PC PSU FSP450-60APN(85) DESCRIPTION This specification describes a 450 watts power supply. With +5V stand-by, second 12V rail and remote ON/OFF control for ATX-12V system and a “Power factor collector (PFC )” circuit to meet EPA requirement of input range with in 230V/50Hz. APPLICATION Desktop W ATTAGE Wattage: 450W SAFETY STANDARD APPAOVAL 140mm(L) x 150mm(W) x 86mm(H) GENERAL SPECIFICATION Bronze <0.5W 230V Efficiency: Bronze PWOK Delay Time: 500ms > PWOK > 100ms EMC Performance: EN55022 class B EN55024 EN 61000-3-2 EN 61000-3-3 DIMENSION Dimension: PRODUCT HIGHLIGHT Efficiency Level: Erp Lot: Input Voltage: INPUT SPECIFICATION Input Range: Input Frequency: Input Current: 200-240 Vac 47-63 Hz 3.5Amp (maximum) at 230 Vrms/ 50 Hz. . ENVIRONMENTAL SPECIFICATION TEMP.Range: MTBF: OUTPUT SPECIFICATION Output Rise Time: +3.3V 20mS (maximum) +5V 20mS (maximum) +12 V1 20mS (maximum) +12 V2 20mS (maximum) -12 V 20mS (maximum) *Output Voltage and C urrent Rating +3.3V Ripple-Noise(R-P) mV 50mV Regulation Load % ±5% Output Max.(A) 24A Output Min.(A) 0.5A +5V 50mV ±5% 15A 0.3A Storage Temperature: -40°C to + 70℃ The power supply reliability, when calculated by “Bellcore” latest revision are exceed 100,000 hours with all output at maximum load and an ambient temperature of 25℃. The special requirement is for cooling fan that MTTF be guarantee over 30,000 hours at 25℃ ambient temperature. +12V1 5mV ±5% 18A 0.5A +12V2 120mV ±5% 18A 0.5A NOTES +3.3V & +5V total output not exceed 120W. When +5V is load to 15A, the +3.3V maximum load is 13.63A. When +3.3V is load to 24A, the +5V maximum load is 8A. +12V1 & +12V2 total output not exceed 360W This content is subject to change, please refer to specification for m ore detail. FSP reserve the right to change the content without prior notice -12V 200mV ±10% 0.3A 0A +5Vsb 50mV ±5% 2.5A 0A