ACDC 15 Watts DLE Series xppower.com • AC Input LED Driver • Constant Voltage & Current Versions • High Power Factor • High Efficiency • Water Proof to IP67 • Class 2 • 3 Year Warranty Specification Input General • • • • • • • 90-264 VAC, see derating curve 47-63 Hz 0.25 A at 115 VAC, 0.1 A at 230 VAC 15 A at 230 VAC, cold start +25 °C >0.83 at 230 VAC, full load <0.5 W max at 230 VAC Internal T1.0A/250V fuse fitted in line Output Voltage Minimum Load Start Up Delay Hold Up Time • • • • Line Regulation Load Regulation • • Turn On Overshoot Transient Response • • Ripple & Noise • See table No min load required 500 ms max at 115 VAC No hold up for -A versions, 6ms min for -V versions ±0.5% ±1.0% in constant voltage mode, ±5.0% in constant current mode 5% max 5% max deviation, recovery to within 1% in 10 ms for a 50% load change 1% max mV pk-pk, for - V versions (see note 2) 130-160% for -V versions, auto recovery Trip and restart (hiccup mode) 0.04%/°C Input Voltage Input Frequency Input Current Inrush Current Power Factor No Load Input Power Input Protection Output Overload Protection • Short Circuit Protection • Temperature • Coefficient • • • • See table 3750 VAC Input to Output 100 kHz typical >200 kHrs to MIL-HDBK-217F at 25 °C, GB • • • • • -20 °C to +70 °C (see derating curve) 5-100% RH, non-condensing -40 °C to +80 °C 3000 m 10-500 Hz, 2 g, 10 mins/cycle, 6 cycles in each of 3 axes Emissions Harmonic Currents Voltage Flicker ESD Immunity • • • • Radiated Immunity EFT/Burst Surge • • • Conducted Immunity Dips & Interruptions • • Safety Approvals • EN55015, class B conducted and radiated EN61000-3-2, class C EN61000-3-3 EN61000-4-2, 8 kV air and 4 kV contact, Perf Criteria A EN61000-4-3, level 2 Perf Criteria A EN61000-4-4, level 2 Perf Criteria A EN61000-4-5, installation class 3, Perf Criteria B EN61000-4-6, level 2 Perf Criteria A EN61000-4-11, 100% 10 ms, 30% 200 ms, Perf Criteria B, B EN61347, UL8750, CE Mark Efficiency Isolation Switching Frequency MTBF Environmental Operating Temperature Operating Humidity Storage Temperature Operating Altitude Vibration EMC & Safety Output Power Output Voltage Output Current Efficiency(1) Model Number 15 W 15 W 15 W 15 W 15 W 14.7 W 12 V 24 V 8 - 12 V 14 - 22 V 24 - 30 V 26 - 42 V 1250 mA 630 mA 1250 mA 700 mA 500 mA 350 mA 81.0% 83.0% 81.0% 83.0% 83.0% 84.0% DLE15PS12-V DLE15PS24-V DLE15PS1250-A DLE15PS700-A DLE15PS500-A DLE15PS350-A Notes 1. Typical efficiency at full load and 230 VAC input. 2. Measured using 12” twisted pair with 0.1 µF and 47 µF capacitors in parallel at 20 MHz bandwidth. Mechanical Details 5.90 (150.0) 4.33 (110.0) 5.90 (150.0) UL1015 18AWG UL1015 20AWG AC N(Blue) V- (Black) 2-R1 0.07 (1.8) 1.38 (35.0) AC L(Brown) V+ (Red) 0.12 (3.0) 0.98 (25.0) Notes 1. Tolerance: 0.x = ±0.008 (±0.2) 0.xx = ±0.002 (±0.05) Application Notes Constant Current Curve Output Voltage Vo max Vo min Trip & Restart Zone 0 10 20 30 40 50 60 70 Output Current (%) 100 100 80 80 Load (%) Load (%) Derating Curves 60 40 20 0 -20 80 90 100 60 40 20 -10 0 10 20 30 Temp (˚C) 40 50 60 70 0 90 100 264 Input Voltage (VAC) 19-Sept-13 ACDC DLE15 Models and Ratings