DR200G - DR210G GLASS PASSIVATED JUNCTION SILICON RECTIFIERS PRV : 50 - 1000 Volts Io : 2.0 Amperes D2 FEATURES : * * * * * Glass passivated chip High current capability High reliability Low reverse current Low forward voltage drop 1.00 (25.4) MIN. 0.161 (4.10) 0.154 (3.90) 0.284 (7.20) 0.268 (6.84) MECHANICAL DATA : * Case : D2 Molded plastic * Epoxy : UL94V-O rate flame retardant * Lead : Axial lead solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.465 gram 1.00 (25.4) MIN. 0.034 (0.86) 0.028 (0.71) Dimensions in inches and ( millimeters ) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. RATING SYMBOL DR DR DR DR DR DR DR 200G 201G 202G 204G 206G 208G 210G 50 100 200 400 600 800 1000 UNIT Maximum Repetitive Peak Reverse Voltage VRRM Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average Forward Current 0.375"(9.5mm) Lead Length Ta = 50 °C IF(AV) 2.0 Amps. IFSM 50 Amps. Peak Forward Surge Current 8.3ms Single half sine wave Superimposed on rated load (JEDEC Method) Maximum Forward Voltage at IF = 2.0 Amps. VF 1.0 Volts Maximum DC Reverse Current Ta = 25 °C IR 5.0 µA at rated DC Blocking Voltage Ta = 100 °C IR(H) 50 µA Typical Junction Capacitance (Note1) CJ 75 pF Typical Thermal Resistance (Note2) RθJA 20 °C/W Junction Temperature Range TJ - 65 to + 175 °C Storage Temperature Range TSTG - 65 to + 175 °C Notes : (1) Measured at 1.0 MHz and applied reverse voltage of 4.0V DC (2) Thermal resistance from Junction to Ambient at 0.375" (9.5mm) Lead Lengths, P.C. Board Mounted. UPDATE : MAY 27, 1998 RATING AND CHARACTERISTIC CURVES ( DR200G - DR210G ) FIG.2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 50 2.0 PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD OUTPUT CURRENT, AMPERES FIG.1 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT 1.6 1.2 0.8 0.4 8.3 ms SINGLE HALF SINE WAVE 40 30 Ta = 50 °C 20 10 RESISTIVE OR INDUCTIVE LOAD 0 0 25 50 75 100 125 150 0 175 1 AMBIENT TEMPERATURE, ( °C) FORWARD CURRENT, AMPERES 100 10 1.0 Pulse Width = 300 µs 2% Duty Cycle REVERSE CURRENT, MICROAMPERES FIG.3 - TYPICAL FORWARD CHARACTERISTICS 0.1 2 4 6 10 20 40 60 FIG.4 - TYPICAL REVERSE CHARACTERISTICS 10 TJ = 100 °C 1.0 0.1 TJ = 25 °C 0.01 0 20 40 60 80 100 120 TJ = 25 °C PERCENT OF RATED REVERSE VOLTAGE, (%) 0.01 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 100 NUMBER OF CYCLES AT 60Hz 1.3 FORWARD VOLTAGE, VOLTS 1.4 140