H HiTRON UNIVERSAL INPUT HARMONIC CORRECTION AC-DC N+1 REDUNDANCY AND ACTIVE CURRENT SHARING ENCLOSURE BOX SINGLE & MULTI-OUTPUT 400 WATTS INTERNAL SWITCHING POWER SUPPLIES HVP400 SERIES FEATURES: ACCOMMODATE UNIVERSAL AC SOURCES MEET IEC 61000-3-2 HARMONIC CORRECTION THIRD-WIRE CURRENT SHARING OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE MEET UNIVERSAL SAFETY STANDARDS EMI MEET EN 55022 CLASS B CE MARKING COMPLIANCE SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: Typ. 90-264Vac with PFC. Input Connector: IEC320-3P & On/Off Switch. Input Frequency: 47-63Hz. Inrush Current: ≤ 30A @230Vac by active inrush current limiter circuit. Input Current: 5.8A @ 115Vac, 2.6A @ 230Vac. Dielectric Withstand: Meet IEC 60950-1. EMI: Meet EN 55022 Class B. Hold-up Time: Typ. 7.2-12mS @ 115Vac and Typ. 35-42mS @ 230Vac. Power OK Signal: Available at VO1 & VO2. Power Factor Correction: Meet IEC 61000-3-2 Harmonic Correction. PF typ. 0.92-0.98. Over Temp. Protection: By thermostat. Power Disable: Pin P3-2/open=shut-down. Pin P3-2/short=Operation. Power On LED Indicator: Installed. Earth Leakage: Less than 0.5mA @230Vac. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Connector: B-S/S-T/Molex MLX5045. Output Wattage: Typ. 350-400 watts. Line Regulation: Typ. 0.1%. Load Regulation: Main VO1 typ. ±1.0%. Aux.VO2 typ. ±1-2% (Magnetic Amp.). Aux.VO3 typ. ±3.0% (Couple Common Choke). Noise & Ripple: Typ. 1.0% peak to peak. OVP: Built-in at main VO1. Remote Sense: Available at VO1 & VO2 rail. Redundancy: Available for N+1 redundancy operation for sharing the load. Current Sharing: 3rd-wire current sharing for VO1 & VO2 rails. OR-ing Diode: Installed in VO1,2,3. Adjustability: Available at VO1 & VO2. Output LED Indicator: Installed in VO1,2,3. Overload Protection (OLP): Fully protected against output overload and short circuit. Consult the factory for OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 65-70%. Switching Frequency: Fixed frequency at 56K Hz. Circuit Topology: PWM Fixed Frequency Forward Circuit. Transient Response: Output voltage returns in less than 3mS following a 25% load change. Safety Standard: UL 60950-1/EN 60950-1 Class I. Hot Swappable: Available. Power Density: 2.95 Watts / Cubic Inch. Operating Temperature: 0 to +50°C under 35 cfm forced air cooling for full load. Storage Temperature: -20 to +85 °C. Temperature Coefficient: Typ. 0.04% /°C. Cooling: At least required 35 cfm forced cooling air flow for full load operation. MTBF: 180,000 hours at full load and 25°C by MIL-HDBK-217F spec. Construction: Enclosure box. Note: Due to requests in market and advances in technology, specifications subject to change without notification. In application -63- OUTPUT VOLTAGE / CURRENT RATINGS CHART SINGLE OUTPUT MODEL NO. HVP400-S033850 HVP400-S050700 HVP400-S120300 HVP400-S150250 HVP400-S240160 HVP400-S280140 HVP400-S360110 HVP400-S480085 DUAL OUTPUT MAIN VO1 @★#≡⊙ Typ. Volt. 85.0A 3.3V 70.0A 5.0V 30.0A 12.0V 25.0A 15.0V 16.0A 24.0V 14.0A 28.0V 11.0A 36.0V 8.5A 48.0V MODEL NO. HVP400-D033E HVP400-D033I HVP400-D033K HVP400-D033M HVP400-D050I HVP400-D050K HVP400-D050M MAIN VO1 @★#≡⊙ Typ. Volt. 70.0A +3.3V 70.0A +3.3V 70.0A +3.3V 70.0A +3.3V 55.0A +5.0V 55.0A +5.0V 55.0A +5.0V AUX. VO2 @▲◇#≡⊙ Typ. Volt. 20.0A 5.0V 10.0A 12.0V 8.0A 15.0V 5.0A 24.0V 10.0A 12.0V 8.0A 15.0V 5.0A 24.0V TRIPLE OUTPUT MAIN VO1 @★#≡⊙ AUX. VO2 @▲◇#≡⊙ Typ. Typ. Volt. Volt. 70.0A 25.0A HVP400-T033EI +3.3V 5.0V 70.0A 10.0A HVP400-T033II +3.3V 12.0V 50.0A 25.0A HVP400-T050DI +5.0V 3.3V 50.0A 10.0A HVP400-T050II +5.0V 12.0V 50.0A 10.0A HVP400-T050IE +5.0V 12.0V 50.0A 5.0A HVP400-T050MI +5.0V 24.0V 50.0A 8.0A HVP400-T050KK +5.0V 15.0V MODEL NO. Symbol: "★" OVP built-in. "@" Adjustable. "◇" Floating(or isolated) output. "≡" Active current sharing. "▲" Installed with magnetic amplifier. "■" Couple common choke. MECHANICAL DIMENSIONS: MM [INCHES] AUX. VO3 ■◇⊙ Typ. Volt. 3.0A 12.0V 3.0A 12.0V 3.0A 12.0V 3.0A 12.0V 3.0A 5.0V 3.0A 12.0V 3.0A 15.0V "#" Remote sensing. "⊙" Installed with OR-ing diode. WEIGHT: 2,400.0g (85.0 Oz.) INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT AC INPUT ASSIGNMENT AC-L AC-N AC-G CNTR & PIN# L N G SINGLE O/P DUAL & TRIPLE O/P ASSORTED SIGNALS DCDCPower Power DC VO1 VO1 +VO2 -VO2 +VO3 -VO3 +VO1# -VO1# +VO1≡ -VO1≡ +VO2# -VO2# +VO2≡ -VO2≡ COM COM Good Disable COM P1P1P1-V1 P1-V1 P2-4 P2-3 P2-2 P2-1 P3-4 P3-6 P3-3 P3-5 P4-4 P4-3 P4-2 P4-5 P4-1 P3-2 P3-1 COM COM Mating connector: P1 &P2 No-needed. P3 & P4 Molex MLX5051. -64-