AZ2800 30 AMP MINIATURE POWER RELAY FEATURES • • • • • • DPST-NO and DPDT configuration Meets 8 mm creepage, 4 kV dielectric Epoxy selead version available UL Class F (155°C) standard UL, CUR file E44211 VDE certificate 40023442 CONTACTS Arrangement DPST (2 Form A) DPDT (2 Form C) Ratings Resistive load: Max. switched power: 560 W or 8310 VA Max. switched current: 30 A (N.O.), 3 A (N.C.) Max. switched voltage: 30 VDC* or 600 VAC * Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. Rated Load UL Normally open contacts (N.O.) 30 A at 277 VAC, General Use, 100k cycles [1][2] 10 A at 600VAC, General Use, 6k cycles [1] 1 HP at 120 VAC, 100k cycles [1][2] 2.5 HP at 240 VAC, 100k cycles [1][2] 8 FLA / 26 LRA at 600 VAC, 30k cycles [1] Normally open contacts (N.O.), DC coils only 25.3 FLA / 110 LRA at 240 VAC, 30k cycles [1][2] Normally closed contacts (N.C.) 3 A at 277 VAC, General Use, 100k cycles [1][2] 2 A at 480 VAC, General Use, 6k cycles [1] 1 A at 600 VAC, General Use, 6k cycles [1] 3 FLA / 3 LRA at 240 VAC, 30k cycles [1] 2 FLA / 2 LRA at 480 VAC, 30k cycles [1] 1 FLA / 1 LRA at 600 VAC, 30k cycles [1] VDE GENERAL DATA Life Expectancy Mechanical Electrical Minimum operations 5 x 107 1 x 105 at 30 A 277 VAC Res. (N.O.) Operate Time 15 ms typical 25 ms maximum with bounce Release Time 10 ms typical 25 ms maximum with bounce (with no coil suppression) Dielectric Strength 1500 Vrms contact to contact (at sea level for 1 min.) 4000 Vrms contact to coil 2000 Vrms between contact sets Insulation Resistance 109 ohms minimum at 500 VDC Dropout DC: Greater than 10% of nominal coil voltage AC: Greater than 20% of nominal coil voltage Ambient Temperature Operating At nominal coil voltage DC: -40°C (-40°F) to 85°C (185°F) AC: -40°C (-40°F) to 65°C (149°F) Vibration 0.062" (1.5 mm) DA at 10–55 Hz Shock Operational, 10 g for 11 ms 1/2 sine pulse (no contact opening > 100usec) Non-destructive, 100 g for 11 ms 1/2 sine pulse Enclosure P.B.T. polyester Normally open contacts (N.O.) 20 A at 250 VAC, resistive, 50k cycles [2] Normally closed contacts (N.C.) 3 A at 250 VAC, resistive, 50k cycles [2] Material Silver cadmium [1], silver tin oxide [2], Resistance < 50 milliohms initially (at 6 V, 1 A, voltage drop method) COIL Power At Pickup Voltage (typical) 925 mW, DC coil 2.6 VA, AC coil Terminals Quick connect tabs Note: Allow suitable slack on leads when wiring, and do not subject the terminals to excessive force Max. Solvent Temp. 80°C (176°F) Max. Immersion Time 30 seconds Weight 86 grams Packing unit in pcs 20 per plastic tray / 100 per carton box Max. Continuous Dissipation 5 W at 20°C (68°F) ambient, DC coil 7 VA at 20°C (68°F) ambient, AC coil Temperature Rise 48°C (86°F) at nominal coil voltage, DC coil 68°C (122°F) at nominal coil voltage, AC coil 1. All values at 20°C (68°F). Max. 155°C (311°F) 3. Specifications subject to change without notice. Temperature NOTES 2. Relay may pull in with less than “Must Operate” value. ZETTLER electronics GmbH Junkersstr. 3, D-82178 Puchheim, Germany - A ZETTLER GROUP Company phone: +49 89 800 97-0 [email protected] fax: +49 89 800 97-200 www.ZETTLERelectronics.com This product specification to be used only together with the application notes which can be downloaded from http://www.ZETTLERelectronics.com/pdfs/relais/ApplicationNotes.pdf 2014-09-08 AZ2800 RELAY ORDERING DATA COIL SPECIFICATIONS – DC Coil Nominal Coil VDC 6 Must Operate VDC 4.5 Max. Continuous VDC 10.5 Nominal Current mA ± 10% 272.0 ORDER NUMBER* Coil Resistance Ohm ± 10% 22 AZ2800–2C–6D 12 9.0 20.7 140.0 86 AZ2800–2C–12D 24 18.0 41.8 68.5 350 AZ2800–2C–24D 48 36.0 83.4 34.5 1,390 AZ2800–2C–48D 110 82.5 190.5 15.2 7,255 AZ2800–2C–110D COIL SPECIFICATIONS – AC Coil Nominal Coil VAC 12 50 Hz Nominal Current mA ± 10% 340.0 ORDER NUMBER* Must Operate VAC 9.6 Max. Continuous VAC 15.6 Coil Resistance Ohm ± 10% 8 24 19.2 31.2 166.0 45 120 96.0 156.0 33.3 1,125 AZ2800–2C–120A5 220 176.0 286.0 18.2 3,800 AZ2800–2C–220A5 240 192.0 312.0 16.7 4,500 AZ2800–2C–240A5 277 221.6 360.1 14.4 6,000 AZ2800–2C–277A5 AZ2800–2C–12A5 AZ2800–2C–24A5 * Subsitute “2A” in place of “2C” to indicate 2 Form A contacts. “2A” or “2C” denote silver cadmium contacts. Add suffix “E” to “2A” or “2C” for silver tin oxide contacts. Add suffix “E” at the end of order number for sealed version. Add suffix “K” for 0.187” x 0.020” [4.8 mm x 0.5 mm] coil terminals. MECHANICAL DATA MECHANICAL DATA .31 [8.0] .58 [14.8] WIRING DIAGRAMS 2 Form C .18 [4.6] .63 [16.0] 1.36 [34.5] 1.00 [25.4] .15 [3.8] 0 6 x .250 [6.3] 1.62 [41.1] 2.35 [59.7] 8 x .032 [.8] 2 4 3 6 8 7 1 1.04 [26.4] 2 Form A 2 x DIM "A" DIM. "A" = .250 x .032 [6.3 x 0.8] - STANDARD DIM. "A" = .187 x .020 [4.8 x 0.5] - SUFFIX "K" 8 x .45 [11.4] .13 [3.3] 0 2 4 6 8 1 Viewed toward terminals 2.69 [68.4] Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Junkersstr. 3, D-82178 Puchheim, Germany - A ZETTLER GROUP Company phone: +49 89 800 97-0 [email protected] fax: +49 89 800 97-200 www.ZETTLERelectronics.com This product specification to be used only together with the application notes which can be downloaded from http://www.ZETTLERelectronics.com/pdfs/relais/ApplicationNotes.pdf 2014-09-08