H HiTRON UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 175 WATTS CURRENT SHARING SWITCHING POWER SUPPLIES HAC175P & HAC175D SERIES FEATURES: 175W IN 3U X 8HP EUROCARD PACKAGE UNIVERSAL AC INPUT WITH PFC INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE DROOP CURRENT SHARING EMI MEET EN 55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: Typ. 90-264Vac with PFC. Power Factor Correction: Meet Harmonic Correction IEC 61000-3-2. Power Factor typ. 0.98. Input Connector: PCIH47M400A1 for HAC175P. DIN41612 M24/8 for HAC175D. Input Frequency: 47-63Hz. Inrush Current: < 30A @ 230Vac by adding thermistor. Input Current: 2.2A @115Vac/1.1A @230Vac for HAC175D. 2.4A @115Vac/1.2A @230Vac for HAC175P. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet EN 55022 / FCC Class A. Hold-up Time: 5mS @115V & 230Vac after power fail signal. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: <Green> means valid input voltage. <Amber> means a critical fault. Thermal Protection: Installed NTC for thermal sensor at [DEG#] pin. Earth Leakage: Less than 0.5mA @230Vac. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 175W continuous. Output Connector: PCIH47M400A1 for HAC175P. DIN41612 M24/8 for HAC175D. Line Regulation: Typ. 0.5%. Load Regulation: VO1 & VO2 typ. ±1.0%. VO3 & VO4 typ. ±2.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV, whichever is greater. OVP: Built-in at VO1 & VO2. Adjustability: Available at VO1 & VO2. VO3 factory set. Remote Sensing: Available at VO1 & VO2. Hot-Swap: Available. N+1 Redundancy: Installed with OR-ing diodes for N+1 redundancy operation. Current Sharing: Droop current sharing at all output. Power OK Signal: Available for VO1 & VO2. Over Current Protection (OCP): Installed in all outputs. Overload Protection (OLP): Fully protected against output overload and short circuit. Consult factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 75-78%. Switching Frequency: 100 KHz. Circuit Topology: Half-bridge circuit. Transient Response: Typ. 1.0mS for a 25% load change. Safety Standard: IEC 60950-1/UL 60950-1 Class I. Construction: Eurocard 3U x 8HP x 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50°C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40°C to +85°C. Temperature Coefficient: Typ. ±0.02% /°C. Cooling: At least 20cfm (600lfm) airflow is required to deliver full rating load. Power Density: 3.2 Watts /Cubic Inch. Note: Due to requests in market and advances in technology, specifications subject to change without notification. For the details of safety approval, please consult the factory. -1- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @ Min. Typ. Volt. HAC175P-490(E) 0.0A 20A +5V HAC175P-490(O) 0.0A 20A +5V HAC175D-490(O) 0.0A 20A +5V MODEL NO. #=⊙ Max. 35A 35A 35A AUX. +VO2 ▲ #=⊙@ AUX. +VO3▲=⊙ (@) Typ. Max. Typ. Volt. Max. Peak Volt. 10A +3.3V 20A 3.0A +12V # 5.0A 6A 10A +3.3V 20A 3.0A +12V # 5.0A 6A 10A +3.3V 20A 3.0A +12V 5.0A 6A AUX. -VO4 ● =⊙ Typ. Volt. Max. Peak 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A Symbol: " " OVP built-in. "@" Adjustable. "(@)" Adjustable factory set.. "#" Remote sensing. "=" Droop Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post Regulator. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 666.0g (23.5 Oz.) INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT ASSIGNMENT AC-L AC-N AC-GND VO1 VO1 S + VO1 S VO2 VO2 S+ VO3 VO3 S+ VO4 HAC175P-490(E) DC COM EN# DEG # INH # FAL # PIN NO. 47 46 45 1,2,3,4. 30 34 13, 14, 15, 16, 17, 18. 33 20 36 21 5, 6, 7, 8, 9, 10, 11, 12, 19 ,24. 27 38 39 42 Mating connector: PCIH47F400A1 HAC175P-490(O) HAC175P INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT ASSIGNMENT AC-L AC-N AC-GND VO1 VO1 S + VO1 S VO2 VO2 S+ VO3 VO4 DC COM EN# DEG # INH # FAL # HAC175D-490(O) PIN NO. B2 B5 B11 B22 A17 A16 B13,14,15,16, 17,18. A18 B19 B20 B25 C13 C14 A14 C15 Mating connector: DIN 41612 M24/8-F HAC175D -2-