Xeon 1 Power Warm White LED OSM5XME1C1E VER C.0 ■Features ■Outline Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Anode(+) 1.15 ● Dimension 3.6 2.0 Cathode(-) BackView ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext 0.1 (Ta=25℃) 1.05 ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Directivity Value Unit DC Forward Current IF 400 mA Pulse Forward Current* IFP 500 mA Reverse Voltage VR 5 V Power Dissipation PD 1600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 0 Duty ratio max 1/10 ■Forward Operating Current (DC) (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=350mA 3.0 3.3 4.0 V DC Reverse Current IR VR=5V - - 10 µA Luminous Flux Φv IF=350mA 90 100 - lm Color Temperature CCT IF=350mA - 3000 - K Chromaticity x IF=350mA - 0.45 - - Coordinates* y IF=350mA - 0.41 - - 2θ1/2 IF=350mA - 120 - deg 400 Forward Current, IF (mA) ■Electrical -Optical Characteristics 50% Power Angle 0.2 14.5 Symbol *Pulse width Max.10ms Cathode 5.3 Anode ■Absolute Maximum Rating Item 2.75 5.0 350 300 250 200 150 100 50 RJ-A=60℃/W RJ-A=50℃/W RJ-A=40℃/W RJ-A=30℃/W 0 0 25 50 100 75 Ambient Temperature, TA (℃) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 125 Xeon 1 Power Warm White LED OSM5XME1C1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER C.0