1.0X0.5mm SMD CHIP LED LAMP APHS1005SYCK Features SUPER BRIGHT YELLOW Description 1.0mmX0.5mm SMT LED, 0.5mm THICKNESS. The Super Bright Yellow source color devices are LOW POWER CONSUMPTION. made with DH InGaAlP on GaAs substrate Light W IDE VIEW ING ANGLE. Emitting Diode. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE: 2000PCS / REEL . RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAB0814 REV NO: V.7 DATE: MAR/14/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001482 Selection Guide Part No. Dice APHS1005SYCK Iv (mcd) @ 20 mA Lens Type SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 18 120 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Yellow λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 590 nm IF=20mA Super Bright Yellow 590 nm IF=20mA Spectral Line Half-width Super Bright Yellow 20 nm IF=20mA C Capacitance Super Bright Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 175 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB0814 REV NO: V.7 DATE: MAR/14/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001482 Super Bright Yellow APHS1005SYCK SPEC NO: DSAB0814 REV NO: V.7 DATE: MAR/14/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001482 APHS1005SYCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB0814 REV NO: V.7 DATE: MAR/14/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001482