EGP20A THRU EGP20K Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 Features • • • • 2.0 Amp Glass Passivated High Efficient Rectifiers 50 to 800 Volts Superfast recovery time for high efficiency Glass passivated cavity-free junction, Plastic case Low forward voltage, high current capability Low leakage current Maximum Ratings • • • DO-15 Operating Temperature: -55OC to +150 OC Storage Temperature: -55OC to +150 OC Typical Thermal Resistance: 40OC/W Junction to Ambient Part Number EGP20A EGP20B EGP20D EGP20F EGP20G EGP20J EGP20K Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 300V 400V 600V 800V Maximum RMS Voltage Maximum DC Blocking Voltage D 35V 70V 140V 210V 280V 420V 560V 50V 100V 200V 300V 400V 600V 800V A Cathode Mark B Electrical Characteristics @ 25OC Unless Otherwise Specified Maximum Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage EGP20A-20D EGP20F-20G EGP20J-20K Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time EGP20A-20D EGP20F-20K Typical Junction Capacitance EGP20A-20D EGP20F-20K IF(AV) 2.0 A IFSM 75A VF 0.95V 1.25V 1.70V IR Trr CJ 5.0uA 100uA 50nS 75nS 70pF 45pF D O TA = 55 C 8.3ms, half sine C IFM = 2.0A; TA = 25OC TA = 125OC DIMENSIONS DIM A B C D INCHES MIN .230 .104 .026 1.000 IF=0.5A, IR=1.0A, Irr=0.25A Measured at 1.0MHz, VR=4.0V www.cnelectr.com MAX .300 .140 .034 --- MM MIN 5.80 2.60 .70 25.40 MAX 7.60 3.60 .90 --- NOTE EGP20A thru EGP20K Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 150OC 2 Amps 2.0 1 .6 25OC Amps 1.5 .4 1.0 .2 .5 Resistive or Inductive Load 0.375”(9.5mm) Lead Length .1 .06 00 .04 EGP20A –EGP20D EGP20F-EGP20K .4 .6 .8 1.0 1.4 1.2 75 100 125 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 200 TJ =25OC 160 140 120 pF 100 60 40 20 EGP20A –EGP20D EGP20F-EGP20K 0 .1 .2 .4 1 2 4 150 175 O C Average Forward Rectified Current - Amperes versus Ambient Temperature - OC .02 .01 50 10 20 40 100 200 Volts Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com 400 1000 EGP20A thru EGP20K Figure 4 Peak Forward Surge Current 90 75 60 45 Amps 30 15 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr .com