HITRON HDM08-24B-S05 Pcb-mount dc-dc converter encapsulated modules 8 watts single & dual output Datasheet

H HiTRON
PCB-MOUNT DC-DC CONVERTER ENCAPSULATED MODULES
8 WATTS SINGLE & DUAL OUTPUT HDM08-S & HDM08-D SERIES
FEATURES:
LOW COST SINGLE & DUAL OUTPUT
WIDE 4:1 & 2:1 INPUT RANGE
8W ISOLATED OUTPUT
SIX-SIDED METAL SHIELD
SPECIFICATION
INPUT SPECIFICATION
OUTPUT SPECIFICATION
Input Range: Wide 4:1 & 2:1 DC input range.
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Voltage Accuracy: Main O/P ±2.0% typical.
Line Regulation: Various with output voltages.
±0.5% typical.
Load Regulation: Various with output voltages.
Single O/P±1.0% typical.
Dual O/P ±2.0% typical.
Noise & Ripple: Typical 100mV for 3.3V/5.0V &
1.0% for others peak to peak.
OVP: Built-in on main output.
Overload Protection (OLP):
Fully protected against output overload and short circuit.
OLP set at about 125-150% rating output wattage.
Consult the factory for OLP setting.
See Ratings Chart.
Input Voltage: Nominal 12/24/48 Vdc.
Input Current: Various with input range and load.
See Ratings Chart.
Input Fuse: Use external fuse.
Input Filter: Pi-Network.
Undervoltage Shutdown: 8Vdc.
Isolation Resistance: 1,000 Mega Ohms.
Isolation Voltage: 1,500Vdc.
EMI: Six-sided metal shielding.
GENERAL SPECIFICATION
Efficiency: 84% typical various with input.
Switching Frequency: Fixed frequency 100K Hz.
Circuit Topology: 100K Hz. Forward Circuit.
Transient Response: Peak deviation 200mV.
Recovery time< 3mS for a 25% load change.
Case: Black coated steel with non-conductive metal base.
Power Density: 10Watts. / Cubic inch.
Commercial Grade only.
MTBF: 1,000,000 hours. Mil Std 217, 25°C.
Operating Temperature: -10 to +70°C range.
0°C to +60°C full load without derating.
From +60°C, derating linearly to half load @+70°C.
(Refer to Derating Chart.)
Temperature: -20°C to +85°C.
Temperature Coefficient: ± 0.03% /°C.
Cooling: Convection cooling up to +60°C @ full load.
At least 100LFM moving air is recommended for
F-L > +60°C in a confined area.
Humidity: Up to 95%RH, Non-condensing.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Line Regulation measured from High to Low Lines at full load.
(3) Load Regulation measured from Full Load to 1/2 Full Load at nominal input.
(4) Correct fuse size by calculating the max. DC current drains at low Line input & Load and then adding 20-25%for the desired fuse size.
Due to requests in market and advances in technology, specifications subject to change without notice.
-17-
INPUT/OUTPUT & VOLTAGE/ CURRENT RATINGS CHART
SINGLE OUTPUT
INPUT
Vdc
MODEL NO.
HDM08-24B-S03
HDM08-24B-S05
HDM08-24B-S09
HDM08-24B-S12
HDM08-24B-S15
HDM08-24B-S24
HDM08-24D-S03
HDM08-24D-S05
HDM08-24D-S09
HDM08-24D-S12
HDM08-24D-S15
HDM08-24D-S24
HDM08-48D-S03
HDM08-48D-S05
HDM08-48D-S09
HDM08-48D-S12
HDM08-48D-S15
HDM08-48D-S24
18.018.018.018.018.018.09.09.09.09.09.09.020.020.020.020.020.020.0-
36.0
36.0
36.0
36.0
36.0
36.0
36.0
36.0
36.0
36.0
36.0
36.0
72.0
72.0
72.0
72.0
72.0
72.0
INPUT CURRENT
OUTPUT
N. L. (mA) F.L. VO1(Vdc)★
46
290
3.3V
46
393
5.0V
46
420
9.0V
46
415
12.0V
46
425
15.0V
46
430
24.0V
50
290
3.3V
50
393
5.0V
50
420
9.0V
50
415
12.0V
50
425
15.0V
50
430
24.0V
46
145
3.3V
46
196
5.0V
46
210
9.0V
46
207
12.0V
46
212
15.0V
46
215
24.0V
OUTPUT
VO1(A)
CASE
SIZE
1.50A
1.50A
0.90A
0.67A
0.55A
0.35A
1.50A
1.50A
0.90A
0.67A
0.55A
0.35A
1.50A
1.50A
0.90A
0.67A
0.55A
0.35A
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DUAL OUTPUT
MODEL NO.
INPUT
Vdc
INPUT CURRENT
N. L. (mA) F.L.
46
18.0- 36.0
46
18.0- 36.0
46
18.0- 36.0
46
18.0- 36.0
50
9.0- 36.0
50
9.0- 36.0
50
9.0- 36.0
50
9.0- 36.0
46
20.0- 72.0
46
20.0- 72.0
46
20.0- 72.0
46
20.0- 72.0
Symbols: "★" OVP built-in.
"║" Double Feedback.
HDM08-24B-D03
HDM08-24B-D05
HDM08-24B-D12
HDM08-24B-D15
HDM08-24D-D03
HDM08-24D-D05
HDM08-24D-D12
HDM08-24D-D15
HDM08-48D-D03
HDM08-48D-D05
HDM08-48D-D12
HDM08-48D-D15
300
420
420
420
300
420
420
420
150
210
210
210
OUTPUT (Vdc)
+VO1★
-VO2║
OUTPUT (A)
+VO1
-VO2
CASE
SIZE
+3.3V
+ 5.0V
+12.0V
+15.0V
+3.3V
+ 5.0V
+12.0V
+15.0V
+3.3V
+ 5.0V
+12.0V
+15.0V
0.80A
0.80A
0.34A
0.27A
0.80A
0.80A
0.34A
0.27A
0.80A
0.80A
0.34A
0.27A
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
DM2C
-3.3V
-5.0V
-12.0V
-15.0V
-3.3V
-5.0V
-12.0V
-15.0V
-3.3V
-5.0V
-12.0V
-15.0V
MECHANICAL DIMENSIONS: MM [INCHES]
0.80A
0.80A
0.34A
0.27A
0.80A
0.80A
0.34A
0.27A
0.80A
0.80A
0.34A
0.27A
WEIGHT: 27.5g (0.95 Oz.)
PIN ASSIGNMENT
PIN NO.
PIN# 1.
PIN# 2.
PIN# 3.
PIN# 4.
PIN# 5.
SINGLE
-INPUT
+INPUT
DC-COM
NO PIN
+VO1
DERATING CHART
CASE SIZE: DM2C
-18-
DUAL
-INPUT
+INPUT
-VO2
DC-COM
+VO1
Similar pages