Material: 1 RJ45 Jack Housing: ABS, UL94V-0 - with optional color 2. Jack Bracket Set: PBT, UL94V-0 3. RJ45 Jack Contact Material & Finished - Phosphor Bronze - Contact area: Min. 3MM 50 Micro-inch Gold plated over Nickel plated 4. IDC Housing: PC, 94V-2 5. IDC Terminal material & finished: - Phosphor Bronze w/Min. 50 Micro-inch Tin plated - Suitable for 23-24AWG stranded & solid wire 6. IDC CAP: PC, UL94V-2 Electrical: • Wiring: T568A & T568B • Insertion Force: 900 GM for 8 contacts • Retention Strength: 7.7Kg between Jack & Plug • Operating Temperature: -10°C ~ +60°C • Durability: Jack: 750 cycles Plug-Jack mating and unmating test, Insertion cycles at 20 cycles/ minute max. Contact resistance test per 100 cycles. • The Cat.6 transmission performance is in compliance with the ANSI/TIA/EIA 568 B.2-1 standard ITEM NO. RoHS Compliant TITLE DN-93601-U/WH Cat.6 Unshielded Keystone Jack, 90° Tool Free Type, White ASSMANN Electronics, Inc. 1840 W. Drake Drive, Suite 101 • Tempe, AZ 85283 Toll Free: 1-877-277-6266 • Email: [email protected] THIS DRAWING IS UNPUBLISHED ©Copyright 2009 by Assmann Electronic Components All International Rights Reserved 1 3 30mm ASSMANN Electronics, Inc. 2 2 1 6 3 5 4 7 8 Unshielded type Tool Colored Sticker A BB AA BB Shielded type 5 5 White/Green Green White/Orange Blue White/Blue Orange White/Brown Brown White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown T568B Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 Cable tie Cable tie Insert the cable tie to tight up the cable jacket. Then complete the installation. Fully Shielded Half Shielded Complete the installation. Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 T568A DN-93501-U/X and DN-93601-U/X Keystone Jack Installing Instruction the wires. 4 the wires. press down to close plastic lid to connect Plug the easy tool into upper hole, then Tool press down to close plastic lid to connect Plug the easy tool into upper hole, then 4 Strip approximately 30mm of the cable jacket, and separate to 4 pair each. Attn: Suitable for 23~24 AWG Solid Wire Follow the direction on the plastic lid color- coding to position T568A or T568B wiring, separate a little space on proper position and insert the wire pair by pair into each slot. 3 Follow the direction on the plastic lid color- coding to position T568A or T568B wiring, separate a little space on proper position and insert the wire pair by pair into each slot.