AH282 Hall-Effect Smart Fan Motor Controller Features General Description - On chip Hall sensor - Rotor-locked shutdown - Automatically restart - Frequency generator (FG) output - Buil t-in Zener protection for output driver - Operating voltage: 10V~20V, driver start up: 8V (minimum) - Output current: IO( AVE ) = 300 mA AH282 is a monolithic fan motor controller with Hall sensor’s capability. It contains two complementary open-collector transistors as motor coil drivers, automatic lock current shutdown, and recovery protections. Additional, frequency generator (FG) output is for speed detection relatively. To avoid coil burning, rotor-lock shutdown detection circuit shut down the output driver if the rotor is blocked and then the automatic recovery circuit will try to restart the motor. This function repeats while the rotor is blocked. Until the blocking is removed, the motor recovers running normally. - Package: SIP-5L, SOT89-5L Pin Descriptions Pin Configuration Symbol FG VCC DO DOB GND ( Front View ) 282 1 : FG 2 : VCC 3 : DO Description Frequency generation Input power Output pin Output pin Ground 4 : DOB 5 : GND 1 2 3 4 5 SIP-5L VCC 1 GND 2 5 FG AH282 DO 3 74 DOB SOT89-5L Ordering Information AH282 X - X X X Wafer Body Package Lead Packing Blank or A~Z : if necessary to specify P: SIP-5L Y: SOT89-5L L : Lead Free Blank: Normal Blank : Tube or Bulk A : Tape & Reel This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of this product. No rights under any patent accompany the sale of the product. Rev. 0.4 Apr 16, 2004 1/7 AH282 Hall-Effect Smart Fan Motor Controller Block Diagram (SIP5) VCC 2 Lock shutdown and Automatic recovery Regulator Hall Plate 3 DO 4 DOB Control Logic Amp. 5 1 GND FG Typical Application Circuit D1 + Vcc (12V) R pu C1 10uF 282 Coil2 1 2 3 4 Coil1 5 GND FG 12V DC Brush-less Fan with FG output function Anachip Corp. www.anachip.com.tw Rev 0.4 Apr 16, 2004 2/7 AH282 Hall-Effect Smart Fan Motor Controller Absolute Maximum Ratings (Ta = 25°C) Characteristics Symbol Output Zener-breakdown Voltage Operating Supply Voltage Rating Vz VCC 38 28 300 400 550 800 -20 ~ 100 -55 ~ 150 150 IO(AVE) IO(PEAK) Output Current Power Dissipation SIP5 SOT89-5 PD Operating Temperature Storage Temperature Maximum Junction Temp. Unit Topr Tstg Tj V V mA mW °C °C °C Electrical Characteristics (Ta = 25 °C, VCC = 12V, unless otherwise notice) Characteristics Supply Voltage Symbol Conditions Min. Typ. Vcc Operating 10 Supply current Locked Protection On Locked Protection Off Icc Tlrp-on Tlrp-off Operating - 2 Output saturation voltage VOUT( sat ) - Output On resistance FG output Vds Rds(on) Vol 0.4 2.4 375 625 2.6 0.5 IO=150mA IO=250mA IO=10mA Max. Unit 20 V 4 mA Sec Sec - mV ohm V Magnetic Characteristics (Ta = 25 °C, VCC = 12V, unless otherwise specified) (1mT=10 Gauss) Characteristics Symbol Min. Typ. Max. Unit Operate Point Release Point Hysteresis Bop Brp Bhy -60 - 30 -30 60 60 - Gauss Gauss Gauss Anachip Corp. www.anachip.com.tw Rev 0.4 Apr 16, 2004 3/7 AH282 Hall-Effect Smart Fan Motor Controller Operating Characteristics DO 12 RP Output Voltage in Volts Output Voltage in Volts DOB OFF 10 8 6 4 2 ON Brp 0 OP 12 OFF OP 10 8 6 4 2 RP Bop Brp Magnetic Flux Density in Gauss ON 0 Bop Magnetic Flux Density in Gauss Performance Characteristics (SIP5) Ta (°C) 25 50 60 70 80 85 90 95 100 105 110 115 120 Pd (mW) 550 440 396 352 308 286 264 242 220 198 176 154 132 P o w e r D is s ip a tio n C u rve P d (m W ) 600 500 400 300 200 100 0 25 50 75 100 125 150 T a (。 C ) Anachip Corp. www.anachip.com.tw Rev 0.4 Apr 16, 2004 4/7 AH282 Hall-Effect Smart Fan Motor Controller Marking Information (1)SIP-5L ( Top View ) 282 X XX X X Part Number Blank : normal L : Lead Free Package ~ ID Code Nth week: 01~52 Year: "1" = 2001 "2" = 2002 (2)SOT89-5L 4 7 5 ID code A~Z: Non-Lead Free a~z : Lead Free M : Month: A~L Y : Year: 0-9 282 Y M X 1 2 3 Anachip Corp. www.anachip.com.tw Rev 0.4 Apr 16, 2004 5/7 AH282 Hall-Effect Smart Fan Motor Controller Package Information ( unit: mm / [inch] ) (1)Package type: SIP-5L 5.22 ± 0.1 [0.206 ± 0.003] 2° ~ 3° 2-0.3C [0.079-0.012C] 2 ° ~ 5° 1.55 ± 0.1 [0.061 ± 0.003] 4.2 REF [0.165 REF] 0.73 ± 0.1 [0.029 ± 0.003] 2° ~ 3 ° 2° ~ 5 ° 3.65 ± 0.1 [0.144 ± 0.003] 0.48 ± 0.1 [0.019 ± 0.003] 14.3 ± 0.3 0.38 ± 0.03 [0.563 ± 0.012] [0.015 ± 0.001] 0.95 ± 0.03 0.38 ± 0.03 [0.037 ± 0.001] [0.015 ± 0.001] Location of Sensing Point 2.006 mm [0.079 inch] ( Top View) 1.016 mm [0.04 inch] 1 2 3 Anachip Corp. www.anachip.com.tw 4 5 Rev 0.4 Apr 16, 2004 6/7 AH282 Hall-Effect Smart Fan Motor Controller (2) Package type: SOT89-5L A C D F B E K J F L I H G Package Sensor Location Y X Symbol A B C D E F G H I J K L X Y Dimensions In Millimeters Min. Nom. Max. 4.40 4.50 4.60 4.05 4.15 4.25 1.50 1.60 1.70 1.30 1.40 1.50 2.40 2.50 2.60 0.80 3.00 Ref. 1.50 Ref. 0.40 0.46 0.52 1.40 1.50 1.60 0.35 0.39 0.43 5o Typ. 1.90 1.65 - Anachip Corp. www.anachip.com.tw Dimensions In Inches Min. Nom. Max. 0.173 0.177 0.181 0.159 0.163 0.167 0.059 0.063 0.067 0.051 0.055 0.059 0.094 0.098 0.102 0.031 0.118 Ref. 0.059 Ref. 0.016 0.018 0.020 0.055 0.059 0.063 0.014 0.015 0.017 5o Typ. 0.075 0.065 - Rev 0.4 Apr 16, 2004 7/7