Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 1A FAST RECOVERY PLASTIC RECTIFIER FR10-005-LFR THRU FR10-10-LFR FEATURES z FAST RECOVERY TIMES z UL 94V0 FLAME RETARDANT EPOXY MOLDING COMPOUND z DIFFUSED JUNCTION z LOW COST z HIGH SURGE CURRENT CAPABILITY z ROHS 1.0(25.4) MIN .034(0.9) .028(0.7) .205(5.2) .166(4.2) .107(2.7) .080(2.0) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO41, DIMENSIONS IN INCHES AND (MILLIMETERS) z LEADS: SOLDERABLE PER MIL-STD-202, METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 0.34 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% FR10 FR10 FR10 FR10 FR10 FR10 FR10 UNITS RATINGS SYMBOL -005-LFR -01-LFR -02-LFR -04-LFR -06-LFR -08-LFR -10-LFR MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 200 400 600 800 1000 V MAXIMUM RMS VOLTAGE VRMS 35 70 140 280 420 560 700 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 200 400 600 800 1000 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 1.0 A 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 30 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 15 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 50 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) FR10 FR10 FR10 FR10 FR10 FR10 FR10 UNITS CHARACTERISTICS SYMBOL -005-LFR -01-LFR -02-LFR -04-LFR -06-LFR -08-LFR -10-LFR MAXIMUM FORWARD VOLTAGE AT IO DC VF 1.3 V MAXIMUM REVERSE CURRENT AT 25℃ IR 5 MAXIMUM REVERSE CURRENT AT100℃ IR 50 MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR 150 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20x20x1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FR10-005-LFR THRU FR10-10-LFR μA μA 250 Page: 1 500 nS RATINGS AND CHARACTERISTIC CURVE FR10-005-LFR THRU FR10-10-LFR FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 10Ω NO INDUCTIVE Trr +0.5A (-) D.U.T. PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) -0.25A 1Ω NON INDUCTIVE (-) 0 OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50OHMS 1cm SET TIME BASE FOR 10/20 ns/cm RESISTIVE OR INDUCTIVE LOAD 0.375”(9.5mm) LEAD LENGTH 1.0 Fig. 5-MAXIMUM FORWARD SURGE NUMBER OF CYCLES 0.8 I(pk) 0.6 I(AV) PEAK FORWARD SURGE CURRENT AMPERES Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM CURRENT DERATING CURVE π = CAPACITIVE LOAD 0.4 I(pk) 0.2 I(AV) 0 0 5 = 10 20 20 40 60 80 100 120 140 160 180 200 TA-AMBIENT TEMPERATURE (OC) FIG. 3-TYPICAL JUNCTION CAPACITANCE 20 30 TA=75oC 8.3ms SINGLE HALF SINE-WAVE JEDEC METHOD 20 10 1.0 CYCLE 0 1 10 NUMBER OF CYCLES AT 60 HZ FIG. 6-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS f = 1 MHz Vsig = 50 mVp-p 1 1 10 100 REVERSE VOLTAGE, VOLTS INSTANTANEOUS REVERSE CURRENT, MICRO AMPERES(uA) 100 10 FIG. 4-TYPICAL REVERSE CHARACTERISTICS 100 10 o TJ=100 C 1 INSTANTANEOUS FORWARD CURRENT, IF(A) CAPACITANCE, pF Tj=25oC 20 10 3 1 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE .3 .1 .03 .01 0.4 0.1 0.6 0.8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, (V) TJ=25oC .01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE FR10-005-LFR THRU FR10-10-LFR Page: 2