14 Pin DIP Passive Delay Lines Zo DELAY OHMS nS ±5% ±10% or ± 2nS† 50 50 50 100 100 100 100 200 200 10 25 50 20 50 100 250 20 40 TAP RISE DELAYS TIME nS ±10% nS or ± 0.5nS† Max. 1 2.5 5 ±1 2 5 ±1 10 25 2 4 ATTEN DB Max. PCA PART NUBER 1 1 1 1 1 1 1 1 1 EP6400-1 EP6400-2 EP6400-3 EP6400-4 EP6400-5 EP6400-6 EP6400-18 EP6400-17 EP6400-7 3 5 10 4 10 20 50 4 8 Zo DELAY OHMS nS ±5% ±10% or ± 2nS† 200 200 250 300 300 300 500 500 500 TAP RISE DELAYS TIME nS ± 10% nS or ± 0.5nS† Max. 100 200 250 60 150 300 100 250 500 10 20 25 6 ±1 15 30 10 25 50 ATTEN DB Max. 20 40 50 12 30 60 20 50 100 PCA PART NUMBER 1 1 1 1 1 1 1 2 2 EP6400-8 EP6400-9 EP6400-16 EP6400-10 EP6400-11 EP6400-12 EP6400-13 EP6400-14 EP6400-15 †Whichever is greater. DC Electrical Characteristics Distortion Temperature Coefficient of Delay Insulation Resistance @ 100 Vdc Dielectric Strength Min Max Unit ±10 100 Schematic % PPM/°C Meg Ohms Vdc 1K 100 14 IN 2 12 3 1 Recommended Operating Conditions PW* D* TA Pulse Width % of Total Delay Duty Cycle Operating Free Air Temperature Min Max Unit 40 70 % % °C 200 0 11 4 5 10 6 GROUND 9 7 OUT 8 Package Dimensions PCA EP6400-1 Date Code *These two values are inter-dependent. White Dot Pin#1 .280 Max. .780 Max. .020 Min. .230 Max. Input Pulse Test Conditions @ 25°C VIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Input Rise Time (10 - 90%) Pulse Repetition Rate @ Td ≤ 150 nS Pulse Repetition Rate @ Td > 150 nS DSD6400 Rev. A 3 Volts 300 % 2.0 nS 1.0 MHz 300 KHz .020 Typ. .100 Typ. .365 Max. QAF-CSO1 Rev. B 8/25/94 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 .010 Typ. .150 Typ. ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791