BOARDCOM BCM8705LAKFBG Serial 10-gbe/fibre channel transceiver with wis layer and xauiâ ¢ interface Datasheet

BCM8705
®
SERIAL 10-GBE/FIBRE CHANNEL TRANSCEIVER WITH WIS LAYER AND
XAUI™ INTERFACE
SUMMARY OF BENEFITS
FEATURES
• Fully integrated CMU, CDR, SerDes, limiting amplifier,
EyeOpener®, and 4-lane XAUI™ interface
• PMD interface supported serial rates: 9.953/10.3125/
10.5188-Gbps
• Receive equalization on XAUI and 10G serial interfaces
• Transmit pre-emphasis and amplitude control on XAUI interface
• 10G PMD interface phase and decision threshold adjust
• WIS layer for EOS/WAN applications
• SONET performance monitoring
• Supports Broadcom’s StrataXGS® Ethernet switches service
aware flow control (SAFC) protocol
SONET) application
• Universal design for 10-GbE, SONET, and 10 GFC for
XENPAK/X2 module
• Compliant to XENPAK/X2 3.0 and XPAK MSA optical
module standards
• Integrated and compact design allows for high-density line
card applications
• Upgrade path for existing Broadcom LAN PHY transceivers
• Build-in features reduce external components
• Meets and exceeds industry standard
• IEEE 802.3™ae serial Ethernet transceiver (LAN/WAN PHY),
MDIO Clause 45 management interface with extended indirect
address register access
• 10-Gigabit Fibre Channel draft, rev 3.0
• Support for XFP/XFI interfaces
• Support for XENPAK/X2 3.0 and XPAK MSA optical module
standards
• Additional features
•
•
•
•
•
•
• Best performance for LAN (10-GbE) and WAN (OC-192
• Clean-up PLL
• 2.5V voltage regulator output
• In-rush current limits
APPLICATIONS
• XENPAK, X2, XPAK modules
Jumbo packets support in WAN mode
Reference clock output for XFP module reference clock
I2C master to control XFP module from device
Staged power-up mode to minimize in-rush current
Loopback modes supporting IEEE standards modes
Built-in self-test (BIST) and PRBS generator/checker
• Interface to XFP modules
• LAN/MAN/WAN switch/routers
• Pin-compatible with the BCM8704
• Low power: LAN mode 900 mW, WAN mode 1.0W to 1.1W
• Available in 13-mm x 13-mm and 17-mm x 17-mm plastic BGA
• Hubs and repeaters
• Network interface cards (NICs)
(Pb-free version also available)
BCM8705 Block Diagram
XAUI
BCM8705
MAC
MDC MDIO
Management
Interface
9.953/10.3125/10.5188
Gbps
WIS
XGXS
Media
Access
Controller
Interface
PCS/PMA
RS
XGXS
OTX
ORX
Optical
PMD
EEPROM
OVERVIEW
System/MAC Interface
XAUI
outputs
X[A:D]OP/N
Differential CML
XAUI
inputs
X[A:D]IP/N
AC-coupled
internally biased
differential CML
Line/Fiber-Optic Module Interface
AC-coupled
internally biased
differential CML
PPDOUT
PCOP/N
Differential CML
XPDOUT
External VCXO
PEXTCLKP/N
XEXTCLKP/N
PVCOXP/N
PDOP/N
AC-coupled
internally biased
differential LVPECL
SYSRSTB
RSTB
MDC
MDIO
PRTAD[4:0]
Control
and
Status
PLOSB/A1
PMD Analog
XAUI
CMOS
LASI
TXONOFF
JTAG
TRSTB
JTCK
TMS
TDI
TDO
10G Serial
Outputs
CDR Loop
Filter
PMD
2WENB
CONFIG[1:0]
SDA
SCL
VCPCDR
VCNCDR
10G Serial
Inputs
CMOS
PCDRLK
PCMULK
REFCLKOUT
2-Wire
interface
PDIP/N
CMOS
OPTXENB0/1
OPTXRST0/1
OPRXLOS
OPBIASFLT
OPTMPFLT
OPPWFLT
OPTXFLT
OPRXFLT
OPOUTLVL
OPINLVL
Optics
Control
and
Status
BCM8705 Fully Integrated Interface
The BCM8705 Ethernet/Fibre Channel/SONET LAN/WAN PHY is a
fully integrated serialization/deserialization (9.953/10.3125/
10.5188-Gbps) interface device performing the extension functions for a
10-gigabit serial Ethernet reconciliation sublayer (RS) interface. The
XGXS, PCS, and PMA functions include 8B/10B coding, 64B/66B
coding, SerDes, WIS, clock multiplication unit (CMU), and clock and
data recovery (CDR).
On-chip clock synthesis is performed by the high-frequency low-jitter
phase-locked loops for the PMD and XAUI output retimers. Individual
PMD and XAUI clock recovery is performed on the device by
synchronizing directly to their respective incoming data streams. Elastic
buffers are provided to allow the XAUI and PMD interfaces to operate
in asynchronous configuration. Only an external 155.52/156.25/
159.38-MHz oscillator is required for the reference clock input.
For WAN applications, a WIS-compliant framer with flexible clocking
modes allows transmission of Ethernet traffic over a WAN network.
The BCM8705 is available in a 13-mm × 13-mm, 256-pin FBGA with a
0.8-mm ball pitch and also in a 17-mm x 17-mm, 256-pin 1-mm ball
pitch RoHS-compliant package.
Broadcom®, the pulse logo, Connecting everything®, the Connecting everything logo, EyeOpener®,
and StrataXGS® are among the trademarks of Broadcom Corporation and/or its affiliates in the United
States, certain other countries and/or the EU. Any other trademarks or trade names mentioned are the
property of their respective owners.
®
BROADCOM CORPORATION
16215 Alton Parkway, P.O. Box 57013
Irvine, California 92619-7013
© 2006 by BROADCOM CORPORATION. All rights reserved.
8705-PB02-R
04/17/06
Phone: 949-450-8700
Fax: 949-450-8710
E-mail: [email protected]
Web: www.broadcom.com
Similar pages