3.2x2.4mm SMD CHIP LED LAMP APD3224SEC-F01 SUPER BRIGHT ORANGE Features z3.2x2.4mm SMT LED, 2.4mm THICKNESS. Description zLOW POWER CONSUMPTION. The Super Bright Orange device is made with DH zIDEAL FOR BACKLIGHT AND INDICATOR. InGaAlP (on GaAs substrate) light emitting diode chip. zVARIOUS COLORS AND LENS TYPES AVAILABLE. zPACKAGE : 1500PCS / REEL. zRoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAF1084 REV NO: V.1 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1203001073-01 Selection Guide Part No. Dice Iv (mcd) @ 20mA Lens Type APD3224SEC-F01 SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 650 2000 20° Units Test Conditions Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. λpeak Peak Wavelength Super Bright Orange 610 nm IF=20mA λD Dominant Wavelength Super Bright Orange 601 nm IF=20mA ∆λ1/2 Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Orange 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA Reverse Voltage 5 V Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAF1084 REV NO: V.1 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1203001073-01 Super Bright Orange APD3224SEC-F01 SPEC NO: DSAF1084 REV NO: V.1 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1203001073-01 APD3224SEC-F01 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF1084 REV NO: V.1 APPROVED: J. Lu CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1203001073-01