MOTOROLA MOC217 Small outline optoisolators transistor output Datasheet

Order this document
by MOC215/D
SEMICONDUCTOR TECHNICAL DATA
[CTR = 20% Min]
Transistor Output (Low Input Current)
[CTR = 50% Min]
These devices consist of a gallium arsenide infrared emitting diode optically
coupled to a monolithic silicon phototransistor detector, in a surface mountable,
small outline, plastic package. They are ideally suited for high density
applications, and eliminate the need for through–the–board mounting.
[CTR = 100% Min]
• Convenient Plastic SOIC–8 Surface Mountable Package Style
Motorola Preferred Devices
• Low LED Input Current Required, for Easier Logic Interfacing
• Standard SOIC–8 Footprint, with 0.050″ Lead Spacing
• Shipped in Tape and Reel, which Conforms to EIA Standard RS481A
SMALL OUTLINE
OPTOISOLATORS
TRANSISTOR OUTPUT
• Compatible with Dual Wave, Vapor Phase and IR Reflow Soldering
• High Input–Output Isolation of 3000 Vac (rms) Guaranteed
• UL Recognized
File #E54915
Ordering Information:
• To obtain MOC215, 216, 217 in Tape and Reel, add R2 suffix to device numbers:
R2 = 2500 units on 13″ reel
• To obtain MOC215, 216, 217 in quantities of 50 (shipped in sleeves) — No Suffix
Marking Information:
• MOC215 = 215
• MOC216 = 216
• MOC217 = 217
Applications:
CASE 846–01, STYLE 1
PLASTIC
• Low power Logic Circuits
• Interfacing and coupling systems of different potentials and impedances
• Telecommunications equipment
• Portable electronics
SCHEMATIC
MAXIMUM RATINGS (TA = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
IF
60
mA
IF(pk)
1.0
A
Reverse Voltage
VR
6.0
V
LED Power Dissipation @ TA = 25°C
Derate above 25°C
PD
90
0.8
mW
mW/°C
Collector–Emitter Voltage
VCEO
30
V
Collector–Base Voltage
VCBO
70
V
Emitter–Collector Voltage
VECO
7.0
V
Collector Current — Continuous
IC
150
mA
Detector Power Dissipation @ TA = 25°C
Derate above 25°C
PD
150
1.76
mW
mW/°C
INPUT LED
Forward Current — Continuous
Forward Current — Peak (PW = 100 µs, 120 pps)
OUTPUT TRANSISTOR
1
8
2
7
3
6
4
5
1.
2.
3.
4.
5.
6.
7.
8.
LED ANODE
LED CATHODE
NO CONNECTION
NO CONNECTION
EMITTER
COLLECTOR
BASE
NO CONNECTION
NOTE: Thickness through insulation between input and output is ≥ 0.5 mm.
Preferred devices are Motorola recommended choices for future use and best overall value.
REV 1
Optoelectronics
Device Data
Motorola
Motorola, Inc.
1995
1
MAXIMUM RATINGS — continued (TA = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
VISO
3000
Vac(rms)
Total Device Power Dissipation @ TA = 25°C
Derate above 25°C
PD
250
2.94
mW
mW/°C
Ambient Operating Temperature Range(3)
Storage Temperature Range(3)
TA
Tstg
—
–55 to +100
°C
–55 to +150
°C
260
°C
TOTAL DEVICE
Input–Output Isolation Voltage(1,2)
(60 Hz, 1.0 sec. duration)
Lead Soldering Temperature (1/16″ from case, 10 sec. duration)
ELECTRICAL CHARACTERISTICS (TA = 25°C unless otherwise noted)(4)
Symbol
Min
Typ(4)
Max
Unit
—
1.05
1.3
V
Reverse Leakage Current (VR = 6.0 V)
VF
IR
—
0.1
100
mA
Capacitance
C
—
18
—
pF
ICEO1
ICEO2
—
1.0
50
nA
—
1.0
—
µA
V(BR)CEO
V(BR)ECO
30
90
—
V
7.0
7.8
—
V
CCE
—
7.0
—
pF
IC (CTR)(5)
200 (20)
500 (50)
1.0 (100)
500(50)
800 (80)
1.3 (130)
—
—
—
µA (%)
µA (%)
mA (%)
VCE(sat)
ton
—
0.35
0.4
V
—
7.5
—
µs
—
5.7
—
µs
Rise Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω)
toff
tr
—
3.2
—
µs
Fall Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω)
tf
—
4.7
—
µs
VISO
RISO
CISO
3000
1011
—
—
Vac(rms)
—
—
Ω
—
0.2
—
pF
Characteristic
INPUT LED
Forward Voltage (IF = 1.0 mA)
OUTPUT TRANSISTOR
Collector–Emitter Dark Current
(VCE = 5.0 V, TA = 25°C)
(VCE = 5.0 V, TA = 100°C)
Collector–Emitter Breakdown Voltage (IC = 100 µA)
Emitter–Collector Breakdown Voltage (IE = 100 µA)
Collector–Emitter Capacitance (f = 1.0 MHz, VCE = 0)
COUPLED
Output Collector Current
(IF = 1.0 mA, VCE = 5.0 V)
MOC215
MOC216
MOC217
Collector–Emitter Saturation Voltage (IC = 100 µA, IF = 1.0 mA)
Turn–On Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω)
Turn–Off Time (IC = 2.0 mA, VCC = 10 V, RL = 100 Ω)
Input–Output Isolation Voltage (f = 60 Hz, t = 1.0 sec.)(1,2)
Isolation Resistance (VI–O = 500 V)(2)
Isolation Capacitance (VI–O = 0, f = 1.0 MHz)(2)
1.
2.
3.
4.
5.
2
Input–Output Isolation Voltage, VISO, is an internal device dielectric breakdown rating.
For this test, pins 1 and 2 are common, and pins 5, 6 and 7 are common.
Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Always design to the specified minimum/maximum electrical limits (where applicable).
Current Transfer Ratio (CTR) = IC/IF x 100%.
Motorola Optoelectronics Device Data
IC, OUTPUT COLLECTOR CURRENT (NORMALIZED)
TYPICAL CHARACTERISTICS
VF , FORWARD VOLTAGE (VOLTS)
2
PULSE ONLY
PULSE OR DC
1.8
1.6
1.4
TA = – 55°C
1.2
25°C
1
100°C
1
10
100
IF, LED FORWARD CURRENT (mA)
10
NORMALIZED TO:
IF = 1 mA
1
0.1
0.001
1000
IF = 1 mA
1.6
MOC217
1.4
1.2
1
MOC216
0.8
MOC215
0.6
0.4
0.2
ICEO, COLLECTOR–EMITTER DARK CURRENT
(NORMALIZED)
0
0
1
2
3
4
5
6
7
8
9
10
2
5
10
NORMALIZED TO:
TA = 25°C
1
0.1
–60
–40
–20
0
20
40
60
80
VCE, COLLECTOR–EMITTER VOLTAGE (VOLTS)
TA, AMBIENT TEMPERATURE (°C)
Figure 3. Output Current versus
Collector–Emitter Voltage
Figure 4. Output Current versus
Ambient Temperature
100
120
20
NORMALIZED TO:
VCE = 10 V
TA = 25°C
100
18
C, CAPACITANCE (pF)
I C, OUTPUT COLLECTOR CURRENT (mA)
2
1.8
0.1
0.2
0.5 1
IF, LED INPUT CURRENT (mA)
Figure 2. Output Current versus Input Current
I C, OUTPUT COLLECTOR CURRENT (NORMALIZED)
Figure 1. LED Forward Voltage versus Forward Current
0.05
10
VCE = 30 V
1
10 V
20
40
60
80
TA, AMBIENT TEMPERATURE (°C)
100
Figure 5. Dark Current versus Ambient Temperature
Motorola Optoelectronics Device Data
f = 1 MHz
14
12
10
8
CCE
6
4
0.1
0
CLED
16
2
0.01
0.1
1
10
100
V, VOLTAGE (VOLTS)
Figure 6. Capacitance versus Voltage
3
PACKAGE DIMENSIONS
–A–
8
5
K
1
4
D 8 PL
0.13 (0.005)
G
–T–
NOTES:
1. DIMENSIONING AND TOLERANCING PER ANSI
Y14.5M, 1982.
2. CONTROLLING DIMENSION: INCH.
B
SEATING
PLANE
M
T A
M
C
0.038 (0.0015)
H
J
DIM
A
B
C
D
G
H
J
K
INCHES
MIN
MAX
0.182
0.202
0.144
0.164
0.123
0.143
0.011
0.021
0.050 BSC
0.003
0.008
0.006
0.010
0.224
0.244
STYLE 1:
PIN 1.
2.
3.
4.
5.
6.
7.
8.
MILLIMETERS
MIN
MAX
4.63
5.13
3.66
4.16
3.13
3.63
0.28
0.53
1.27 BSC
0.08
0.20
0.16
0.25
5.69
6.19
ANODE
CATHODE
NC
NC
EMITTER
COLLECTOR
BASE
NC
CASE 846–01
ISSUE B
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit,
and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters can and do vary in different
applications. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does
not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in
systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of
the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such
unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless
against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death
associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part.
Motorola and
are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer.
How to reach us:
USA / EUROPE: Motorola Literature Distribution;
P.O. Box 20912; Phoenix, Arizona 85036. 1–800–441–2447
JAPAN: Nippon Motorola Ltd.; Tatsumi–SPD–JLDC, Toshikatsu Otsuki,
6F Seibu–Butsuryu–Center, 3–14–2 Tatsumi Koto–Ku, Tokyo 135, Japan. 03–3521–8315
MFAX: [email protected] – TOUCHTONE (602) 244–6609
INTERNET: http://Design–NET.com
HONG KONG: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park,
51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298
4
◊
*MOC215/D*
Motorola Optoelectronics Device
Data
MOC215/D
Similar pages