AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier DESCRIPTION AA8632 is a dual video amplifier with 6db gain, 75Ω output buffer and SAG correction, and it supports 3V and 5V operation voltage. The 75Ω buffer is capable of driving two circuits. The SAG could reduce the output coupling capacitor. The power saving circuit provides the power saving function. The IC is available in 8-pin TSSOP (AA8632AP), 8-pin SOP (AA8632SP) and 8-pin DIP (AA8632PP) package. FEATURES APPLICATION 1. Composite video driver with 6dB gain 2. Support 3V and 5V operation voltage 3. Dual channels video amplifier 4. Output short circuit protection function 5. SAG correction function 6. A load sufficient for driving two circuits 7. Low operating current, 17mA typical 8. Internal voltage clamp circuit 9. TSSOP-8 (AA8632AP), SOP-8 (AA8632SP) and DIP-8 (AA8632PP) package ¾ VCR ¾ Video Camera ¾ TV ¾ Video Player 10. AC-Couple or DC-Couple output AA8632 BLOCK DIAGRAM Vcc Vin2 7 8 6dB 75Ω Amp CLAMP Driver 5 Vout2 6 Vsag2 4 Vout1 3 Vsag1 750Ω 2.2K 2.0K Vin1 1 6dB 75Ω Amp CLAMP Driver 750Ω 2.0K 2.2K 2 1 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier PIN DESCRIPTION Symbol Pin No Type Function Vin1 1 I Channel1 input terminal of 1V composite signal GND 2 - Ground Vsag1 3 O Channel 1 SAG correction output Vout1 4 O Channel 1 output Vout2 5 O Channel 2 output Vsag2 6 O Channel 2 SAG correction output VCC 7 - 3V or 5V power supply Vin2 8 I Channel 2 input terminal of 1V composite signal ABSOLUTE MAXIMUM RATING Ta = 25 ℃ Parameter Supply Voltage Operating Ambient Temperature Storage Temperature Symbol Rating MIN TYP Vcc -0.3 Ta Ts 3 MAX UNIT 7 V -40 85 ℃ -40 125 ℃ CONDITION NOTE : Stress above those listed under “Absolute Maximum Rating” may cause device permanent damage to the device. This stress-rating only factor and functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for an extended period of time may affect device reliability of the device. 2 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier ELECTRICAL CHARACTERISTICS Ta = 25℃ , Vcc = 5V Parameter Symbol Min Typ Max 17 20 Supply Current Icc Voltage Gain Gv 5.5 6 6.5 Frequency Characteristic GF -1 - 1 Clamp Voltage 1.9 2.1 2.3 Output DC level 1.0 1.2 1.4 35 45 SAG-Terminal Gain GSAG mA No input Signal Input Signal Freq = dB 4.43MHz, 1VP-P, measure VO1 Input Signal Freq = dB 7MHz/1MHz, 1VP-P, measure VO1 V V dB Differential Gain DG 1 3 Differential Phase DP 1 3 Crosstalk CT -70 3 Unit Condition VIN = 1VP-P, refer staircase signal VIN = 1VP-P, refer deg staircase signal V IN=1V 4.43M dB Sinewave % 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier MEASUREMENT CIRCUIT Tp1 H Vin1 75£[ 4.7uF Tp2 1 S1 2 Gnd 4.7uF 22uF (6dB) S3 75£[ Vout3 100uF 400£[ 75£[ 1000pF 100uF 22uF Vsag2 Vsag1 Vout2 S6 S5 4 75£[ Vcc Tp6 3 Vin2 S2 Vcc Gnd Tp5 Vout1 H Vin2 Vin1 100uF (6dB) S4 75£[ Vout2 Vout1 Tp3 Tp4 400£[ 1 Vout4 75£[ 1 0.6V 0.6V 2 2 TEST METHODES SWITCH CONDITIONS PARAMETER SYMBOL CONDITIONS S1 S2 S3 S4 S5 S6 Supply Current lcc H H 7PIN Sink Current Voltage Gain Gv H H ON ON Vout1 / Vin. Vout2 / Vin2 at Vin1(Vin2)=1MHz, 1Vpp, Sinewave Frequency Characteristic Gf H H ON ON Gv1M Voltage Gain at Vin1(Vin2)=1MHz, 1Vpp Gv10M Voltage Gain at Vin1(Vin2)=7MHz, 1Vpp Gf=Gv10M-Gv1M Differential Gain DG H H ON ON Measuring Vout3 at Vin1=Staircase Signal Differential Phase DP H H ON ON Measuring Vout3 at Vin1=Staircase Signal Crosstalk CT H L ON ON Vout2 / Vout1 at Vin1=4.43MHz 1Vpp Sinewave Vout1 / Vin2 at Vin2=4.43MHz 1Vpp Sinewave Gain Oftest Gch H H ON ON Gv1=Vout1 / Vin1, Gv2=Vout2/Vin2 Gch=Gv1-Gv2 Input Clamp Voltage Vcl H H Measuring at TP1 (TP2) SAG Terminal Gain Gsag H H TP3(TP4) Voltage; V01A(V02A), TP5(TP6) voltage. Vso1A(Vso2A) H H ON ON TP3(TP4) Voltage; V01A(V02A), TP5(TP6) voltage. Vso1B(Vso2B) Gsag=20log[(V01B-V01A) / (Vso1A-Vso1B)] Gsag=20log[(V02B-V02A) / (Vso2A-Vso2B)] 4 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. Agamem Microelectronics Inc. PRELIMINARY AA8632 Dual Video Amplifier APPLICATION CIRCUIT 1 4.7uF 1 Vin1 – AC-Couple output 4.7uF Vin2 Vin2 Vin1 75Ω 75Ω 2 Gnd Vcc Gnd Vcc 1000pF 75Ω 22uF 3 Vout1 75Ω 100uF 4 Vout1 22uF Vsag1 Vsag2 Vout1 Vout2 4.7uF 1 75Ω 100uF MEASUREMENT CIRCUIT 2 Vin1 100uF – 75Ω Vout2 DC-Couple output 4.7uF Vin1 Vout2 Vin2 Vin2 75Ω 75Ω Gnd 2 Vcc Gnd Vcc 1000pF 100uF 75Ω 3 Vout1 75Ω Vout1 4 Vsag1 Vsag2 Vout1 Vout2 75Ω Vout2 75Ω 5 Vout2 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier TSSOP-8 – AA8632AP – PACKAGE DIMENSION SYMBOLS DIMENSIONS IN MILLIMETERS DIMENSIONS IN INCHES MIN NOM MAX MIN NOM MAX A --- --- 1.20 --- --- 0.048 A1 0.05 --- 0.15 0.002 --- 0.006 0.039 0.041 --- 0.012 A2 0.80 1.00 1.05 0.031 b 0.19 --- 0.30 0.007 C 0.09 --- 0.20 0.004 --- 0.008 D 2.90 3.00 3.10 0.114 0.118 0.122 E 6.20 6.40 6.60 0.244 0.252 0.260 E1 4.30 4.40 4.50 0.169 0.173 0.177 e --- 0.65 --- --- 0.026 --- L 0.45 0.60 0.75 0.018 0.024 0.030 y --- --- 0.10 --- --- 0.004 θ 0° --- 8° 0° --- 8° NOTES: 1. mold flash protrusions or gate burrs. 2. Tolerance ± 0.1 ㎜ (4 mil) unless otherwise specified 3. Coplanarity:0.1 mm 4. Controlling dimension is millimeter converted inch dimensions are not necessarily exact. 5. 6 Package body sizes exclude Followed from JEDEC MO-153. 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. AA8632 Agamem Microelectronics Inc. PRELIMINARY Dual Video Amplifier SOP-8 – AA8632SP – PACKAGE DIMENSION SYMBOLS DIMENSIONS IN MILLIMETERS DIMENSIONS IN INCHES MIN NOM MAX MIN NOM MAX A 1.35 1.60 1.75 0.053 0.063 0.069 A1 0.10 --- 0.25 0.004 --- 0.010 A2 --- 1.45 --- --- 0.057 --- b 0.33 --- 0.51 0.013 --- 0.020 C 0.19 --- 0.25 0.007 --- 0.010 D 4.80 --- 5.00 0.189 --- 0.197 --- 0.157 2. 0.050 --- 3. Coplanarity: 0.1 mm 4. Controlling dimension is E 3.80 --- 4.00 0.150 e --- 1.27 --- --- H 5.80 --- 6.20 0.228 --- 0.244 L 0.40 --- 1.27 0.016 --- 0.050 y --- --- 0.10 --- --- 0.004 θ 0° --- 8° 0° --- 8° 7 NOTES: 1. Package body sizes exclude moldflash protrusions or gate burns. Tolerance ± 0.1 ㎜ (4 mil) unless otherwise specified millimeter converted inch dimensions are not necessarily exact 5. Followed from JEDEC MS-012 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. Agamem Microelectronics Inc. PRELIMINARY AA8632 Dual Video Amplifier DIP-8 – AA8632PP – PACKAGE DIMENSION 8 2007/8/9 AGAMEM MICROELECTRONICS INCOPERATION RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. AGAMEM DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS.