS9281 (fo/2) MAS9281 (fo/4) MAS9281 (fo/8) MAS9281 (fo/16) MAS9281 (fo/512) Output Voltage Range Unit 15 50 pF 10.00 60.00 MHz fo 10.00 40.00 MHz IDD mA 11.3 8.0 7.7 7.6 7.3 7.1 Vdd ± 0.5 3 TSTART 45 48-52 Note Note 1 See fig. 2 Vpp 4 2 Output Symmetry Tri State Output Buffer OFF State ON State Power Down High Level Output Voltage: Ioh=16 mA ,Vdd = 5V (Test measurement, see fig. 1, p. 5) PD Pull-up resistance Design value Max fo Rise and Fall Time Start-up Time Typ ns ms 55 PD % V 0 1.6 0.55 VDD VOH 4.7 V Rup1 900k ohm Note1: MAS9281AN – MAS9281AT and MAS9281A0 – MAS9281A4 maximum frequency is 44MHz PIN DESCRIPTION Pin Description Power Down Crystal Oscillator Output Crystal Oscillator Input Power Supply Ground Power Supply Voltage Buffer Output Symbol x-coordinate y-coordinate PD X2 X1 146 312 553 140 140 140 VSS VDD OUT 695 178 597 140 826 826 Note: Because the substrate of the die is internally connected to GND, the die has to be connected to GND or left floating. Please make sure that GND is the first pad to be bonded. Pick-and-place and all component assembly are recommended to be performed in ESD protected area. Note: Pad coordinates are measured from the left bottom corner of the chip to the center of the pads. The coordinates may vary depending on sawing width and location, however, distances between pads are accurate. 3 (6) DA9281.002 10 July 2006 IC OUTLINES VDD OUT MAS9281A1 988um PD X2 X1 VSS Die map reference 850um Note: Die map reference is the actual left bottom corner of the sawn chip. SERIES CONFIGURATION Product Code MAS9281AA MAS9281AB MAS9281AC MAS9281AD MAS9281AE MAS9281AG MAS9281AH MAS9281AJ MAS9281AK MAS9281AL MAS9281AN MAS9281AP MAS9281AQ MAS9281AR MAS9281AS MAS9281AT MAS9281A0 MAS9281A1 MAS9281A2 MAS9281A3 MAS9281A4 Output Frequency fo fo/2 fo/4 fo/8 fo/16 fo fo/2 fo/4 fo/8 fo/16 fo fo/2 fo/4 fo/8 fo/16 fo/512 fo fo/2 fo/4 fo/8 fo/16 Crystal Load (pF) 9 9 9 9 9 11 11 11 11 11 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 Output Load (pF) 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 Output Duty Level CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS CMOS Power Down Function Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Frequency Range (MHz) 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 - 60 10 – 44 10 – 44 10 – 44 10 – 44 10 - 44 10 - 44 10 – 44 10 – 44 10 – 44 10 – 44 10 – 44 4 (6) DA9281.002 10 July 2006 APPLICATION INFORMATION Version PD pin Output Oscillator AA, AB, AC, AD, AE, AG, AH, AJ, AK, AL, AN, AP, AQ, AR, AS, AT HIGH LOW Floating HIGH LOW Floating Normal Operation High Impedance Normal Operation Normal Operation High Impedance Normal Operation Normal Operation Stopped Normal Operation Normal Operation Normal Operation Normal Operation A0, A1, A2, A3, A4 Figure 1 Signal Generator 1nF X1 MAS9281 Output 250R 50R Vdd Vss Figure 2 Signal Generator 1nF X1 MAS9281 Output 50R Vdd Vss A 5 (6) DA9281.002 10 July 2006 ORDERING INFORMATION Product Code MAS9281AATG00 MAS9281ABTG00 MAS9281ACTG00 MAS9281ADTG00 MAS9281AETG00 MAS9281AGTG00 MAS9281AHTG00 MAS9281AJTG00 MAS9281AKTG00 MAS9281ALTG00 MAS9281ANTG00 MAS9281APTG00 MAS9281AQTG00 MAS9281ARTG00 MAS9281ASTG00 MAS9281ATTG00 MAS9281A0TG00 MAS9281A1TG00 MAS9281A2TG00 MAS9281A3TG00 MAS9281A4TG00 Output Frequency fo fo/2 fo/4 fo/8 fo/16 fo fo/2 fo/4 fo/8 fo/16 fo fo/2 fo/4 fo/8 fo/16 fo/512 fo fo/2 fo/4 fo/8 fo/16 Crystal Load (pF) Wafer thickness 9 9 9 9 9 11 11 11 11 11 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 14.5 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm 215 µm Comments Tested, wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer Tested wafer For product definitions see Application Information on page 5. Contact Micro Analog Systems Oy for other wafer thickness options. LOCAL DISTRIBUTOR MICRO ANALOG SYSTEMS OY CONTACTS Micro Analog Systems Oy Kamreerintie 2, P.O. Box 51 FIN-02771 Espoo, FINLAND Tel. +358 9 80 521 Fax +358 9 805 3213 http://www.mas-oy.com NOTICE Micro Analog Systems Oy reserves the right to make changes to the products contained in this data sheet in order to improve the design or performance and to supply the best possible products. Micro Analog Systems Oy assumes no responsibility for the use of any circuits shown in this data sheet, conveys no license under any patent or other rights unless otherwise specified in this data sheet, and makes no claim that the circuits are free from patent infringement. Applications for any devices shown in this data sheet are for illustration only and Micro Analog Systems Oy makes no claim or warranty that such applications will be suitable for the use specified without further testing or modification. 6 (6)