Phone: +39-011-988 2251 Fax: +39-011-988 1358 Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] http://gpsemi.it/pdf/GPTS3570.pdf GPTS3570 PHASE CONTROLLED SCR High reliability operation DC power supply Controlled rectifiers DC drives - Motor starters BLOCKING VOLTAGE UP TO 2800 V AVERAGE CURRENT 5700 A SURGE CURRENT BLOCKING CHARACTERISTICS Characteristic Conditions 76 kA Value VRRM Repetitive peak reverse voltage 2800 V VRSM Non-repetitive peak reverse voltage 2900 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 2800 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 300 mA 300 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 5700 A IT(RMS) R.M.S. on-state current Surge on-state current Sine wave,180° conduction, Th = 55 °C Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax 8953 A ITSM I²t VT(TO) I² t for fusing coordination Threshold voltage Tj = Tjmax 0.85 V rT On-state slope resistance Tj = Tjmax 0.07 mW VTM Peak on-state voltage, max 1.41 V IH IL Holding current, max Latching current, typ On-state current IT = 8000 A , Tj = Tjmax Tj = 25 °C Tj = 25 °C 76 kA 28880 kA²s 400 mA 1500 mA TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 12 V 3 V IGT Gate trigger current Tj = 25 °C, VD = 12 V 300 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.35 V PGM Peak gate power dissipation Pulse width 0.5 ms 150 W PG(AV) Average gate power dissipation IFGM Peak gate current 12 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 30 V 5 V 5 W SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Tj = Tjmax 250 A/µs dV/dt tq Critical rate of rise of off-state voltage Tj = Tjmax 1000 V/µs Turn-off time, typ Tj = Tjmax, IT = 2000 A, di/dt = -10 A/µs VR = 100 V, VD = 67% VDRM, dV/dt = 20 V/µs 500 µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.0057 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.0010 °C/W Tjmax Max operating junction temperature Tstg Storage temperature F Clamping force ± 10% Mass Document GPTS3570T002 125 °C -40 / 125 °C 80 kN 2700 g GPTS3570 PHASE CONTROLLED SCR Current rating - sine wave Power loss - sine wave 12000 120 10000 110 90° 90 80 70 30° 60 60° 90° 120° 180° 30° 6000 4000 2000 180° 50 0 0 1000 2000 3000 4000 5000 6000 0 1000 2000 3000 IT [A] 4000 5000 On-state voltage drop 80 10000 12000 70 8000 10000 50 8000 6000 [A] ITIT[A] 60 40 30 20 10 0 1 10 100 Tjmax Tj=T j=Tjmax 6000 4000 4000 2000 2000 00 0.8 0 1 0.5 1.2 1 1.4 1.51.6 VTT [V] Number of cycle current pulses [n] Thermal impedance (j-c) 0.006 0.005 ZTH(j-c) [°C / W] 6000 IT[A] Maximum surge current d.s. cooled ITSM [A] 120° 60° 8000 100 PF [W] Heatsink temperature [°C] 130 0.004 0.003 0.002 0.001 0 0.001 0.01 0.1 1 10 100 Time [s] Ordering information GPTS3570-VVGL VV: blocking voltage / 100 (e.g. 28 for 2800 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTS3570T002 1.8 2