SL Power MINT1045 45 w single output sery Datasheet

MINT1045
45 W Single Output Series
Medical & ITE – Universal Input Power Supply
3 Year Warranty
•45 W Convection Cooled
•Universal Input 80--270 Vac
•Very Small Size: 2” W x 3” L x 1.0” H
•88% Efficiency Typical
•Class I or Class II AC Input Applications
rd
•CSA/EN/IEC/UL60601-1 3
Edition for Medical,
Type BF Capable, Ultra-low Leakage Current
nd
•CSA/EN/IEC/UL60950-1 2
Specifications
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
AC Input
100-240Vac +/- 10%, 47-63 Hz 1∅ rated
80-270 Vac, 47-440 Hz operational
0.75A @ 120 Vac, 0.45 A @ 240 Vac
Input Current
Inrush Current
37A max., 264 Vac
Input Fuses
F1, F2: 1.6A, 250Vac fuses provided internally
Power Factor
Complies with EN61000-3-2, Class A
Efficiency
Output Power
Edition for ITE
88% typical
45 W continuous. See chart for operation above 50°C
Peak Output Power
50 W for 1 minute, 10% duty cycle
Ripple and Noise
1% pk-pk max., 20 MHz BW, differential mode
Measured with noise probe directly across output terminals
Output Voltage
See chart
Voltage Adjustability
Not adjustable
Factory set with fixed resistors for higher reliability
Minimum Load
Not required
Total Regulation
Transient Response
Switching Frequency
See chart
500µs max. to 1%, 50% load step
0.2A/µs, 3.5% deviation. typical
Fixed 65 kHz, typical
Turn On Time
500 ms max at 120 Vac
Hold-up Time
25 ms minimum at 45 W, nominal input (120Vac)
Overvoltage Protection
120-150%, auto-reset
Overload Protection
Hiccup Mode, 58W typical
Short Circuit Protection
Hiccup Mode, 58W typical
Overtemperature Protection
Self-Recovering
Medical Safety Standards
CSA/EN/IEC/UL 60601-1, 3rd Edition
Methods Of Protection: 2 MOPP for Type BF Applications
ITE Safety Standards
CSA/EN/IEC/UL 60950-1, IEC 2nd Edition
See page 2 for detailed safety agency standards
Isolation
Input-Output: 4500Vac, Input-Ground: 1900Vac
Output-Ground: 1900Vac
Leakage Current
12V-28V models: 120Vac: 30µA NC/70µA SFC
264Vac: 75µA NC/130µA SFC
48V model: 120Vac: 90µA NC/120µA SFC
264Vac: 190µA NC/220µA SFC
Operating Temperature
-20° to 70°C
See derating chart
Output Power Derating
Derate output power by 2.5%
per °C above 50°C, up to 70°C max
Storage Temperature
-40 to +85°C
Relative Humidity
5% to 95%, non-condensing
MTBF
300K hours per Telcordia
Model Number Key
MINT 1 045 A 12 75 K 01
01 = Standard Model, 02 and higher indicates a m odified m odel.
"K" = Input Connector - 3 pin header
"75" = Output Connector - 4 pin header
Output Voltage: "12" = 12V output, "24" = 24V output, etc.
Model Configuration: "A" = Class I Input; "B" = Class II Input (no ground)
Output Pow er (Watts) - "045" = 45W
# of Outputs
Product Fam ily: "M" = Medical, "I" = Internal, "NT" = New Technology
______________________________________________________________________________________________________________________________ 1 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MINT1045
45 W Single Output Series
Medical & ITE – Universal Input Power Supply
3 Year Warranty
Output Parameters
Model
Number
Volts
Output
Current
Ripple
& Noise
Total
Regulation
Initial Set-point
Tolerance
±2%
MINT1045A1275K01
12 V
3.75
120mV
±0.5%
MINT1045A1575K01
15 V
3.00
150mV
±0.5%
±2%
MINT1045A2475K01
24 V
1.90
240mV
±0.5%
±2%
MINT1045A2875K01
28 V
1.60
280mV
MINT1045A4875K01
48 V
0.95
480mV
Notes:
1. Derate output power by 2% per volt AC for input voltage <90Vac.
±0.5%
±2%
±0.5%
±2%
Consult factory for availability
Specifications (continued)
Random vibration per MIL-STD-810E, Method 514.4,
Cat. 1, Figure 514.4-1, 1 hr in each of three axes
Enclosure Dimensions
See outline drawing
Vibration
Weight
113 grams
Shock
Operating Altitude
Half-sine, 40 gpk, 10 msec duration, +/- in
each of three axes, total of 6 shocks
-500 to 10,000 ft
Non-operating Altitude
-500 to 40,000 ft
EMI/EMC Compliance
Conducted Emissions
EN55011/22 Class B, FCC Part 15, Class B, 6db margin
Radiated Emissions
Static Discharge Immunity
EN55011/22 Class A, FCC Part 15, Class A, 10db margin
To meet class B for grounded input (Class I), unit should be
mounted on a metal plate.
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz.
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity
EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity Convection Cooled
EN61000-4-8, 3A/m
Voltage Dip Immunity
EN61000-4-11 100Vac, 95% dip/0.5 cycle (Criteria A),
60%/5cycles (Criteria A at 30% load), 30%/25 cycles (Criteria A).
Complies with EN61000-3-2, EN60601-2-1
Line Frequency Harmonics
Safety Agency Compliance
•
•
•
Medical Certification to the New 3rd Edition:
Demko certified to EN 60601-1:2005, 3rd Ed.
CB certified to IEC 60601-1:2005, 3rd Edition
UL Recognized to ANSI AAMI ES60601-1:2005
& CAN/CSA C22.2, No. 60601-1-08
ITE Certification to the New 2nd Edition:
• Demko certified to EN60950-1:2006+ A11:2009,2nd Ed.
• CB certified to IEC 60950-1:2005, 2nd Edition
• UL Recognized to UL 60950-1:2007, 2nd Edition &
CAN/CSA C22.2, No. 60950-1-07, 2nd Edition
______________________________________________________________________________________________________________________________ 2 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MINT1045
45 W Single Output Series
Medical & ITE – Universal Input Power Supply
3 Year Warranty
Outline Drawing
[4]
0.122
4 PLCS
MTG HOLES
Mating Connectors: J1 = AMP 640250-3, J2 = 640250-4,
Contacts = AMP 770461-1
Note: For Class II (No earth ground) applications, all mounting
hardware must be non-conductive.
Data Sheet © 2011 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 6-7-2011
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 3 of 3
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
Similar pages