LD005 THRU LD10 SINGLE PHASE GLASS PASSIVATED SURFACE MOUNT FLAT BRIDGE RECTIFIER VOLTAGE: 50 TO 1000V CURRENT: 0.6A FEATURE LDF Low profile space Ideal for automated placement Glass passivated chip Low forward voltage drop Low leakage current High forward surge capability High temperature soldering:260℃/10 seconds at terminals MECHANICAL DATA Terminal: Plated leads solderable per MIL-STD 202E, method 208C Case:UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current at Ta =40°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at forward current 0.3A Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C Typical Thermal resistance (Note1) Typical Junction Capacitance (Note2) Storage and Operating Junction Temperature Range Vrrm Vrms VDC LD 005 50 35 50 LD 01 100 70 100 LD 02 200 140 200 LD 04 400 280 400 LD 06 600 420 600 LD 08 800 560 800 LD 10 1000 700 1000 V V V If(av) 0.6 A Ifsm 20.0 A Vf 1.0 V Rth(ja) Rth(jl) Cj 5.0 100.0 70 20 13.0 Tstg, Tj -55 to +150 Ir µA °C/W pF °C Note: 1. On aluminum substrate P.C.B. with an area of 0.8”×0.8”(20×20mm) mounted on 0.05×0.05”(1.3×1.3mm) solder pad 2. Measured at 1.0 MHz and applied voltage of 4.0 volt Rev.A2 Units www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES LD005 THRU LD10 Rev.A2 www.gulfsemi.com