DC-DC 5-16 Amps xppower.com JAZ Series • Industry Standard Pin-out • 0.75 - 5.5 VDC Adjustable Output Versions • No Minimum Load Required • Continuous Short Circuit Protection • Input Range from 3-5.5 VDC and 9-14 VDC • UL60950 Approval • SIP and SMT Versions Available Specification Input Input Voltage Range Input Current Undervoltage Lockout Protection Input Filter General • 5 V: 3 - 5.5VDC 12 V: 9 - 14 VDC • See tables • 5 V: Turn ON > 2.8 V typical Turn OFF > 2.7 V typical 12 V: Turn ON > 8.5 V typical Turn OFF > 8.0 V typical (see note 2) • Capacitive Minimum Load Line Regulation Load Regulation Setpoint Accuracy Transient Response Ripple & Noise • See tables • 0.75 - 5.5 V, output is set by R Trim see output configuration table • No minimum load requirements • ±0.2% • ±0.5% • ±1.5% • Recovery to within 1% of nominal output voltage in 200 µS after a 25% load change • JAZ05/10/15: 20 mVrms, 50 mV pk-pk JAZ05 5 V: 45 mVrms, 75 mV pk-pk JAZ16: 30 mVrms, 75 mV pk-pk • 0.03% /˚C Temperature Coefficient Short Circuit Protection • Continuous Overtemperature • JAZ5/10/15: 120 ˚C typical Protection JAZ16: 130 ˚C typical (measured internally on all units) Remote On/Off • On = Open circuit or ≥ Vin Off = < 0.4 V For negative logic ‘L’ option: On = Open circuit or < 0,4 V Off = 2.8 V < V < Vin 1 • • • • • See tables Non-isolated 300 kHz typical SIP or SMT JAZ05: 1500 kHrs JAZ10: 1450 kHrs JAZ15: 1370 kHrs JAZ16: 1300 kHrs Environmental Output Output Voltage Output Voltage Trim Efficiency Isolation Voltage Switching Frequency Packaging Style MTBF Operating Temperature • -40 ˚C to +85 ˚C, see derating curves Cooling • Convection or force-cooled Storage Temperature • -55 ˚C to +125 ˚C EMC & Safety Safety Approvals • UL60950 Input Voltage Output Voltage 0.75 V 1.20 V 1.50 V 1.80 V 2.00 V 2.50 V 3.30 V 5.00 V 8.3 - 14.0 VDC DC-DC JAZ05 Models and Ratings Output Current 5A 5A 5A 5A 5A 5A 5A 5A R Trim (kOhms) Open 22.33 13.00 9.00 7.40 5.00 3.12 1.47 Input Current No Load Full Load 20 mA 428 mA 25 mA 625 mA 25 mA 762 mA 30 mA 893 mA 30 mA 890 mA 35 mA 1197 mA 45 mA 1545 mA 50 mA 2264 mA Efficiency Model Number(1,2,3) 73% 80% 82% 84% 85% 87% 89% 92% JAZ05-12S05 Notes 1. Add suffix ‘S’ for SMT versions. 2. The undervoltage lockout protection for the JAZ05-12S05 is turn on > 8.0 V and turn off <7.9 V. 3. For negative logic remote turn on/off add suffix ‘-L’ to part number. Mechanical Details All dimensions are in inches (mm) Tolerances: x.xx = ±0.02 (±0.50) unless otherwise stated x.xxx = ±0.01 (±0.25) Standard Version SMT Version 0.90 (22.9) 0.80 (20.3) 0.22 (5.6) Max 0.19 (4.8) GND 0.40 (10.2) 1 2 3 4 0.16 (4.1) 5 0.16 (4.1) TRIM 0.065 (1.7) 0.34 (8.6) VIN 0.025 (0.64) 0.025 (0.64) 0.200 (5.08) 0.700 (17.78) 0.062 (1.57) 0.19 (4.7) 0.24 (6.1) max VOUT 0.35 (8.9) 0.14 (3.6) 0.100 (2.54) 0.18 (4.6) 0.45 (11.4) ON/OFF Surface Mount Contact 5 Places 0.09 (2.3) 0.05 (1.3) 0.06 (1.5) 0.800 (20.32) 0.18 (4.6) 1.1 mm PLATED THROUGH HOLE 1.6 mm PAD SIZE 0.16 (4.1) VOUT 0.20 (5.1) LAYOUT PATTERN TOP VIEW 0.16 (4.1) TRIM 0.19 (4.8) GND 0.34 (8.6) 0.24 (6.1) 0.35 (8.9) ON/OFF 0.06 (1.5) PIN CONNECTIONS Pin 1 2 3 4 5 Function + Output Trim Common + V Input On/Off 0.05 (1.3) 0.01 (0.3) VIN 0.69 (17.5) PAD SIZE MIN: 0.120 x 0.095 (3.05 x 2.41) MAX: 0.135 x 0.110 (3.43 x 2.79) Derating Curves Standard Version Derating Curve for 3.3 VDC Output SMT Version Derating Curve for 3.3 VDC Output 2 DC-DC JAZ10/15/16 Models and Ratings Input Voltage Output Voltage 1.00 V 1.20 V 1.50 V 1.80 V 2.00 V 2.50 V 3.30 V 0.75 - 5.00 V 1.0 V 1.2 V 1.5 V 1.8 V 2.5 V 3.3 V 5.0 V 0.9 - 2.5 V 3.3 V 0.75 - 5.00 V 3.0 - 5.5 VDC 8.3 - 14.0 VDC 9.0 - 14.0 VDC 3.0 - 5.5 VDC 4.5 - 5.5 VDC 9.0 - 14.0 VDC Input Current No Load Full Load 50 mA 2353 mA 50 mA 2791 mA 50 mA 3409 mA 50 mA 4000 mA 60 mA 4396 mA 60 mA 5376 mA 60 mA 6947 mA 70 mA 3000 mA 50 mA 992 mA 50 mA 1160 mA 50 mA 1400 mA 50 mA 1670 mA 50 mA 2260 mA 70 mA 2960 mA 70 mA 4390 mA 70 mA 8152 mA 70 mA 10532 mA 75 mA 4783 mA Output Current 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 10 A 15 A 15 A 16 A Model Number(1,2,4) JAZ10-05S1V0 JAZ10-05S1V2 JAZ10-05S1V5 JAZ10-05S1V8 JAZ10-05S2V0 JAZ10-05S2V5 JAZ10-05S3V3 JAZ10-12S05T(3) JAZ10-12S1V0 JAZ10-12S1V2 JAZ10-12S1V5 JAZ10-12S1V8 JAZ10-12S2V5 JAZ10-12S3V3 JAZ10-12S05 Efficiency 85% 86% 88% 90% 91% 93% 95% 93% at 3.3 84% 86% 89% 90% 92% 93% 95% 92% at 2.5 94% at 3.3 92% at 3.3 V V V V JAZ15-05S3V3(3) JAZ16-12S05(3) Notes 1. Add suffix ‘S’ for SMT versions. 2. The undervoltage lockout protection for the JAZ10-12S05T is turn on > 8.0 V and turn off <7.9 V. 3. See Output Configuration Table below for values of trim resistors for specific output voltages. 4. For negative logic remote turn on/off add suffix ‘-L’ to part number. Output Configuration Table Output Voltage 0.75 V 0.90 V 1.20 V 1.50 V 1.80 V 2.00 V 2.50 V 3.30 V 5.00 V JAZ05-12S05 R Trim (kOhm) Open JAZ10-12S05T R Trim (kOhm) Open 22.33 13.00 9.00 7.40 5.00 3.12 1.47 22.30 13.00 9.00 JAZ15-05S3V3 R Trim (kOhm) JAZ16-12S05 R Trim (kOhm) Open 135.36 41.70 23.00 15.00 5.00 3.12 1.47 22.30 13.00 9.00 7.00 3.20 5.00 3.12 1.47 Mechanical Details All dimensions are in inches (mm) Tolerances: x.xx = ±0.02 (±0.50) unless otherwise stated, x.xxx = ±0.01 (±0.25) Standard Version SMT Version 0.33 (8.30) max 2.00 (50.80) 1.30 (33.0) 0.19 (4.8) 0.31 (7.9) 0.23 (5.80) COM 0.13 (3.52) 3 4 6 5 7 +VO 0.19 (4.8) TRIM 0.30 (7.5) +SENSE 0.41 0.53 (10.3) (13.5) 9 10 11 8 VIN 0.03 (0.64) 0.063 (1.60) 0.28 (7.10) 0.05 (1.30) 0.10 (2.54) 0.048 (1.2) 1.18 (29.9) TOP VIEW 0.19 (4.8) +SENSE 0.33 (8.40) LAYOUT PATTERN 0.075 (1.9) Surface Mount Contact 0.30 (7.5) 0.29 (7.4) ON/OFF 0.112 (2.84) 0.25 (0.64) 1.00 (25.40) 0.40 (10.20) 0.37 (9.3) max 0.065 (1.7) 0.43 (10.9) 0.50 (12.70) 1 2 0.19 (4.8) 0.19 (4.8) TRIM 0.19 (4.8) +VO PAD SIZE MIN: 0.140 x 0.095 (3.56 x 2.41) MAX: 0.165 x 0.110 (4.19 x 2.79) 0.31 (7.9) COM 0.41 (10.3) 0.43 (10.9) 0.025 (0.64) ON/OFF VIN 0.04 (1.10) PLATED THROUGH HOLE 0.06 (1.60) PAD SIZE Surface Mount Contact PIN CONNECTIONS 3 Pin 1 2 3 4 5 6 7 8 9 10 11 Function + Output + Output + Sense + Output Common Common + V input + V input No pin Trim On/Off Control JAZ05/10/15/16 JAZ10/15/16 Circuit configuration for programming output voltage using an external resistor. Derating Curves Standard Version SMT Version Derating Curve for 5.0 VDC Input Derating Curve for 5.0 VDC Input Derating Curve for 5.0 VDC Input Derating Curve for 5.0 VDC Input Derating Curve for 12.0 VDC Input Derating Curve for 12.0 VDC Input JAZ10 JAZ15 JAZ16 14-Jul-05 DC-DC Circuit Configuration Diagram