I3DB16F84AR1 I3DB18F1320R1 ICEPIC 3 Daughterboards Introduction Many thanks for purchasing this ICEPIC3 daughterboard. The ICEPIC 3 manual is supplied in electronic format on the CD supplied with the In-Circuit Emulator. Current revisions of the manual can also be downloaded from the RF solutions website. Installation of Daughter Board 1. Installation of a daughter board is a simple push fit onto the topside of the ICEPIC3 motherboard, connecting only by the two connectors. It is only possible to fit the daughter board in a single orientation. 2. Ensure the Target header cables are securely inserted. Jumper Link Configuration There are several Jumper Links, which are used to configure your daughter board. These are all fitted to factory default settings during manufacture. A jumper link guide is installed along with the ICEPIC III software. This can be accessed from the windows start menu, Start -> Programs -> ICEPIC III -> ‘Jumper Links.pdf’ Target Board Connectors The daughterboard target board connectors are for use with the packages given in the table below. Daughterboard Connector Target Board Package P4 20 Pin SOIC P8 18 Pin DIP P3 20 Pin SOIC P4 18 Pin DIP I3DB16F84AR1 I3DB18F1320R1 Warning Extra care is therefore advised when handling the ICEPIC system, in particular the ICEPIC Daughterboards. Always apply Power to the ICEPIC pod BEFORE the target board and remove power from the ICEPIC after the target board. Care must be taken to avoid exposing the Target probe cable to any excessive static or reverse voltage.The Microchip emulation devices (16C01/3, 16CXXME etc) do not contain the same high voltage protection on their I/O lines as the standard PIC Microcontrollers. R. F. Solutions Ltd., Unit 21, Cliffe Industrial Estate, South Street, Lewes, E. Sussex, BN8 6JL. England Tel +44 (0)1273 898 000 Email [email protected] Fax +44 (0)1273 480 661 http://www.rfsolutions.co.uk RF Solutions is a member of the Low Power Radio Association All Trademarks acknowledged and remain the property of the respected owners Information contained in this document is believed to be accurate, however no representation or warranty is given and R.F. Solutions Ltd. assumes no liability with respect to the accuracy of such information. Use of R.F.Solutions products as critical components in life support systems is not authorised except with express written approval from R.F.Solutions Ltd. DS058-1 Dec ’04 ©2004 RF Solutions Ltd, www.rfsolutions.co.uk Tel 01273 898000 Fax 01273 480661 Page 1