Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 3A FAST EFFICIENT RECTIFIER FE30-005 THRU FE30-08 FEATURES z LOW POWER LOSS, HIGH EFFICIENCY z LOW LEAKAGE z LOW FORWARD VOLTAGE DROP z HIGH CURRENT CAPABILITY z HIGH SPEED SWITCHING z HIGH RELIABILITY z HIGH CURRENT SURGE z GLASS PASSIVATED CHIP JUNCTION 1.0(25.4) MIN .052(1.3) .048(1.2) .375(9.5) .335(8.5) .220(5.6) .197(5.0) MECHANICAL DATA z CASE: MOLDED PLASTIC, DO201AD, DIMENSIONS IN INCHES AND (MILLIMETERS) z EPOXY: UL 94V-0 RATE FLAME RETARDANT z LEAD: MIL-STD-202E METHOD 208C GUARANTEED z MOUNTING POSITION: ANY z WEIGHT: 1.20 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% FE30 FE30 FE30 FE30 FE30 FE30 FE30 FE30 FE30 UNITS RATINGS SYMBOL -005 -01 -015 -02 -03 -04 -05 -06 -08 MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 150 200 300 400 500 600 800 V MAXIMUM RMS VOLTAGE VRMS 35 70 105 140 210 280 350 420 560 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 150 200 300 400 500 600 800 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 3.0 A 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 60 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 70 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 30 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL FE30 -005 FE30 FE30 -01 -015 0.98 FE30 -02 FE30 FE30 -03 -04 1.25 FE30 FE30 -05 -06 1.85 FE30 UNITS -08 2.60 V MAXIMUM FORWARD VOLTAGE AT IO DC VF MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 50 μA 25 nS MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20×20×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FE30-005 THRU FE30-08 Page: 1 RATINGS AND CHARACTERISTIC CURVE FE30-005 THRU FE30-08 FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC FIG. 2-TYPICAL FORWARD CURRENT DERATING CURVE Trr 50Ω NO INDUCTIVE 100Ω NO INDUCTIVE +0.5A D.U.T. 0 PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) OSCILLOSCOPE ( NOTE 1 ) 6 5 4 3 2 1 0 AVERAGE FORWARD CURRENT (A) (-) -0.25A (+) -1.0A 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (oC) 1cm NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS SET TIME BASE FOR 10/20 ns/cm FIG. 4-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT (A) 100 100 10 10 TJ=125oC 1 1.0 TJ=80oC 0.1 0.1 TJ=25oC .01 0.01 20 40 10.0 FE30-005~30-02 1.0 FE30-03~30-04 .1 .01 FE30-06 .001 .4 60 80 100 120 140 .6 .8 1.0 1.2 1.4 1.6 1.8 2.0 INSTANTANEOUS FORWARD VOLTAGE (V) PERCENT OF RATED PEAK REVERSE VOLTAGE (%) FIG. 6-TYPICAL JUNCTION CAPACITANCE FIG. 5-MAXIMUN NON-REPETITIVE FORWARD SURGE CURRENT 200 70 8.3 ms Single Half Sine Wave (JEDEC Method) 60 50 40 30 20 10 100 JUNCTION CAPACITANCE (pF) PEAK FORWARD SURGE CURRENT (A) INSTANTANEOUS REVERSE CURRENT (uA) FIG. 3-TYPICAL REVERSE CHARACTERISTICS 1000 1000 Single Phase Half Wave 60 Hz Resistive or Inductive Load 40 TJ=25oC 20 10 6 4 2 1 0 1 5 10 20 50 NUMBER OF CYCLES AT 60 Hz FE30-005 THRU FE30-08 100 .1 .2 .4 1.0 2 4 10 20 40 100 REVERSE VOLTAGE (V) Page: 2