Raltron CO6 Through hole clock oscillators-hcmos compatible Datasheet

THROUGH HOLE CLOCK OSCILLATORS-HCMOS COMPATIBLE
SERIES CO6 AND CO12
FEATURES
STANDARD 8 AND 14 PIN DIP PACKAGE
TOLERANCE AND STABILITY TO ± 25 PPM
EXCELLENT CLOCK FOR 16 AND 32 BIT PROCESSORS
LOW COST
AVAILABLE IN 3.3 VOLT
SPECIFICATIONS
SERIES
CO6
PACKAGE
CO12
14 PIN DIP
FREQUENCY RANGE
8 PIN DIP
500.00 KHz TO 125.00 MHz
500.00 KHz TO 125.00 MHz
CO6100 : ±100 PPM
CO12100 : ±100 PPM
CO6050 : ±50 PPM
CO12050 : ±50 PPM
FREQUENCY STABILITY†
CO6025 : ±25 PPM
CO12025 : ±25 PPM
0° C TO +70° C STANDARD
-40° C TO 85° C EXTENDED
0° C TO +70° C STANDARD
-40° C TO 85° C EXTENDED
STORAGE TEMPERATURE RANGE
-55° C TO +125° C
-55° C TO +125° C
VOLTAGE††
+5 VDC ±0.5 VDC
+5 VDC ±0.5 VDC
500 KHz TO 19.999 MHz: 20 mA
500 KHz TO 19.999 MHz: 20 mA
20 MHz TO 34.999 MHz: 30 mA
20 MHz TO 34.999 MHz: 30 mA
35 MHz TO 69.999 MHz: 40 mA
35 MHz TO 69.999 MHz: 40 mA
70 MHz TO 125 MHz: 60 mA
70 MHz TO 125 MHz: 60 mA
40 TO 60% NORMAL
45 TO 55% TIGHT
40 TO 60% NORMAL
45 TO 55% TIGHT
OPERATING TEMPERATURE RANGE
INPUT
CURRENT (MAX)
SYMMETRY
RISE AND FALL TIME
(0.5 - 4.5 VDC)
OUTPUT
UNDER 24 MHz : ±10 ns MAX
UNDER 24 MHz : ±10 ns MAX
24 MHz TO 70 MHz : ±6 ns MAX
24 MHz TO 70 MHz : ±6 ns MAX
70 MHz TO 125 MHz : ±3 ns MAX
70 MHz TO 125 MHz : ±3 ns MAX
LOGIC "0" LEVEL
+0.5 V MAX. (10% VDD)
+0.5 V MAX. (10% VDD)
LOGIC "1" LEVEL
+4.5 V MIN (90% VDD)
+4.5 V MIN (90% VDD)
15 pF OR 10 LS TTL STANDARD
15 pF OR 10 LS TTL STANDARD
LOAD†††
† FREQUENCY STABILITY INCLUSIVE OF ROOM TOLERANCE , FREQUENCY STABILITY OVER TEMPERATURE,
10% POWER SUPPLY VARIATION, AGING, SHOCK, AND VIBRATION
†† +3.3 VOLT VERSION IS AVAILABLE. CONSULT RALTRON FOR SPECIFICATIONS
††† OUTPUT LOADS ALSO AVAILABLE AT 15 pF, 30 pF AND 50 pF. CONSULT RALTRON FOR SPECIFICATIONS
ENVIRONMENTAL AND TECHNICAL CONDITIONS
OUTPUT WAVEFORMS
ENVIRONMENTAL
TEMPERATURE CYCLE
MIL-STD 883, METHOD 1010, 10 CYCLES -20° C TO 85° C
SHOCK
MIL-STD-202, METHOD 213, TEST CONDITION C
VIBRATION
MIL-STD-202, METHOD 204, TEST CONDITION A
RESISTANCE TO
SOLDERING HEAT
MIL-STD-202, METHOD 210, TEST CONDITION B
HUMIDITY
85% RELATIVE HUMIDITY AT 85° C 250 HOURS
tf
tr
VCC
MECHANICAL
"1" LEVEL
+4.5 VDC
1/2 VCC
+2.5 VDC
"0" LEVEL
+0.5 VDC
0 VDC
GROSS LEAK TEST
MIL-STD-883, METHOD 1014, TEST CONDITION C
FINE LEAK TEST
MIL-STD-883, METHOD 1014, TEST CONDITION A
TERMINAL STRENGTH
MIL-STD-202, METHOD 211, TEST CONDITION A AND C
MARKING INK
EPOXY, HEAT CURED.
t
T
MOISTURE RESISTANCE MIL-STD 202, METHOD 106, OMIT STEP 7B
SOLDERABILITY
MIL-STD-202, METHOD 208, 95% COVERAGE
SOLVENT RESISTANCE
MIL-STD-202, METHOD 2002, METHOD 215
PART NUMBERING SYSTEM
SERIES
CO6
CO12
(14 PIN DIP)
(8 PIN DIP)
FREQUENCY
STA BIL ITY
10 0
±1 00 PPM
05 0
± 50 PPM
02 5
± 25 PPM
EXTENDED
TEMPERA TURE
FREQUENCY
-
IN MHz
S YMMETRY
-
EXT
EXAMPLE: CO6100-10.000-EXT-T, CO12050-32.000-EXT-T-TR
OPTIONS
-
T TIGHT SY MMETRY
TR TA PE A ND REEL *
GW GULL WING
3. 3 +3 .3 V
* Available for Gull Wing only
Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A.
Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com
THROUGH HOLE CLOCK OSCILLATORS - HCMOS COMPATIBLE
SERIES CO6 AND CO12
TEST CIRCUIT
FREQUENCY
STANDARD
FREQUENCY
COUNTER
OSCILLOSCOPE
A
14 (8)
VDD
POWER
SUPPLY
-
.01 µF
+
V
8 (5)
OUT
CLOCK
OSCILLATOR
N/C
1
CL
GND
7 (4)
DIMENSIONS
CO6 PACKAGE (FULL SIZE 14 PIN DIP)
COLORED DOT
INDICATES
PIN 1 LOCATION
Scal e non e D ime nsio n i n
mm
i nch
CO12 PACKAGE (HALF SIZE 8 PIN DIP)
Scale none Di mensi on in
mm
inch
MARKING
AREA
MARKING
AREA
PIN 14
12.19
.787 ± .076
5.08 MAX
.031 ± .003
6.35 MIN
.250 MIN
PIN 4
PIN 8
.480
20.80 MAX
13.21 MAX
.520 MAX
7.62 ± .13
.300 ± .005
PIN 1
7.62 ± .13
4.57
7 .62 ± .1 3
.300 ± .005
PIN 7
.180
.519 MAX
0.45 ± .076 DIA
.018 ± .003 DIA
.300 ± .005
.600 ± .005
PIN 1
.200 MAX
.018 ± .003 DIA
15.24 ± .13
13.20 MAX
.031 ± .003
0.46 ± .08 DIA
6.35 MIN
.250 MIN
5.08 MAX
.200 MAX
0.79 ± .08
PIN 1 LOCATION
PIN 8
13.21 MAX
.520 MAX
PIN 5
.819 MAX
PIN CONNECTION
PIN CONNECTION
PIN
FUNCTION
1
N/C
GROUND
4
GROUND
OUTPUT
5
OUTPUT
VCC
8
VCC
PIN
FUNCTION
1
N/C
7
8
14
NOTE: PIN 7 IS INTERNAL
TO HEADER
NOTE: PIN 4 IS INTERNAL
TO HEADER
PACKAGING
14 PIN DIP: 25 PIECES PER ELECTROSTATIC TUBE
8 PIN DIP: 40 PIECES PER ELECTROSTATIC TUBE
Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A.
Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com
Similar pages