D28mm Tops 6 Power Warm White COB LED OSM5X3L6E1E VER.A.2 ■ Features ● High-power LED ● Long lifetime operation ● Typical viewing angle : 140deg ● RoHS compliant Possible to attach to heat sink directly without using print circuit board. ● ■Outline ■ Applications ● Indoor & outdoor lighting ● Light Bulb ● Reading lamps ● Display cases, furniture illumination, marker Architectural illumination ● Spotlights ● ■Absolute Anode Cathode Unit:mm Tolerance:±0.30mm Tolerances are for reference only Maximum Rating Item Dimension ■Directivity (Ta=25℃) Symbol Value Unit DC Forward Current *1 IF 700 mA Pulse Forward Current*2 IFP 1200 mA Reverse Voltage VR 15 V Power Dissipation*1 PD 8,400 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 ℃ ℃ ℃/5sec - *1, Power dissipation and forward current are the value when the module temperature is set lower than the rating by using an adequate heat sink. *2, Pulse width Max.10ms Duty ratio max 1/10 ■Electrical -Optical Characteristics (Ta=25℃ (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=600mA 9.6 10.2 12.0 V DC Reverse Current IR VR=15V - - 20 µA Luminous Flux Φv IF=600mA 370 400 - lm Color Temperature CCT IF=600mA 2700 3000 3300 K x IF=600mA - 0.44 - y IF=600mA - 0.41 - 2θ1/2 IF=600mA - 140 - Chromaticity Coordinates* 50% Power Angle deg Note: Don’t drive at rated current more than 5s without heat sink for High Power series. * Tolerance of chromaticity coordinates is +10% , * Tolerance of Luminous Flux is +20% LED & Application Technologies 30° 0 30° 60° 90° 1 60° 0.5 0 0.5 1 90° D28mm Tops 6 Power Warm White COB LED OSM5X3L6E1E VER . A.2 ■Heat design The following pictures show some measurements of mounted 5W Led on the heat sink for each board A and B (See Fig 1) with using thermograph to make an observation about heat distribution. Each boards is tested at various current conditions. As a result, LED needs larger heat sink as much as possible to reduce its own case temperature. Fig. 1 Configuration pattern examples for board assembly ㎡ Surface area (m ) Board LED power Material A 5W Al 20,600 B 10W Al 41,200 C 25W Al 103,000 D 50W Al 206,000 E 100W Al 412,000 F 200W Al 824,000 G 300W Al 1236,000 Min. Above tested LED device is attached with adhesive sheet to the heatsink. ℃ as a prerequisite on design process of 5W LED. <Fig.3> Board B (surface area=20,600m㎡) For reference's sake, Tj absolute maximum rating is defined at 115 ㎡ <Fig.2> Board A (surface area=10,300m ) IF=600mA LED & Application Technologies IF=600mA