GOOD-ARK GBJ8B Glass passivated single-phase bridge rectifier Datasheet

GBJ8A thru GBJ8M
Glass Passivated Single-Phase Bridge Rectifiers
Reverse Voltage 50 to 1000 Volts Forward Current 8.0 Amperes
Features
Glass passivated junction
Ideal for printed circuit board
Reliable low cost construction
Plastic material has Underwriters Laboratory Flammability
Classification 94V-0
Surge overload rating to 170 amperes peak
High case dielectric strength of 2500VRMS
Mechanical Data
Case: GBJ(5S)
Epoxy meets UL-94V-0 Flammability rating
Terminals: Leads solderable per MILSTD-750 Method 2026
High temperature soldering guaranteed:
260oC/10 seconds, 0.375 (9.5mm) lead length,
5lbs.(2.3kg) tension
Weight: 0.24 ounce, 6.8 grams
Mounting torque: 8.17 in. lbs. max.
Typical Applications
General purpose use in ac-to-dc bridge full wave rectification for
Switching Power Supply, Home Appliances, Office Equipment,
Industrial Automation applications
Package outline dimensions in millimeters
Maximum Ratings and Electrical Characteristics
Rating at 25oC ambient temperature unless otherwise specified.
Parameter
Symbols
GBJ8A
GBJ8B
GBJ8D
GBJ8G
GBJ8J
GBJ8K
GBJ8M
Units
Maximum repetitive peak reverse voltage
VRRM
50
100
200
Maximum RMS voltage
VRMS
35
70
140
400
600
800
1000
Volts
280
420
560
700
Volts
50
100
200
400
600
800
1000
Volts
Maximum DC blocking voltage
V DC
Maximum average forward rectified output current (See Fig.2)
IF(AV)
8.0
Amps
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method)
IFSM
180
Amps
I2t
120
A 2 se c
VF
1.0
Volt
Rating for fusing (t<8.3ms)
Maximum instantaneous forward voltage drop per leg at 4.0A
TA=25oC
TA=125oC
IR
5.0
250.0
Typical thermal resistance per leg (Note 2)
RθJC
1.6
Dielectric strength (Therminals to case, AC 1 minute)
VISO
2500
TJ, TSTG
-55 to +150
Maximum DC reverse current
at rated DC blocking voltage per leg
Operating junction and storage temperature range
Notes:
1. Unit case mounted on AL plate heatsink
2. Unit mounted on P.C.B.with 4”x0.06" (100x100x1.6mm) copper pads and 0.375" (9.5mm) lead length
3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
466
uA
o
C/W
Volts
o
C
RATINGS AND CHARACTERISTIC CURVES
(TA = 25oC unless otherwise noted)
467
Similar pages