E3 - SERIES SPECIFICATIONS AND ORDERING INFORMATION 1 1/2" DIAMETER 1.5 AMPS @ 28 VDC The E3 Series was designed to provide spring return action in an open frame construction. Standard construction is available with 2 or 3 positions, 30° index, and solder lug terminals. SPECIFICATIONS ELECTRICAL MECHANICAL Current and Voltage Rating: Make and break resistive load 1.5 amps @ 28 VDC; 0.5 amp @ 115 VAC. Current Carrying Capacity: 9 amps. Dielectric Strength: 1,500 VAC between current carrying parts and ground. Contact Resistance: Average initial 3.5 milliohms. Insulation Resistance: In excess of 750,000 megohms. Materials and Finishes: All parts utilize non-corrosive materials as standard. Clips and Rotors: Brass with silver plate as standard. Insulation: Glass epoxy. Index: Coil spring. Index Life: 25,000 cycles minimum. Index Torque: Switches have lowest practical torque consistent with crisp detenting and smooth, reliable operation. Index Angles: Positive 30° standard. Index Stops: Fixed stops standard. Stop Strength: 25 in. lbs. minimum. Hardware: Mounting nut and lockwasher are shipped assembled. STANDARD PART NUMBER SPRING RETURN SWITCHES - 30° INDEXING - FIXED STOPS - SOLDER LUG TERMINALS ACTIVE POLES/ NO. OF POLES POSITIONS SECTION SECTIONS 04 06 06 02 03 03 4 3 3 1 2 2 SHORTING NONSHORTING E3G0402S-1 E3G0603S-2 E3G0603S-3 E3G0402N-1 E3G0603N-2 E3G0603N-3 DESCRIPTION .......... .......... .......... SPRING RETURN FROM CLOCKWISE. SPRING RETURN BOTH SIDES TO CENTER. SPRING RETURN CLOCKWISE TO CENTER, POSITIVE INDEX COUNTER CLOCKWISE OF CENTER. E DIMENSIONS STANDARD CONSTRUCTION E3G - GLASS EPOXY CONSTRUCTION 1.187 1.187 • ELECTRONIC PRODUCTS UNIT OF ELECTRO SWITCH CORP. 2010 Yonkers Road Raleigh, NC 27604 Telephone: (888) ROTARYS or (919) 833-0707 Fax: (800) 909-9171 or (919) 833-8016 39