ODLC-65 65W Constant Current Mode LED Driver F M ■ Features Constant Current mode output Flicker free design Plastic housing with class II design Built-in active PFC function No load power consumption<0.5W(Blank-Type) IP67 rating for indoor or outdoor installations Function options: 2 in 1 dimming (dim-to-off); M SELV IP67 series Type HL ■ Applications LED panel lighting LED flood lighting Indoor LED lighting Auxiliary DC output 3 years warranty ■ Description ODLC-65 series is a 65W LED AC/DC driver featuring the constant current mode output with flicker free design. ODLC-65 operates from 180~295VAC and offers models with different rated current ranging between 700mA and 1750mA. Thanks to the efficiency up to 88%, with the fanless design, the entire series is able to operate for -20℃~+85℃ case temperature under free convection. The design of plastic housing and IP67 ingress protection level allows this series to fit indoor wet applications. ODLC-65 is equipped with various function options, such as dimming methodologies, so as to provide the optimal design flexibility for lighting system. ■ Model Encoding ODLC- 65 A - 1050 Rated output current(700/1050/1400/1750mA) Function options Output wattage Series name Type Blank A Function 2 in 1 dimming (0~10VDC and 10V PWM) 2 in 1 dimming and Auxiliary DC output Note In Stock In Stock File Name:ODLC-65-SPEC 2016-10-26 ODLC-65 65W Constant Current Mode LED Driver series SPECIFICATION ODLC-65 -700 ODLC-65 -1050 ODLC-65 -1400 ODLC-65 -1750 RATED CURRENT 700mA 1050mA 1400mA 1750mA RATED POWER 65.1W 65.1W 64.4W 63W CONSTANT CURRENT REGION Note.2 69 ~ 93V 46 ~ 62V 34 ~ 46V 27 ~ 36V OPEN CIRCUIT VOLTAGE(max.) 118V 82V 60V 53V MODEL OUTPUT CURRENT RIPPLE 5% max. @rated current CURRENT TOLERANCE ±7.0% SETUP TIME 500ms / 230VAC Note.4 AUXILIARY DC OUTPUT Note.5 Nominal 12V(deviation 11.4~12.6)@50mA for A-Type only VOLTAGE RANGE INPUT Note.3 180 ~ 295VAC 254 ~ 417VDC (Please refer to "STATIC CHARACTERISTIC" section) FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) PF>0.95/230VAC, PF>0.9/277VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) TOTAL HARMONIC DISTORTION THD< 20%(@load≧75%/230VAC,277VAC) (Please refer to “TOTAL HARMONIC DISTORTION” section) EFFICIENCY (Typ.) 88% AC CURRENT 0.4A/230VAC INRUSH CURRENT (Typ.) COLD START 30A(twidth=100μs measured at 50% Ipeak) at 230VAC; Per NEMA 410 86% 85% 85% 0.3A/277VAC MAX. No. of PSUs on 16A 32 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230VAC CIRCUIT BREAKER LEAKAGE CURRENT <0.75mA / 277VAC NO LOAD POWER CONSUMPTION <0.5W for Blank-Type, <1.2W for A-Type PROTECTION SHORT CIRCUIT Hiccup mode, re-power on to recovery WORKING TEMP. Tcase=-20 ~ +85℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section) MAX. CASE TEMP. Tcase=+85℃ WORKING HUMIDITY 20 ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 45℃) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS UL8750;CSA C22.2 NO.250.13-12; ENEC EN61347-1 & EN61347-2-13 independent, EN62384, GB19510.1,GB19510.14; IP67 approved WITHSTAND VOLTAGE I/P-O/P:3.75KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH EMC Compliance to EN55015, EN61000-3-2 Class C (≧75% load) ; EN61000-3-3,GB17743,GB17625.1 EMC EMISSION EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level( surge immunity:Line-Line:1KV ) MTBF 380.7Khrs min. OTHERS DIMENSION PACKING NOTE MIL-HDBK-217F (25℃) 121*77*28.5mm(L*W*H) 0.43Kg; 24pcs/ 11.3Kg/ 0.74CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25℃ of ambient temperature. 2. Please refer to "DRIVING METHODS OF LED MODULE". 3. De-rating may be needed under low input voltages. Please refer to STATIC CHARACTERISTIC sections for details. 4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time or set up failure 5. There is no design of short circuit protection for the Auxiliary DC output; this function can not be used when dimming input terminals(DIM+,DIM-) are short circuit or when it is no load or short circuit at output(Vo+,Vo-). 6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. File Name:ODLC-65-SPEC 2016-10-26 ODLC-65 65W Constant Current Mode LED Driver fosc : 70KHz Block Diagram AUX+(for A-Type) AUX-(for A-Type) RECTIFIERS I/P series EMI FILTER & RECTIFIERS RECTIFIERS & FILTER POWER SWITCHING O.L.P. PWM&PFC CONTROL CURRENT LIMIT Vo+ VoDIM+ DIM- DETECTION CIRCUIT DRIVING METHODS OF LED MODULE ※ This series works in constant current mode to directly drive the LEDs. In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. 100 Vo(%) Constant Current area Should there be any compatibility issues, please contact MEAN WELL. 75 (min.) Hiccup Protection 50 100 Io(%) Typical output current normalized by rated current (%) File Name:ODLC-65-SPEC 2016-10-26 ODLC-65 65W Constant Current Mode LED Driver series DIMMING OPERATION ※ 2 in 1 dimming function AUX-(Green) AUX+(Yellow) Vo-(Black) Vo+(Red) DIM-(Gray) DIM+(Purple) ACN(Blue) ACL(Brown) Output constant current level can be adjusted by applying one of the two methodologies between DIM+ and DIM-: 0 ~ 10VDC, or 10V PWM signal. Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers. ◎ Applying additive 0 ~ 10VDC 100% 90% Vo- + + - - DIM+ + Output current (%) 80% Vo+ 70% 60% 50% 40% 30% Additive Voltage - 20% DIM- 10% “DO NOT connect "DIM- to Vo-" 0% 0V 1V 2V 3V 4V 5V 6V 7V 8V 9V 10V Dimming input: Additive voltage ◎ Applying additive 10V PWM signal (frequency range 300Hz ~ 3KHz): 100% 90% Vo- + + - - DIM+ Additive PWM signal Output current (%) 80% Vo+ 70% 60% 50% 40% 30% 20% DIM“DO NOT connect "DIM- to Vo-" 10% 0% 0% 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% Duty cycle of additive 10V PWM signal dimming input Note : 1. Min. dimming level is about 8% and the output current is not defined when 0%< I out<8%. 2. The output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle. File Name:ODLC-65-SPEC 2016-10-26 ODLC-65 65W Constant Current Mode LED Driver series 100 100 80 80 60 60 LOAD (%) LOAD (%) OUTPUT LOAD vs TEMPERATURE 40 40 20 20 -20 -10 0 5 10 20 30 45 -20 (HORIZONTAL) -10 0 15 AMBIENT TEMPERATURE,Ta (℃) 30 45 75 85 (HORIZONTAL) Tcase (℃) STATIC CHARACTERISTIC POWER FACTOR (PF) CHARACTERISTIC ※ Tcase at 75℃ 100 1 90 0.95 80 0.9 PF LOAD (%) 70 60 0.85 50 0.8 40 0.75 180 200 230 260 277V 230V 0.7 295 50% 60% 70% 80% 90% LOAD ※De-rating is needed under low input voltage. TOTAL HARMONIC DISTORTION (THD) EFFICIENCY vs LOAD ODLC-65 series possess superior working efficiency that up to 88% can be reached in field applications. ※ 700mA Model, Tcase at 75℃ ※ 700mA Model, Tcase at 75℃ 94 18 16 12 10 277VAC 8 230VAC 6 EFFICIENCY(%) 90 14 THD 100% (65W) INPUT VOLTAGE (V) 86 277V 82 230V 78 4 74 2 0 50% 60% 70% LOAD 80% 90% 100% 70 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% LOAD File Name:ODLC-65-SPEC 2016-10-26 ODLC-65 65W Constant Current Mode LED Driver MECHANICAL SPECIFICATION Case No.ODL-65A series Unit:mm 121 3.5 ※ Blank-Type: 3.5 200±10 77 30 tc 150±10 30 ACN(Blue) ACL(Brown) 3.5 Vo-(Black) Vo+(Red) DIM-(Gray) DIM+(Purple) 200±10 2*ψ4.5 3.5 28.5 ※ tc : Max. Case Temperature. DC wire No. Assignment(DC OUT) ACN(Blue) SVT 18AWG Vo-(Black) UL1007 18AWG ACL(Brown) SVT 18AWG Vo+(Red) UL1007 18AWG DIM-(Gray) UL1007 22AWG 2.5 AC wire No. Assignment(AC IN) DIM+(Purple) UL1007 22AWG ※ A-Type: 3.5 121 3.5 200±10 150±10 77 30 tc 150±10 30 ACN(Blue) ACL(Brown) 3.5 AUX-(Green) AUX+(Yellow) Vo-(Black) Vo+(Red) DIM-(Gray) DIM+(Purple) 200±10 2*ψ4.5 3.5 AC wire No. Assignment(AC IN) ACN(Blue) SVT 18AWG ACL(Brown) SVT 18AWG DC wire No. Assignment(DC OUT) 2.5 28.5 ※ tc : Max. Case Temperature. AUX-(Green) UL1007 22AWG AUX+(Yellow) UL1007 22AWG Vo-(Black) UL1007 18AWG Vo+(Red) UL1007 18AWG DIM-(Gray) UL1007 22AWG DIM+(Purple) UL1007 22AWG INSTALLATION MANUAL Please refer to : http://www.meanwell.com/manual.html File Name:ODLC-65-SPEC 2016-10-26