MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER DESCRIPTION Th is p rod u ct is d e si gn e d t o pr o vi de hi g h op tic a l pe r fo rma n ce f or SD H S TM- 6 4 /S O NE T O C-1 9 2 . Trans mitte r uses co oled lase r in a butterfly pa ckag e mod ule wi th dri ve red by sp eci fic i nte gra ted ci rcu it . Re ceiver u ses PD pre amp -modul e (b utterfly packag e mod ule) and integrated circuits for reshaping, retimin g an d r e g e n e r a ti n g o p ti c a l s i g n a l . FEATURES Full SONET/SDH line up K connector interface -5.2V,+5V power supply target, -2.2V(TX only) Case Temp. Range: 10 to 65 ° C Clock recovery and digital alarm function. APPLICATION Short haul and long haul telecommunication systems for SDH STM64 / SONET OC-192. ABSOLUTE MAXIMUM RATINGS Stress below listed absolute maximum rating may cause permanent damage to the transmitter and receiver. Th is is a stress o nly and functional operation of the transceiver at these or any other conditions in excess of those given in the operational sections of this data sheet is not implied. Exposure to Absolute Maximum Rating for extended periods may affect transmitter and receiver reliability. Tc=25°C Parameters Symbol Ratings Unit Vcc +5.3 V Vee -6.0 V Vtt -2.4 V Tstg -40 to 85 °C Tc 10 to 65 °C Relative humidity(non condensation) - 10 to 80 % Fiber bend radius rF 32 mm Supply voltage Storage temperature Operating case temperature MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER ELECTRICAL CHARACTERISTICS All parameters are specified over the operating case temperature. Measurement conditions are at 9953.28Mb/s+/-20ppm, NRZ PN223 -1 and 50%duty cycle data signal. Vcc=+5.0V+/-5%, Vee=-5.2V+/-5%, Vtt=-2.2V+/-0.1V,Tc=10 to 65 °C, Using a PRBS 2 23 -1 pattern with a 50%Mark ratio, unless otherwise noted. Transmitter Parameters Condition Supply voltage Supply current Symbol Min. Typ. Max. Unit Vee -5.46 -5.2 -4.94 V Vcc 4.75 5.0 5.25 V Vtt -2.3 -2.2 -2.1 V Iee - - 1.5 A Icc - - 1.0 A Itt - - 1.2 A Data / Clock input voltage (DC:50ohm) note 1 - Data / Clock relationship note 5 Td note 2,3 - Condition Symbol Min. Typ. Max. Unit Vee -5.46 -5.2 -4.94 V Vcc 4.75 5.0 5.25 V Iee - - 1.5 A Icc - - 1.5 A Function SCFL -20 - +20 Shutdown, Laser Degradation, Power out of range Alarm, Laser Over Temperature Alarm psec - Receiver Parameters Supply voltage Supply current Data output voltage (DC:50ohm) note 4 Clock output voltage (AC:50ohm) note 4 Data / Clock relationship note 5 Jitter Function - Td - note 6 - SCFL - 0.5 - 1.5 Vpp -25 - +25 psec TBD Loss of Signal Alarm - MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER OPTICAL CHARACTERISTICS Parameter Symbol Specification Unit ITU code - - - Min. Max. Min. Max. - Dispersion - -800 +800 -130 +130 ps/nm Pp - 2 - 1 dB - 1530 1565 1530 1565 - Optical output power Pout -3 +3 -2 +3 dBm Spectral width(-20dB) - - 0.5 - 0.5 nm SMSR - 30 - 30 - dB Ex 8.2 - 8.2 - dB - - -14 - -13 dBm -3 - -3 - dBm Optical path penalty S-64.2 S-64.3 - Transmitter Wavelength Extinction Ratio Receiver Sensitivity Overload 23 -12 note : Bit Rate 9953.28Mb/s,PRBS2 -1, BER<=10 ORDERING INFORMATION Transmitter Part number ITU-code Optical connector type MF-10KDS-T12-060 S-64.2 FC MF-10KDS-T12-061 S-64.2 SC MF-10KDS-T12-070 S-64.3 FC MF-10KDS-T12-071 S-64.3 SC Receiver Part number ITU-code Optical connector type MF-10KDS-R13-060 S-64.2 FC MF-10KDS-R13-061 S-64.2 SC MF-10KDS-R13-070 S-64.3 FC MF-10KDS-R13-071 S-64.3 SC MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER TRANSMITTER PIN ALLOCATION No. Symbol Description No. Symbol Description 1 -2.2V Supply voltage for cooler 2 -2.2V Supply voltage for cooler 3 GND Ground 4 NUC No user connection 5 LDMON Laser Bias Monitor 6 PDMON Laser Backface Monitor 7 DEG Laser Degradation Alarm 8 ORA Power Out of Range Alarm 9 LOT Laser Over Temperature Alarm 10 SDC Shut Down Command 11 GND Ground 12 GND Ground 13 GND Ground 14 GND Ground 15 +5V Supply voltage 16 +5V Supply voltage 17 +5V Supply voltage 18 +5V Supply voltage 19 GND Ground 20 GND Ground 21 GND Ground 22 GND Ground 23 -5.2V Supply voltage 24 -5.2V Supply voltage 25 -5.2V Supply voltage 26 -5.2V Supply voltage 27 GND Ground 28 GND Ground 29 GND Ground 30 GND Ground RECEIVER PIN ALLOCATION No. Symbol Description No. Symbol Description 1 GND Ground 2 GND Ground 3 GND Ground 4 LOS Loss of signal alarm 5 NUC No user connection 6 NUC No user connection 7 NUC No user connection 8 NUC No user connection 9 NUC No user connection 10 NUC No user connection 11 GND Ground 12 GND Ground 13 GND Ground 14 GND Ground 15 +5V Supply voltage 16 +5V Supply voltage 17 +5V Supply voltage 18 +5V Supply voltage 19 GND Ground 20 GND Ground 21 GND Ground 22 GND Ground 23 -5.2V Supply voltage 24 -5.2V Supply voltage 25 -5.2V Supply voltage 26 -5.2V Supply voltage 27 GND Ground 28 GND Ground 29 GND Ground 30 GND Ground MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER GENERAL OUTLINE DRAWING NOTE: TOLERANCES UNLESS NOTED +/-0.5 DIMENSIONS ARE IN MILLIMETERS Transmitter Receiver MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER BLOCK DIAGRAM VCC EA-LD Module VCC PD integrated device LD OPT. OUT Thermistor Cooler DRIVER IC DATAin A.T.C DATAin LOT Driver IC CLOCK CLOCK ORA A.P.C SDC DEG Transmitter PD-Preamp Module Clock recovery IC PD OPT. IN DATAout Preamp DATAout PLL CLKout CLKout Alarm LOS Receiver MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER NOTE NOTE1: Input interface Transmitter Data Data 50ohm 0V -0.9V DC Coupled Interface NOTE2: Shut down interface OFF H L ON Transmitter TTL comparator NOTE3: Laser Degradation Alarm / Power out of range Alarm / LD temperature out of range Alarm L a s e r D e g r a d a ti o n A l a r m ( DE G ) se t s wh e n th e b i a s cu r r e n t i s a t l e a s t 7 0 % h i g h e r th a n the maximum initial value allowed . Alarm active: TTL LOW P o we r o u t o f r a n g e A l a r m ( O R A ) , se t s wh e n th e o u tp u t o p t i ca l o u tp u t p o w e r i s 3 d B ( t yp . ) less than the initial optical output level. Alarm active: TTL LOW L a se r O ve r Te m p e r a tu r e A l a r m (L O T) , se t s wh e n t h e t e mp e r a t u r e o f L D i n c r e a s e o r decrease more than 15deg.C from the initial temperature. Alarm active: TTL LOW MITSUBISHI (OPTICAL DEVICES) MF-10KDS-T12-06x/07x MF-10KDS-R13-06x/07x SONET/SDH TRANSMITTER & RECIEVER NOTE4: LVPECL Output interface Receiver 100ohm Data / Data Clock / Clock 50ohm 50ohm note:DC Couple for Data AC Couple for Clock NOTE5: Data and Clock relationship Data Data Clock Clock Td Td < Td 20psec. Td < Rx Tx NOTE6: LOS of signal interface Receiver Optical signal OFF Signal detect activated ON deactivated H L Signal detect TTL 25psec.