16 Pin DIP 5 Tap TTL Compatible Active Delay Lines TAP DELAYS ±5% or ±2 nS† TOTAL DELAYS ±5% or ±2 nS† 5, 10, 15, 20 6, 12, 18, 24 7, 14, 21, 28 8, 16, 24, 32 9, 18, 27, 36 10, 20, 30, 40 12, 24, 36, 48 15, 30, 45, 60 20, 40, 60, 80 25, 50, 75, 100 30, 60, 90, 120 35, 70, 105, 140 40, 80, 120, 160 45, 90, 135, 180 50, 100, 150, 200 60, 120, 180, 240 70, 140, 210, 280 †Whichever is greater. 25 30 35 40 45 50 60 75 100 125 150 175 200 225 250 300 350 PART NUMBER TAP DELAYS ±5% or ±2 nS† EPA054-25 EPA054-30 EPA054-35 EPA054-40 EPA054-45 EPA054-50 EPA054-60 EPA054-75 EPA054-100 EPA054-125 EPA054-150 EPA054-175 EPA054-200 EPA054-225 EPA054-250 EPA054-300 EPA054-350 80, 160, 240, 320 84, 168, 252, 336 88, 176, 264, 352 90, 180, 270, 360 94, 188, 282, 376 100, 200, 300, 400 110, 220, 330, 440 120, 240, 360, 480 130, 260, 390, 520 140, 280, 420, 560 150, 300, 450, 600 160, 320, 480, 640 170, 340, 510, 680 180, 360, 540, 720 190, 380, 570, 760 200, 400, 600, 800 400 420 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 Schematic High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current Recommended Operating Conditions Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature V V V µA mA mA mA 0.5 -1.2 50 1.0 -2 -100 16 75 mA 75 mA 4 nS 5 nS 20 TTL LOAD 10 TTL LOAD Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 -55 40 +125 PCA EPA054-25 Date Code White Dot Pin#1 .300 12 6 10 OUTPUT .280 Max. .200 .88 Max. .020 .040 Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts .020 Typ. .010 Typ. .150 Typ. .365 Max. QAF-CSO1 Rev. B 8/25/94 DSA054 Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 4 Package Dimensions Min Input Pulse Test Conditions @ 25° C VCC 14 8 GROUND .250 Max. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage VCC INPUT 1 *These two values are inter-dependent. EIN PW TRI PRR EPA054-400 EPA054-420 EPA054-440 EPA054-450 EPA054-470 EPA054-500 EPA054-550 EPA054-600 EPA054-650 EPA054-700 EPA054-750 EPA054-800 EPA054-850 EPA054-900 EPA054-950 EPA054-1000 Min Max Unit V CC = min. V IL= max. I OH = max 2.7 V CC = min. VIH = min. I OL= max V CC = min. II = IIK V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V IIL Low-Level Input Current V CC = max. VIN = 0.5V IOS Short Circuit Output Current V CC = max. VOUT = 0. -40 (One output at a time) ICCH High-Level Supply Current V CC = max. VIN = OPEN ICCL Low-Level Supply Current V CC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output V CC = max. VOH = 2.7V NL Fanout Low-Level Output V CC = max. VOL = 0.5V VCC VIH VIL IIK IOH IOL PW* d* TA PART NUMBER Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH TOTAL DELAYS ±5% or ±2 nS† ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791