14 Pin DIL 5 Tap TTL Compatible Active Delay Lines ELECTRONICS INC. EP9810-XX & EP9810-XX-RC Add “-RC” after part number for RoHS Compliant PCA Part Number EP9810-25(-RC) EP9810-30(-RC) EP9810-35(-RC) EP9810-40(-RC) EP9810-45(-RC) EP9810-50(-RC) EP9810-60(-RC) EP9810-75(-RC) EP9810-100(-RC) EP9810-125(-RC) EP9810-150(-RC) EP9810-175(-RC) EP9810-200(-RC) EP9810-225(-RC) EP9810-250(-RC) EP9810-300(-RC) EP9810-350(-RC) Total Delay (†±5% or ± 2nS) Tap Delays (†±5% or ± 2nS) 5 6 7 8 9 10 12 15 20 25 30 35 40 45 50 60 70 10 12 14 16 18 20 24 30 40 50 60 70 80 90 100 120 140 15 18 21 24 27 30 36 45 60 75 90 105 120 135 150 180 210 20 24 28 32 36 40 48 60 80 100 120 140 160 180 200 240 280 25 30 35 40 45 50 60 75 100 125 150 175 200 225 250 300 350 Total Delay (†±5% or ± 2nS) Tap Delays (†±5% or ± 2nS) 80 160 240 320 84 168 252 336 88 176 264 352 90 180 270 360 94 188 282 376 100 200 300 400 110 220 330 440 120 240 360 480 130 260 390 520 140 280 420 560 150 300 450 600 160 320 480 640 170 340 510 680 180 360 540 720 190 380 570 760 200 400 600 800 PCA Part Number EP9810-400(-RC) EP9810-420(-RC) EP9810-440(-RC) EP9810-450(-RC) EP9810-470(-RC) EP9810-500(-RC) EP9810-550(-RC) EP9810-600(-RC) EP9810-650(-RC) EP9810-700(-RC) EP9810-750(-RC) EP9810-800(-RC) EP9810-850(-RC) EP9810-900(-RC) EP9810-950(-RC) EP9810-1000(-RC 400 420 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 †Whichever is greater. • Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter VOH VOL VIK IIH Test Conditions Min. High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current VCC = min. VIL = max. I OH = max VCC = min. VIH = min. IOL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. (One output at a time) ICCH High-Level Supply Current VCC = max. VIN = OPEN ICCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V Recommended Operating Conditions VCC Supply Voltage VIH High-Level Input Voltage VIL Low-Level Input Voltage IIK Input Clamp Current IOH High-Level Output Current IOL Low-Level Output Current PW* Pulse Width of Total Delay d* Duty Cycle TA Operating Free-Air Temperature Min. 4.75 2.0 Max. 5.25 0.8 -18 -1.0 20 40 0 40 +70 Max. Unit 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA 2.7 -40 Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS VCC Supply Voltage 10 4 6 8 OUTPUT 7 GROUND Package .400 Max. (10.16) Pin 1 I.D. .800 Max. (20..32) .020 Typ. (.508) .275 Max. (6.99) .018 x .010 (.457 x .254) .300 (7.62) Volts % nS MHz KHz Volts 12 INPUT 1 Unit V V V mA mA mA % % °C Unit 3.2 110 2.0 1.0 100 5.0 VCC PCA EP9810-XX(-RC) Date Code Notes : 1. Assembly Process (Solder Composition) EIN PW TRI PRR 14 75 mA 75 mA 4 nS 5 nS 20 TTL Load 10 TTL Load *These two values are inter-dependent. Input Pulse Test Conditions @ 25° C Schematic .100 (2.54) (Leadframe) (Assembly Solder) .150 Typ. (3.81) EP9810-XX SnPb EP9810-XX-RC Sn SnPb SnPb (RoHS exemption 7a) 2. Peak Solder Rating 225°C 260°C (per JEDEC22-B102D) 3. Weight 4. Packaging Information (Tube) TBD grams TBD grams 25 pieces/tube 25 pieces/tube Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CS9810-XX & -RC Rev. A1 1/31/06 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com