14 Pin SMD Single Output TTL Compatible Active Delay Lines ELECTRONICS INC. EPA810-XX & EPA810-XX-RC Add “-RC” after part number for RoHS Compliant Time Delays (†±5% or ± 2nS) PCA Part Number EPA810-5(-RC) EPA810-6(-RC) EPA810-7(-RC) EPA810-8(-RC) EPA810-9(-RC) EPA810-10(-RC) EPA810-11(-RC) EPA810-12(-RC) EPA810-13(-RC) EPA810-14(-RC) EPA810-15(-RC) EPA810-16(-RC) EPA810-17(-RC) EPA810-18(-RC) EPA810-19(-RC) EPA810-20(-RC) EPA810-21(-RC) PCA Part Number EPA810-22(-RC) EPA810-23(-RC) EPA810-24(-RC) EPA810-25(-RC) EPA810-30(-RC) EPA810-35(-RC) EPA810-40(-RC) EPA810-45(-RC) EPA810-50(-RC) EPA810-55(-RC) EPA810-60(-RC) EPA810-65(-RC) EPA810-70(-RC) EPA810-75(-RC) EPA810-80(-RC) EPA810-85(-RC) EPA810-90(-RC) 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Time Delays (†±5% or ± 2nS) PCA Part Number EPA810-95(-RC) EPA810-100(-RC) EPA810-125(-RC) EPA810-150(-RC) EPA810-175(-RC) EPA810-200(-RC) EPA810-225(-RC) EPA810-250(-RC) EPA810-275(-RC) EPA810-300(-RC) EPA810-350(-RC) EPA810-400(-RC) EPA810-500(-RC) EPA810-600(-RC) EPA810-700(-RC) EPA810-800(-RC) EPA810-900(-RC) EPA810-1000(-RC) 22 23 24 25 30 35 40 45 50 55 60 65 70 75 80 85 90 Time Delays (†±5% or ± 2nS) 95 100 125 150 175 200 225 250 275 300 350 400 500 600 700 800 900 1000 †Whichever is greater. • Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. Schematic DC Electrical Characteristics Parameter VOH VOL VIK IIH Test Conditions Min. High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current VCC = min. VIL = max. I OH = max VCC = min. VIH = min. IOL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. (One output at a time) ICCH High-Level Supply Current VCC = max. VIN = OPEN ICCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V Recommended Operating Conditions Min. VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 4.75 2.0 Max. Unit 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 *These two values are inter-dependent. Max. Unit 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA 2.7 -40 14 EIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS VCC Supply Voltage 7 GROUND 75 mA 75 mA 4 nS 5 nS 20 TTL Load 10 TTL Load Package .420 Max. (10.67) PCA EPA810-XX(-RC) D.C. .780 Max. (19.81) .200 Max. (5.08) .050 (1.27) .300 (7.62) Notes : 1. Assembly Process Volts % nS MHz KHz Volts .280 Max. (7.11) .600 (15.24) .010 Typ. (2.54) .020 (.508) (Leadframe) (Assembly Solder) EPA810-XX SnPb EPA810-XX-RC Sn SnPb SnPb (RoHS exemption 7a) Unit 3.2 110 2.0 1.0 100 5.0 OUTPUT INPUT 1 (Solder Composition) Input Pulse Test Conditions @ 25° C 8 VCC 2. Peak Solder Rating 225°C 260°C 3 (168 hours, ≤30°C/60%RH) 4 (72 hours, ≤30°C/60%RH) (per IPC/JEDEC J-STD-020C) 3. Moisture Sensitive Levels (MSL) (per IPC/JEDEC J-STD-020C) 4. Weight 5. Packaging Information (Tube) TBD grams TBD grams 25 pieces/tube 25 pieces/tube Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSA810-XX & -RC Rev. A1 2/1/06 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com