RoHS BR5005-5010 SINGLE-PHASE BRIDGE RECTIFIER FEATURES Low cost This series is UL recognized under component index, file number E127707 High forward surge current capability low thermal resistance. High isolation voltage from case to lugs. High temperature soldering guaranteed: 260/10 second, at 5 lbs. (2.3kg) tension. MECHANICAL DATA Case: Molded body Terminal: Plated 0.25" (6.35mm) lug. Polarity: Polarity symbols marked on case. Mounting: Thru hole for #10 screw, 20 in - lbs. Torque max Weight: 0.62ounce, 17.5gram(BR40) O MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load derate current by 20% E Maximum Instantaneous Forward Voltage Drop per bridge element at 25A Maximum DC Reverse Current at rated TA = 25 DC blocking voltage per element TA Isolation Voltage from case to lugs Typical Thermal Resistance (Note 1, 2) Operating Temperature Range Storage Temperature Range W O N SYMBOLS BR5005 BR501 BR502 BR504 BR506 BR508 BR5010 VRRM Volts VRMS Volts VDC Volts C E L Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Output Current, at TC = 50 (Note1,2) Peak Forward Surge Current 8.3ms single half sine - wave superimposed on rated load (JEDEC method ) Rating for Fusing (t<8.3ms) J E R T IC C D T ,. L I(AV) Amps IFSM Amps It 2 As VF Volts (-65 to +150) (-65 to +150) Amp mAmp VAC /W IR VISO RJC TJ TSTG 1. Unit Mounted on 9" X 3.5" X 4.6" (23 X 9 X 11.8cm) Al. finned plate. 2. Bolt down on heatsink with silicon thermal compound between bridge and mounting surface for maximum heat transfer efficiency with #10 screw. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] 2 RoHS BR5005-5010 FIG.1-DERATING CURVE FOR FORWARD SURGE CURRENT PER ELEMENT 9"X 3.5"X 4.6" Thick (23 X 9 X 11.8cm) AL.Finned Plate Single Phase Half Wave 60Hz Inductive or Resistive 600 8.3ms Single Half Sine-Wave Tj (JEDEC Method) =T 1 Cycle 400 300 200 100 Load 10 0 1 0 25 0 50 75 125 100 150 2 4 6 8 10 175 20 40 C NUMBER OF CYCLES AT 60 Hz CASE TEMPERATURE, ( ° C) FIG.4-TYPICAL REVERSE FIG.3-TYPICAL FORWARD CHARACTERISTICS PER BRIDGE LEMENT IC 100 (A) 1.0 Tj =25 ° C Pulse Width=300uS 1%Duty Cycle R T 0.1 C E L 0.01 1.0 0.8 0.6 0.4 1.4 1.2 1.8 1.6 INSTANTANEOUS FORWARD VOLTAGE,(V) N 10 (uA) 10 INSTANTANEOUS REVERSE CURRENT, Tj =100 ° C O 1.0 60 100 CHARACTERISTICS PER BRIDGE ELEMENT 100 INSTANTANEOUS FORWARD CURRENT, j max 500 CURRENT, (A) PEAK FORWARD SURGE Heat Sink Mounting CURRENT,(A) AVERAGE FORWARD OUTPUT 700 30 D T ,. L O FIG.2-MAXIMUM NON-REPETITIVE PEAK OUTPUT RECTIFIED CURRENT 50 Tj =25 ° C 0.1 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) FIG.5-MAXIMUM POWER DISSIPATION E AVERAGE POWER DISSIPATION OF BRIDGE, 100 80 W (W) J E Tj =T j max 60 Capacitive Load 40 Resistive or Inductive 20 Load 0 0 5 10 15 20 25 30 35 40 45 50 AVERAGE OUTPUT CURRENT, (A) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected]