ILPA75VW SERIES 75W Water-Proof Constant Voltage LED Driver – – – – – – – 3 Year Warranty Wide Input Voltage 90 to 264VAC, 47 to 63Hz Constant Output Voltage Available From 12VDC Thru 105VDC Over Voltage, Over Current, Short Circuit, Lighting, and Over Temperature Protection High Efficiency (up to 93%) Active Power Factor Correction (PFC) (99% typical) IP67 Waterproof Rating, Metal Housing Comply with UL8750 & EN61347 Safety Regulation (Pending) Approvals: Single Output Part Number Output Voltage ILPA75VW-S012ST ILPA75VW-S024ST ILPA75VW-S036ST ILPA75VW-S042ST ILPA75VW-S048ST ILPA75VW-S054ST ILPA75VW-S081ST ILPA75VW-S105ST 12 VDC 24 VDC 36 VDC 42 VDC 48 VDC 54 VDC 81 VDC 105 VDC Max. Output Current 6.25 A 3.13 A 2.08 A 1.79 A 1.56 A 1.39 A 0.93 A 0.71 A Efficiency (220VAC, Full Load) 91% 92% 92% 92% 92% 93% 93% 93% Over Voltage Protection 16V 33V 45V 50V 58V 63V 90V 120V Max. Output Power 75W 75W 75W 75W 75W 75W 75W 75W Electrical Characteristics Parameter Input Voltage Input Frequency Output Power Range Input Current (Low Line) Input Current (High Line) High Line Inrush Current Power Factor Correction Power Factor Correction Efficiency No-Load Power Consumption Line Regulation Load Regulation Over Voltage Protection Over Current Protection Over Temperature Protection Short Circuit Protection Output Overshoot / Undershoot Start Up Time Ripple & Noise (Peak to Peak) Test Conditions Operating Voltage Min. 90 47 0 Typ. Max. 264 63 75 0.9 0.45 50 Unit VAC Hz W A A A % % % W % % Vin=90 to 264VAC Io=Full load, Vin=115VAC Io=Full load, Vin=230VAC Io=Full load, 25°C, Cool start, Vin=230VAC Vin=110VAC 99 Vin=220VAC 95 Io=Full Load, Vin=230VAC 93 No Load, VIn=230VAC 1.5 Io=Full Load 1 Vin=230VAC 2 Latch mode. The power unit shall return to normal operation only after the power is turn-on again. (Please refer to output table.) 135 % Io 110 °C No damage shall occur when any output operating in a short circuit condition. The power supply shall be self-recovery when the fault condition is removed. When power on or off 10 % Io=Full Load, Vin=100VAC 3 S Measured by 20 MHz bandwidth oscilloscope and the output paralleled a 0.1 uF ceramic capacitor and a 10 2 % Vo uF electrolytic capacitor. Conditions Parameter Test Conditions Min. Operating Temperature Storage Temperature Relative Humidity Operation temperature at 25°C, calculated per MIL-HDBK-217F Life Time at 25°C ambient temperature No output power derating from -35°C to 70°C -35 -40 5 0.45M 0.1M Typ. Max. Unit 70 85 95 °C °C % Hours Hours Approvals and Compliance Parameter EMI EMS Safety UL/c-UL, T-mark, CE Environmental Compliance Waterproof Standards EN55015 EN61000-3-2, EN61000-3-3, EN61000-4-2, EN61000-4.3, , EN61000-4-4, , EN61000-4-5, EN61000-4-6, EN61000-4-8, EN61000-4-1-1, EN61547 UL8750 Compliant to UL1310 Class 2, UL1012, UL935, CSA-C22.2 No. 0, CSA-C22.2 No. 107.1, CSA-C22.2 No.250.0, EN61347-1,EN61347-2-13 RoHS IP67 Rating Mechanical Parameter Dimension, Net Weight Input Electric Wire Output Electric Wire Specification 184x67.5x37mm (7.24x2.66x1.46 inches), 950g approx. 650mm, Black(ACL), White(ACN), Green(GND) 220mm, Red(V+), Black(V-)